Voltammetric determination of L-dopa using an electrode modified with trinuclear ruthenium ammine complex (Ru-red) supported on Y-type zeolite

The L-dopa is the immediate precursor of the neurotransmitter dopamine. Unlike dopamine, L-dopa easily enters the central nervous system and is used in the treatment of Parkinson’s disease. A sensitive and selective method is presented for the voltammetric determination of L-dopa in pharmaceutical formulations using a carbon paste electrode modified with trinuclear ruthenium ammine complex [(NH₃)₅Ru^IIIORu^IV(NH₃)₄ORu^III(NH₃)₅]⁶⁺ (Ru-red) incorporated in NaY zeolite. The parameters which influence on the electrode response (paste composition, potential scan rate, pH and interference) were also investigated. The optimum conditions were found to an electrode composition (m/m) of 25% zeolite containing 6.7% Ru, 50% graphite and 25% mineral oil in acetate buffer at pH 4.8. Voltammetric peak currents showed a linear response for L-dopa concentration in the range between 1.2×10⁻⁴ and 1.0×10⁻² mol l⁻¹ (r=0.9988) with a detection limit of 8.5×10⁻⁵ mol l⁻¹. The variation coefficient for a 1.0×10⁻³ mol l⁻¹ L-dopa (n=10) was 5.5%. The results obtained for L-dopa in pharmaceutical formulations (tablet) was in agreement with compared official method. In conclusion, this study has illustrated that the proposed electrode modified with Ru-red incorporated zeolite is suitable valuable for selective measurements of L-dopa.     

Adsorptive Voltammetry of Polyelectrolyte Complex Between 11‐Ferrocenyltrimethylundecylammonium and Polyanions at Carbon Paste Electrode

For polyelectrolyte complex between cationic surfactant and polyanion, the adsorptive voltammetry at carbon paste electrode using an electroactive cationic surfactant was examined. The adsorption state of the cationic surfactant in the complexes at CPE was estimated from the half‐height width of the oxidation waves. The half‐height width for poly(styrene sulfonate) was independent of the molecular weight, and was same as that for poly(vinyl sulfate). The half‐height width for heparin was broad and different from that of the vinyl polyanions. According to the analysis by Frumkin isotherm, the interaction between cationic surfactants was attractive in heparin complex at CPE, however, in the vinyl polyanion complexes at CPE the interaction was non‐cooperative as that predicted with the Langmuir isotherm. In spite of the same adsorption state, the concentration dependency of the peak current for poly(styrene sulfonate) was quite different from that for poly(vinyl sulfate). The concentration dependence indicated the reactive property of each polyanion on the association with the cationic surfactant in aqueous solution.     

Simultaneous detection of cadmium, copper, and lead using a carbon paste electrode modified with carbamoylphosphonic acid self-assembled monolayer on mesoporous silica (SAMMS)

A new sensor was developed for simultaneous detection of cadmium (Cd²⁺), copper (Cu²⁺), and lead (Pb²⁺), based on the voltammetric response at a carbon paste electrode modified with carbamoylphosphonic acid (acetamide phosphonic acid) self-assembled monolayer (SAM) on mesoporous silica (Ac-Phos SAMMS). The adsorptive stripping voltammetry (AdSV) technique involves preconcentration of the metal ions onto Ac-Phos SAMMS under an open circuit, then electrolysis of the preconcentrated species, followed by a square wave potential sweep towards positive values. Factors affecting the preconcentration process were investigated. The voltammetric responses increased linearly with the preconcentration time from 1 to 30 min or with metal ion concentrations ranging from 10 to 200 ppb. The responses also evolved in the same fashion as adsorption isotherm in the pH range of 2-6. The metal detection limits were 10 ppb after 2 min preconcentration and improved to 0.5 ppb after 20 min preconcentration.     

Degree of hydration in cement paste and C<Subscript>3</Subscript>A-sodium carbonate-water systems

This research provides a fundamental understanding of the early stage hydration of Portland cement paste, tricalcium aluminate (C₃A) paste at water to cement ratio of 0.5 and C₃A suspension at water to cement ratio of 5.0 modified by 2 or 4 mass% of sodium carbonate. A high conversion of unreacted clinker minerals to gel-like hydration products in the cement-Na₂CO₃ pastes takes place rapidly between 1^st to 24^th h. Contrary the Ca(OH)₂ formation within the same time interval is retarded in the excess of CO₃²⁻ ions due to intensive rise and growth of CaCO₃ crystals in hydrated cement. Later, the conversion of clinker minerals to the hydrate phase is reduced and higher contents of calcite and vaterite relative to that of Ca(OH)₂ in comparison with those found in the Portland cement paste are observed. As a consequence a decrease in strength and an increase in porosity between hardened Portland cement paste without sodium carbonate and those modified by Na₂CO₃ are observed. C₃A hydrates very quickly with sodium carbonate between 1^st and 24^th h forming hydration products rich in bound water and characterized also by complex salts of (x)C₃A·(y)CO₂·(zH₂O type, whereas C₃A-H₂O system offers C₃AH₆ as the main hydration product. Higher content of the formed calcium aluminate hydrates in C₃A-Na₂CO₃-H₂O system also contributes to early strength increase of Portland cement paste.     

纳米金/β-环糊精复合修饰碳糊电极测定亚硝酸盐

本文研究了亚硝酸盐(NO_2~-)在纳米金和β-环糊精复合修饰碳糊电极(AuNPs-β-CD/CPE)上的电化学行为。实验结果表明,与裸CPE相比,AuNPs-β-CD/CPE对NO_2~-的电化学氧化有显著的促进作用,其氧化峰电流显著增加。同时用循环伏安法(CV)、计时电流法(CA)测定了NO_2~-在AuNPs-β-CD/CPE上的电极反应动力学参数,用线性扫描伏安法(LSV)法测得NO_2~-氧化峰电流与其浓度在6.0×10-6~8.0×10-3 mol·L-1范围内呈良好的线性关系,检出限(S/N=3)为5.7×10-7 mol·L-1。将该传感器应用于水样的检测,相对标准偏差在0.15%~1.40%之间,回收率达99.3%~104.0%,检测结果符合定量测定要求。     

Carbon Paste Composite with Co3O4 as a New Electrochemical Sensor for the Detection of Allura Red by Reduction

The detection of Allura red (AR) by electrochemical reduction using a different electrode from the conventional mercury electrode is presented. A carbon paste with cobalt (II, III) oxide composite electrode (CoO_x/CPE) is reported for the first time for the detection of AR. Moreover, others dyes such as tartrazine (TZ), sunset yellow (SY), amaranth (AM), Ponceaut 4‐R (P‐4R), and Sudan (SD) as well as pharmaceutical agents such as paracetamol (PMC) that are present in samples that contained AR did not show a reduced signal between 0.0 and ?0.3 V, which is the potential range where AR reduction was observed. The surface electroactivity was studied using cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and scanning electron microscopy (SEM). The presence of CoO_X increased the cathodic peak current for AR by more than 50 % and 65 % via CV and square wave voltammetry (SWV), respectively, compared with an unmodified carbon paste electrode. Under the optimal parameters, (pH=3.0, accumulation time (t_ACC)=60 s and accumulation potential (E_ACC)=0.50 V), the detection limit for AR was 0.05 μmol L^?1. The new sensor was sensitive and stable for the detection of AR. Moreover, it was easily manufactured and very convenient for food samples such as soft and isotonic drinks as well as chili sauce.     

Voltammetric Study and Rapid Quantification of Resorcinol in Hair Dye and Biological Samples Using Ultrasensitive Maghemite/MWCNT Modified Carbon Paste Electrode

Increased concern over the risk resorcinol (RS) pose to ecology and humans, led to its position in European Union Category 1 list of endocrine disruptors. Legal measures restricted RS utilization and hence crucial to monitor its levels in the environment. Herein we report development of highly efficient and economically viable electrochemical sensor for quantitative determination of RS based on 77Maghemite/MultiWall Carbon Nanotube (M/MWCNT) modified carbon paste electrode. M/MWCNT was synthesized via strategic IR irradiation for the first time, a promising approach to overcome other complicated chemical routes. Powder X‐ray diffraction (PXRD), Transmission electron microscopy (TEM), Field emission scanning electron microscopy (FESEM) and Energy dispersive X‐ray (EDX) were used for characterization. Using Differential Pulse Voltammetry (DPV), we report the lowest detection limit at 0.02 μM. The potential application of the sensor was accomplished as a result of excellent recoveries made from real samples fortified with RS. Results indicated the proficiency of the sensor reliable for rapid, onsite monitoring of RS water contamination and in biological matrices.     

Copper nanoclusters conjugated silica nanoparticles modified on carbon paste as an electrochemical sensor for the determination of dopamine

An electrochemical sensor based on modification of carbon paste electrode by glutathione‐capped copper nanoclusters silica nanoparticles (CuNCs/SiO₂NPs) composite for determination of dopamine in the presence of ascorbic acid was presented. Transmission electron microscopy, scanning electron microscopy, energy dispersive X‐Ray analysis, X‐ray photoelectron spectroscopy, Fourier‐transform infrared spectroscopy, X‐ray diffraction and electrochemical impedance spectroscopy were used for characterization of the developed electrode. The electrochemical behavior of dopamine on CuNCs/SiO₂NPs/carbon paste electrode was investigated by cyclic voltammetry and differential pulse voltammetry. Dopamine was determined in the range of 10.0 – 900.0 μM, and the limit of detection was obtained as 0.43 μM. The electrochemical behaviors of the coexisting electroactive species, which often cause interference with the determination of dopamine, were investigated. The results show that the developed electrode does not show any interference with respect to coexisting species, even in the presence of ascorbic acid. The developed electrochemical sensor was further employed for the determination of dopamine in human blood plasma, with a good recovery.     

Molecular Dynamics Simulation and Density Functional Theory Study of Chemisorption of Propranolol Optical Isomers on a Uracil‐modified Carbon Paste Electrode

To reveal the nature of the interaction of the optical isomers of propranolol with the surface of carbon paste electrodes modified by uracil, we performed a combined computational and experimental study. Our study comprised the different modes of complexation between propranolol and uracil molecules covering the carbon paste electrode within two approaches: molecular dynamics simulation (MD ) and quantum mechanics (QM) modeling. A graphene layer was used as a model of the carbon paste electrode. The computations showed that uracil modification of the carbon paste electrode surface enhanced the selectivity toward the D‐isomer of propranolol as compared to the unmodified case. These theoretical results agree with our voltammetric measurements.     

Determination of Trichloroacetic Acid (TCAA) Using CdO Nanoparticles Modified Carbon Paste Electrode

In this paper, the electrochemical behavior of a carbon paste electrode modified with CdO nanoparticles as a potential electrocatalyst for the reduction of trichloroacetic acid (TCAA) was investigated using cyclic voltammetry and double‐potential step chronoamperometry. The modified electrode showed a great enhancement in cathodic peak current with respect to reduction of TCAA in acidic aqueous solution. Using this increment, a quantitative method was developed for the determination of TCAA in aqueous solution. The detection limit and linear dynamic range of TCAA are 2.3×10^?6 M and 2.3×10^?4–3×10^?6 M, respectively.