二次阳极氧化方法制备有序多孔氧化铝膜

通过二次阳极氧化方法制备多孔氧化铝膜与一次阳极氧化方法制备多孔氧化铝膜孔排布规律性的对比 ,结果发现 ,二次阳极氧化方法制取的多孔氧化铝膜孔排布规律性明显好于一次阳极氧化法制取的多孔膜 .在几个微米范围内 ,孔呈理想的六角排布 .去除一次阳极氧化膜后 ,二次阳极氧化得以在更良好的表面进行 ,制取的氧化铝膜孔规律性和有序度更高 .有序区域的尺寸与晶粒内的亚晶大小有一定关系     

Temperature coefficient of NH chemical shifts of thioamides and amides in relation to structure

NH chemical shift temperature coefficients have been measured in a large series of N-substituted-3-piperidinethiopropionamides in which the NN distances are short but of varied length, as well as in a couple of the corresponding amides and in some simpler amides and thioamides. Geometries are calculated by means of ab initio DFT methods. The N-substituted-3-piperidinethiopropionamides show in most cases strong intramolecular N–HN hydrogen bonds according to IR spectra and ab initio calculations. For compounds with rather short NN distances the S=C–N–H moiety is non-planar. Dihedral angles as small as 160° are found. The NH chemical shift coefficients measured in non-polar solvents in all the N-substituted-3-piperidinethiopropionamides are more negative (−8 to −17 ppb/K) than in non-hydrogen bonded thioamides. For the latter in non-polar solvents like CDCl₃ and toluene the temperature coefficients are as small as −1 to −4 ppb/K. The large negative effects can be related not only to the non-planarity of the thioamide group in a way that the more pronounced the non-planarity the more negative the temperature coefficients, but also to strong hydrogen bonding and the fact that the acceptor is a nitrogen. For similar amides with non-planar amide groups and nitrogen acceptor large negative temperature coefficients are likewise seen. In polar solvents like DMF the effects in simple thioamides are uniform and close to −6 ppb/K, whereas in the more complex compound like 4p(t) the temperature coefficient is close to 0. An essential feature of measuring temperature coefficients of compounds without strong intramolecular hydrogen bonds in non-polar solvents and at low temperatures is to keep the concentration low enough to avoid dimerisation.     

Experimental investigation and theoretical modeling of liquid entrainment in a horizontal tee with a vertical-up branch

This article describes a comprehensive literature review of liquid entrainment in horizontal pipes with vertical-up branches. Deficiencies in the available data and correlations were identified. The Air–water Test Loop for Advanced Thermal–hydraulic Studies (ATLATS) was constructed and entrainment onset and steady-state data were collected for a wide range of flow conditions. Using new insights gained from experimental testing, the authors developed a model for predicting the onset of entrainment and steady-state entrainment rate. Previously published correlations, along with the new model, are compared against all available data. The new model shows very good agreement with the onset data, but is not very good at predicting branch quality at high liquid flow rates.     

Phase modulation in dipolar-coupled A2 spin systems: effect of maximum state mixing in H NMR in vivo

Coupling constants of nuclear spin systems can be determined from phase modulation of multiplet resonances. Strongly coupled systems such as citrate in prostatic tissue exhibit a more complex modulation than AX connectivities, because of substantial mixing of quantum states. An extreme limit is the coupling of n isochronous spins (A_n system). It is observable only for directly connected spins like the methylene protons of creatine and phosphocreatine which experience residual dipolar coupling in intact muscle tissue in vivo. We will demonstrate that phase modulation of this “pseudo-strong” system is quite simple compared to those of AB systems. Theory predicts that the spin-echo experiment yields conditions as in the case of weak interactions, in particular, the phase modulation depends linearly on the line splitting and the echo time.     

Radiation effect on the 400-nm-thermoluminescence emission of a potassium-rich feldspar

The UV-blue thermoluminescence (TL) emission of exsolved and twinned potassium feldspars is potentially valid to be employed in the field of dating and retrospective dosimetry. This paper reports about the following results: (i) The dose dependence of the 400 nm TL intensity of a K-rich feldspar exhibits an excellent linearity in the range of 50 mGy–8 Gy. (ii) The stability of the TL signal after 6 months of storage, shows an initial rapid decay (ca. 45%) maintaining the stability from 40 days onwards which indicates that the electron population decreases asymptotically by the X-axis and the involved electrons are located in deeper traps at room temperature. The fading process can be fitted to a first-order decay equation of the sort y=y₀+A exp(−x/t). (iii) The tests of thermal stability at different temperatures confirm a continuous trap distribution with progressive changes in the glow curve shape, intensity and temperature position of the maximum peak. According to this behaviour some physical parameters are defined.     

Viscosity,particle size distribution,and structural investigation of tetramethyloxysilane/2‐hydroxyethyl methacrylate sols during the sol–gel process with acid and base catalysts

The tetramethoxysilane (TMOS)/2‐hydroxylethyl methacrylate (HEMA) hybrid gels were synthesized with acid and base catalysts, via the in situ polymerization of HEMA, with and without the cosolvent methanol. With methanol in the TMOS/HEMA sol, the enhanced esterification and depolymerization reactions of the silanols resulted in a slower growth of silica particles. The silica particles that were synthesized with an acid catalyst were less than 40 nm. The thermal resistance of the poly(2‐hydroxyethyl methacrylate) (PHEMA) chains was enhanced by the addition of colloidal silica. The Fourier transform infrared characterizations and the exothermal peaks on the differential scanning calorimetry traces of these hybrid gels indicated chemical hybridization occurring as a result of condensation of the colloid silica and PHEMA at higher temperatures. Hence, the residual weight content of the hybrid gel after its synthesis with the base catalyst was even higher than the content of TMOS in the hybrid sol. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 3476–3486, 2004     

Addition–fragmentation chain transfer: Molecular weight distributions and retardation in the system methyl methacrylate/methyl α‐(bromomethyl)acrylate

A detailed investigation of addition–fragmentation chain transfer (AFCT) in the free‐radical polymerization of methyl methacrylate (MMA) in the presence of methyl α‐(bromomethyl)acrylate (MBMA) was carried out to elucidate mechanistic details with efficient macromonomer synthesis as an underlying goal. Advanced modeling techniques were used in connection with the experimental work. Curve fitting of simulated and experimental molecular weight distributions with respect to the rate coefficient for addition of propagating radicals to MBMA (k_add) over 60–120 °C resulted in E_add = 21.7 kJ mol^?1 and A_add = 2.18 × 10⁶ M^?1 s^?1 and a very weak temperature dependence of the chain‐transfer constant (E_add ≈ E_p). The rate coefficient for fragmentation of adduct radicals at 60 °C was estimated as k_f ≈ 39 s^?1 on the basis of experimental data of the MMA conversion and the concentration of 2‐carbomethoxy‐2‐propenyl end groups. The approach developed is generic and can be applied to any AFCT system in which copolymerization does not occur and in which the resulting unsaturated end groups do not undergo further reactions. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2640–2650, 2004     

闪光照相条件下相对质量吸收系数的测量

 介绍了闪光照相中X光传播规律的等效单能模型。针对闪光照相出光重复性差、能谱测量困难的特点提出了相对质量吸收系数的概念。阐述了闪光照相中相对质量吸收系数的测量原理和方法。在闪光照相实验设备上采用整条D～L曲线对钨材料相对质量吸收系数进行了测量，得到的实验结果为1.23，与数值模拟结果1.26符合较好。     

一种新颖的用于光腔模式及光束传输模拟的特征向量法

根据有限元法单元划分的思想，提出了一种新颖的模拟光腔模式及光束传输的特征向量法. 该方法的关键之处在于基于衍射积分理论构造了一种新的光束传输矩阵，通过求解特征矩阵方程可一次性得到谐振腔的一系列特征向量，每一列特征向量即代表了腔镜上光场的一个确定模式的振幅及相位分布. 并可采用该方法模拟光场传输到腔内或腔外任意地方的场分布. 该方法将传统方法中大量的迭代过程转化成为本征积分方程特征向量的求解过程，并与初值取值无关，且可一次性求得多个模式分布，从而可方便地分析谐振腔的模式鉴别能力. 特征向量法对圆形镜共焦 关键词： 谐振腔 特征向量法 模式分布     

用格林函数法计算量子点中的应变分布

自组装量子点材料作为一种新型的光电材料无论在理论和实际应用都成为当今物理学界的研 究热点.由GaAs包围的InAs小岛，由于较大的晶格失配（≈-0.067），应变效应在量子点 的 形成过程中起主导作用.大部分计算量子点结构应变分布的方法都是基于数值解法，需要大 量的计算工作.给出用格林函数法推导各种常见形状量子点应变分布的解析表达式详细过程，讨论了弹性各向异性和形状各向异性对量子点应变分布的影响程度.结果表明对于不 同形状量子点结构中主要部分的应变分布都是相似的，流体静压变部分的特征值随量子点形状的变化不 关键词： 自组装量子点 格林函数 应变分布