Synthesis and thermotropic studies of a novel series of nematogenic liquid crystals 2-(6-alkoxynaphthalen-2-yl)-5-cyanopyridines

A novel series of highly birefringent liquid crystalline compounds, 2-(6-alkoxynaphthalen-2-yl)-5-cyanopyridines (nO-NpPyCN, n?=?2–8) that have potential as commercially useful, were synthesised using a short two-step reaction with overall yields between 55% and 85%. Spectral analyses were in accordance with the expected structures. Their thermotropic behaviours were investigated by polarising optical microscopy and differential scanning calorimetry. It was found that the desymmetrised core results in a nematic phase with a broad mesophase range.     

Application of a new focused microwave technology with species-specific isotope dilution analysis for the quantitative extraction of organometallic contaminants in solid environmental matrices

A new self-tuning single-mode-focused microwave technology has been evaluated in this work to perform the quantitative routine extraction of organometallic species from solid matrices of environmental interest. Species-specific isotope dilution analysis has been employed to better investigate the real influence of the microwave-assisted extractions on the final results. The advantages of such methodology in comparison with other established microwave units for the routine speciation analysis of organomercury and organotin compounds are discussed (such as the capability of using disposable glass vials, a self-tuning mode to provide an accurate control of the temperature and pressure inside of the vials, and the possibility of performing automated sequence of extractions with low sample size). The results obtained in this work demonstrated that such technology provides a fast and reliable quantitative extraction of the organometallic species in a wide range of extraction conditions even when the multi-elemental (Sn and Hg) species-specific determination is carried out.     

The Photodecomposition of 1,l-Dichloro-2,2-bis(5′-chloro-2′-methoxyphenyl)ethylene (MPE), an Analogue of DDE

The solution-phase photodecomposition of l, l-dichloro-2,2-bis(5′-chloro-2′-methoxy-phenyl)ethylene (MPE) has been studied at an excitation wavelength of 313 nm in the presence of O₂ as well as in vacuum-degassed solutions. Only two non-volatile compounds are produced: 2,5-dichloro-3-(5′-chloro-2′-methoxyphenyl)benzofuran (BFD) and a minor product which was not identified. The BFD represents approximately 90% of the total non-volatiles. The volatile products were identified as CH₃Cl, CH₄ and HC1, with CH₃C1 being approximately 99.9 % of the total volatiles. Photolyses were carried out in C₆H₁₂ and CCI₄ solvents, the same products being observed in both solvents. Variation of MPE concentration has little or no effect on the relative quantum yield of decomposition. The photodecomposition of MPE does not follow the same pathway as the photodecomposition of DDE.     

Automated analysis of geosmin, 2-methyl-isoborneol, 2-isopropyl-3-methoxypyrazine, 2-isobutyl-3-methoxypyrazine and 2,4,6-trichloroanisole in water by SPME-GC-ITDMS/MS

This paper describes a method of determining the following compounds in water characterised by complex matrices (raw waters and drinking waters): geosmin, 2-methylisoborneol (2-MIB), 2-isobutyl-3-methoxypyrazine (IBM), 2-isopropyl-3-methoxypyrazine (IPM) and 2,4,6-trichloroanisole (TCA). The method is carried out using headspace solid-phase microextraction (HS-SPME) combined with gas chromatography (GC) and ion trap mass spectrometry (ITMS). Several parameters of extraction and desorption were optimised through the use of a Combi PAL autosampler to automate various tasks (temperature extraction, extraction time, stir speed). Quantities of NaCl and the liquid volume/total volume ratio were also optimised. Double fragmentation (tandem MS/MS) was optimised on the target compounds. The method resulted in good linearity obtained for concentrations of 1 to 100?ng?L^?1 and provided detection limits of approximately below 1?ng?L^?1. Good precision (1–8%) was obtained. This method was successfully applied to the analysis of earthy and musty odours in municipal raw source waters with high concentrations of natural organic matter and in the corresponding treated waters. This is the first time MS/MS has been used to analyse odorous compounds in waters destined for human consumption. In addition, the method as developed is simple to use and lends itself to easy interpretation of chromatograms.     

Synthesis and characterisation of a silicon oxide film solid-phase extraction system for lead traces determination: an all the way green analytical method

In this work, an all the way green analytical procedure based on a silicon oxide film-solid phase extraction system is proposed for lead traces determination. From the synthesis of a solid phase extraction (SPE) system and throughout the metal preconcentration and determination only aqueous media were employed. Characterisation of the film was carried out by Scanning Electron Microscopy and Attenuated Total Reflectance-Fourier Transform Infrared Spectroscopy. Preconcentration conditions, prior to Pb(II) Electrothermal Atomic Absorption Spectrometry (ETAAS) determination, such as adsorption and desorption time, pH and temperature, were optimised. Langmuir, Freundlich and Dubinin-Radushkevich isotherm models were analysed along with the evaluation of adsorption energy and standard free energy (ΔG ⁰). The greatest adsorption was obtained with incubation at pH 7 and 37°C. By using a small volume of 0.5?mol?L^?1 HNO₃ (0.5?mL) lead was desorbed from the silicon oxide film after 2?h incubation, generating low amount of waste. The films showed better adjustment for the Langmuir model (R^{2 ?}=?0.989). The detection limit (3.29σ) for Pb(II) was 0.228?µg?L^?1. The developed procedure is 10-fold more sensitive in comparison to direct ETAAS determination. Recovery values from soft tap-water and soft well-water were above 95%. When hard water was analysed, Pb(II) adsorption was found to be interfered by Mg²⁺ and Ca²⁺. After five preconcentration cycles relative recovery was found not to decay below 90%, indicating that the silicon oxide film could be used for multiple lead determinations.     

Simple Device for Isolation of Organic Compounds from Water

Abstract

A simple device for isolation of organic compounds from aqueous samples has been designed and its operating parameters tested during bioth periodic and continuous operation using isolation of organochlorine compounds as an example.

A stream of an aqueous sample is pumped at elevated temperature by a piston pump to an unit for expransion of the liquid phase surface, where the liquid is sprayed on the walls of the unit and flows down freely.

Organochlorine compounds passing to the gaseous phase are purged with a stream of purified air, oxidied and the chlorides formed are determined coulometrically. The designed device, due to its simplicity, can be built and employed in each averagely equipped laboratory.     

FDU-15-Pt composites with different Pt loading and their electrocatalytic reduction to ultratrace nitroaromatic compounds

FDU-15 is a hexagonal mesoporous material with nanometer-sized, highly ordered arrays and large special surface area. In this work, FDU-15-Pt with 2.0%, 5.0% and 8.0% Pt loading were synthesised and used for electrochemical detection of trace nitroaromatic compounds (NACs). The FDU-15-Pt samples were characterised by CO Chemisorption, transmission electron microscopy (TEM) and X-ray diffraction (XRD). It has been demonstrated that FDU-15-Pt with 2.0% Pt loading has the smallest Pt particle size of 2.9?nm, highest Pt metal dispersion of 37.7% and largest Pt metal surface area of 21.36?m^2?g^?1. The FDU-15-Pt/PDDA modified electrode were assembled by electrostatic adsorption of Poly (diallyldimethylammonium chloride) (PDDA) and FDU-15-Pt. The 2.0% FDU-15-Pt modified sensor showed higher selectivity for NACs than those of 5.0% and 8.0% FDU-15-Pt, which were verified by electrochemical experiments. A linear response over TNT concentration ranging from 8.8?×?10^?9?M to 1.2?×?10^?5 M was exhibited with a low detection limit of 2.9?×?10^?9?M (S/N?=?3). Moreover, the proposed 2.0% FDU-15-Pt/PDDA modified sensor has been applied to the detection of NACs in spiked environmental water samples and shows promise for fast and accurate determination of trace NACs in real samples.     

Determination of lead (II) ion by highly selective and sensitive lead (II) membrane electrode based on 2-(((E)-2-((E)-1-(2-hydroxyphenyl) methyliden)hydrazono)metyl)phenol

A PVC (poly vinyl chloride) membrane electrode for lead ion based on 2-(((E)-2-((E)-1-(2-hydroxyphenyl)methyliden)hydrazono)metyl)phenol (HMHMP) as a membrane carrier was prepared. This electrode exhibited linear response with Nernstian slope of 29.2?±?0.2?mV per decade within the concentration range of 2.0?×?10^?7–1.0?×?10^?1?M lead ion. The limit of detection, as determined from the intersection of the extrapolated linear segments of the calibration plot, was 8.0?×?10^?8 M. The electrode exhibited high selectivity for Pb (II). The response time of the electrode was about 5–10?s for different concentrations. The electrode is suitable for use in aqueous solutions in a pH range of 5.0–7.5. It was used as an indicator electrode in a titration of Pb (II) with chromate at constant pH. This electrode was used for the determination of lead in ore samples, and the results were in agreement with those obtained with an atomic absorption spectroscopy (AAS) method. Also lead selective electrode was used for monitoring of lead in spiked samples of the Zayanderud River and waste water by the potentiometry technique.     

Chemical characterisation of a new estuarine pollutant (2,4-Dichloro-6-Nitrophenol) and assessment of the acute toxicity of its quinoid form for Artemia salina

It is known that the compound 2,4-dichloro-6-nitrophenol (2,4DC6NP) is formed upon nitration of 2,4-dichlorophenol, which in turn is a transformation intermediate of the herbicide dichlorprop. However, the chemical and spectroscopic characteristics of 2,4DC6NP, as well as its toxicity, are poorly known. This work shows that 2,4DC6NP behaves as a diprotic acid in aqueous solutions, with pK_a values of 3.0?±?0.9 and 4.9?±?0.5. At pH?<?3, 2,4DC6NP would undergo protonation. The absorption spectra suggest that anionic 2,4DC6NP, which prevails at pH?>?5 would have an ortho-quinoid structure that is responsible for the absorption peak centred at 428?nm. Considering that 2,4DC6NP has been detected in the brackish lagoons of the Rhône delta (southern France), where its levels are comparable to those of the parent herbicide, it is necessary to examine the possible effects of 2,4DC6NP on the species living in that environment. For this reason, the acute toxicity of the anionic form of 2,4DC6NP was assessed for the brine shrimp Artemia salina, a zooplankton species that lives both in brackish and in saline aquatic environments. The toxicity test yielded a LC₂₀ value of 8?±?2?mg?L^?1 and a LC₅₀ value of 18.7?±?0.8?mg?L^?1. Such values are safely higher than the maximum detected concentration of 2,4DC6NP in the Rhône delta lagoons. Further studies should be concentrated on the long-term effects of 2,4DC6NP, and in particular on its potential genotoxicity.