饱和水蒸汽与水的焓与熵参数的新关联式

饱和水蒸汽与水的焓与熵参数的新关联式李斯特，马润梅，吴冷（北京化工大学机械工程系北京１０００２９）关键词统计力学，剩余函数，焓与熵１引言本文根据统计力学与热力学剩余函数原理，结合本课题组曾已建立的饱和水蒸汽与水的新简明状态方程模型，经推导出一则适合于...     

1．5GHz锯材超导腔的研制

介绍铌材超导腔的研制进展，重点讨论了国产铌腔的材料改性，以及相应的超导腔性能的改进．叙述了１．５ＧＨｚ铌腔的腔形设计，分析了铌材的射频性能和机械性能，制定了铌腔制作与后处理的特定工艺．最后给出了１．５ＧＨｚ铌材超导腔的低温实验结果．     

Slow quenching for a one-dimensional kinetic Ising model: Residual energy and domain growth

A one-dimensional kinetic Ising model with Glauber dynamics subjected to a slow continuous quench to zero temperature is studied. For a rather general class of cooling schemes, described by a time-dependent temperatureT(t), the mean domain sizeL(t) is calculated along with the residual energye _res (r) as a function of the cooling rater. If the attempt frequency =₀ exp(–/kT), entering into the transition rates, is temperature dependent (i.e., the barrier is non-zero), the asymptotic growth ofL(t) is given byL()–L(t)~exp[–/kT(t)]. For this case the residual energy exhibits a power-law behaviore _res(r) ~r ^{/2(1 + )} forr small, where =4J/ andJ is the nearest neighbor coupling constant. For =0 and for certain cooling schemes the residual energy is zero andL(t)~t1/2, independent ofr.     

镧对含锡、锑残余元素的34CrNi3Mo钢热塑性的改善作用

采用Gleeble-1500热模拟机测定了不同含量的残余元素锡、锑及稀土镧对低氧、低硫的34CrNi3Mo钢热塑性的影响;采用SEM及EDS手段研究了稀土镧对不同锡、锑含量的钢断裂方式的影响及在其中形成夹杂物的情况。结果表明,用稀土金属可以改善低氧、低硫钢中残余元素对钢性能的危害;镧可以和钢中较低含量的锑作用生成镧锑金属间化合物,并且发现了少量的镧锡金属间化合物。     

Properties of ITO films prepared by reactive magnetron sputtering

Indium tin oxide (ITO) thin films were deposited by mid frequency pulsed dual magnetron sputtering using a metallic alloy target with 10 wt.% tin in an atmosphere of argon and oxygen. The aim of the work was to study the interdependence of structural, electrical and optical properties of ITO films deposited in the reactive and transition target mode, respectively. The deposition rate in the transition mode exceeds the deposition rate in the reactive mode by a factor of six, a maximum value of 100 nm·m min⁻¹ could be achieved. This corresponds to a static deposition rate of 200 nm min⁻¹. The lowest electrical resistivity of 1.1·10⁻³ Ω cm was measured at samples deposited in the high oxygen flow range in the transition mode. The samples show a good transparency in the visible range corresponding to extinction coefficients being below 10⁻². X-ray diffraction was used to characterise crystalline structure as well as film stress. ITO films prepared in the transition mode show a slightly preferred orientation in (211) direction, whereas films deposited in the reactive mode are strongly (222) oriented. Compared to undoped In₂O₃ all samples have an enlarged lattice. The lattice strain perpendicular to the surface is about 0.8% and 2.0% for films grown in the transition and the reactive mode, respectively. Deposition in the transition mode introduces a biaxial film stress in the range of −300 MPa, while stress in reactive mode samples is −1500 MPa.     

Solid sampling Fourier transform infrared determination of Mancozeb in pesticide formulations

A series of approaches have been assayed for FTIR determination of Mancozeb in several solid commercial fungicides using different calibration strategies. The simplest procedure was based on the use of the ratio between the absorbance of a characteristic band of Mancozeb and that of a KSCN internal standard measured in the FTIR spectra obtained from KBr pellets. It was employed the quotient between peak height absorbance values at 1525 cm⁻¹ for Mancozeb and 2070 cm⁻¹ for KSCN. In these conditions a precision as relative standard deviation (RSD) of 0.6% and a relative accuracy error of 0.8% (w/w) were found. For complex formulations, containing other compounds with characteristic absorption bands at different wavenumbers than Mancozeb, one of them was used as internal reference being employed the standard addition approach. In this case, the Mancozeb bands at 1525 cm⁻¹ or at 1289 cm⁻¹ were employed, being used the ferrocyanide band at 2075 cm⁻¹ as internal reference. RSD values between 0.7-1.4% and a relative accuracy error of 3% (w/w) were found. A third strategy was based on the use of partial least squares (PLS) calibration. A reference set was prepared mixing Mancozeb, Kaolin, Cymoxanil and KBr, being predicted the Mancozeb concentration in pesticide formulations by using the quotient between absorbance bands of Mancozeb and those of Cymoxanil. In these conditions a relative accuracy error of 0.6% (w/w) and a relative standard deviation of 1.3% were found.     

氰氟草酯及其代谢物在稻田水、土壤和稻株中的残留分析方法

研究并建立了氰氟草酯及其 4种代谢物在稻田水、土壤及稻株中的残留分析方法。在同一色谱分析条件下 ,同时检测 5种化合物 ,样品前处理过程简单 ,方法准确可靠 ,灵敏度和准确度达到了农药残留检测的要求。氰氟草酯及 4种代谢物在上述样品中的最低检知浓度在 0 .0 2～ 0 .0 0 4mg kg之间 ,方法的添加回收率(0 .0 1～ 5mg kg)在 80 .2 %～ 1 0 1 .2 %之间     

Zur direkten ma?analytischen Bestimmung von Carbamaten als sehr schwache S?uren

Zusammenfassung Eine direkte maßanalytische Methode zur Bestimmung diverser Carbamate wird beschrieben. Die potentiometrische Titration mit käuflicher Tetra-n-butylammoniumhydroxid-Lösung, verdünnt mit Propanol-(2), ist bequem durchzuführen, und die erhaltenen Titrationskurven gestatten eine korrekte Auswertung.

---

Direct volumetric determination of carbamates as very weak acids

Summary A volumetric procedure for the determination of some carbamates is described. The potentiometric titration with commercial tetra-n-butylammonium hydroxide solution diluted with propanol-(2) is convenient and the obtained titration curves permit a correct calculation.

     

Beer Digestions for Metal Determination by Atomic Spectrometry and Residual Organic Matter

Many standard and official sample digestion procedures for trace metal determination are carried out in open vessels on hot plates. A new procedure for the determination of trace metals by flame atomic absorption spectrometry or inductively coupled plasmaatomic emission spectrometry in beer samples was developed to be performed in closed reactors assisted by microwaves. The results are compared with the ones obtained by other procedures by means of the analysis of the variance. The differences between the procedures are attributed to residual organic matter. Voltammetry, absorption molecular spectrophotometry and high pressure liquid chromatography with a photodiode array detector are used to study the nature of these residues. Nitrobenzoic acids, phenolic acids and other organic compounds are often present after digestion. The results obtained are related to the precision in metal determination by atomic spectrometry. The need for elaboration of certified reference materials for trace metals in beer is suggested.     

环境水中甲基对硫磷、对硫磷和辛硫磷农药残留的SPE-HPLC分析

采用离线固相萃取 (SPE)富集 -高效液相色谱(HPLC)分离和紫外分光光度法检测 ,对环境水中甲基对硫磷、对硫磷和辛硫磷3种有机磷农药进行分析;固相萃取用C18 萃取柱 ,用甲醇洗脱 ,高效液相色谱分离以Shim_PackCLCODS柱(150mm×4.6mmid,5μm)为分离柱 ,流动相为甲醇 -水(体积比70∶30) ,紫外检测波长为280nm;该法稳定可靠 ,回收率高