对地观测平台恒星敏感器离焦成像折中设计分析

从对地观测平台角秒量级姿态确定需求出发,在构建星敏感器惯性系成像模型的基础上指出,恒星在成像面上的定位误差是星敏感器姿态确定误差的主要来源。同时,结合理想光学系统离焦模型,分析了星敏感器主要性能指标间的量化关系,并给出了成像面定位误差最低限。仿真结果表明,从优化系统性能考虑,成像模糊区直径为2~3个像元的配置是利用星敏感器焦平面的“轻微离焦”来实现亚像元定位的最佳方案,定位误差可达0.2个像元,能够满足星敏感器惯性姿态确定精度4″~5″的要求。理论分析和数值仿真结果可为后续星敏感器指标的提出及仪器设计提供技术参考。     

螺栓松动边界下纤维增强复合薄板的振动测试方法

提出了基于预埋压力传感器的量化测试方法,研究了螺栓松动边界对纤维增强复合薄板振动特性的影响。首先,自主设计并开发了带有预埋压力传感器的螺栓松动边界下复合薄板的振动测试系统,并详细介绍了系统各个部件的组成和功能;然后,归纳出一套合理、规范的松动边界下复合薄板的振动测试流程,并对HF10碳纤维/树脂复合薄板进行了实际测试。结果表明:随着螺栓松动程度的不断增加,复合薄板的固有频率逐渐降低,模态振型的节线位置也发生了不同程度的变化,但其阻尼结果呈现先增大后减小的趋势;而共振和非共振响应呈现先减小后增大的趋势。     

自由活塞斯特林发动机活塞位移测量

自由活塞斯特林发动机活塞往复振动位移对研究发动机特性具有重要意义,然而该类发动机活塞位于高压封闭腔体内且结构较为紧凑,其活塞往复振动位移难于直接进行测量。加速度传感器具有尺寸小、安装方便和工作稳定等特点,提出了采用加速度传感器测量活塞位移的方法。根据加速度传感器测量位移的原理,建立了一套加速度传感器测量自由活塞斯特林发动机活塞位移的标定试验系统,以位移传感器为基准测试并分析了不同活塞振幅和不同振动频率下加速度传感器测量位移的误差大小。实验结果表明,在活塞振幅小于8 mm,振动频率大于20 Hz条件下,加速度传感器测量位移的误差小于5%。因此加速度传感器可以用于测量自由活塞斯特林发动机的活塞往复运动位移。最后成功把加速度传感器测量的自由活塞斯特林发动机活塞振动位移用于发动机循环指示功的实验研究。     

Novel facile detection of persistent organic pollutants using highly sensitive gas sensor

Persistent organic pollutants (POPs) are greatly noxious chemicals in environment, and they can cumulate in organisms and transfer between different species. Therefore, it is significant to detect POPs for both environmental evaluation and further treatment. However, developing facile approach for the detection of POPs still remains a challenge so far. In this paper, we report an innovative method for facile detection of POPs using gas sensor for the first time. Porous SnO₂ nanostructures with a special tri-walled structure prepared via hydrothermal route and annealing process, were employed as gas-sensing materials. Through gas measurements, it was revealed that the as-fabricated gas sensor exhibited highly sensitive performance towards target POPs, including methoxychlor, mirex, p,p′-DDT, and aldrin. Moreover, we found that target POPs were distinguishable by extracting characteristics in kinetic curves of gas adsorption-desorption. As the presented detecting approach is facile without the requirements of complex operations, expensive and bulky instruments, it is expected that it would be developed as a promising method for the detection of POPs, and thereby showing its significance for environmental monitoring.     

Multi‐responses Methodology Applied in the Electroanalytical Determination of Hair Dye by Using Printed Carbon Electrode Modified with Graphene

This paper describes a rapid and sensitive method for determination of the hair dye Basic Blue 41 in wastewater samples using screen‐printed carbon electrodes modified with graphene (SPCE/Gr). The method is based on the reversible reduction of azo groups of the dye at potential of ?0.23 V/?0.26 V, where both the anodic and cathodic currents increased 1,300 % when compared to screen‐printed carbon (SPCE) and glassy carbon electrodes (GCE). The optimization of a square wave voltammetric method was performed by means of 2³ factorial design, Doehlert matrix and multi‐response assays, and the best parameters were: frequency (54.8 Hz), step potential (6 mV), pulse amplitude (43.7 mV) and pH 4.5. The analytical curve was constructed from 3.00×10^?8 to 2.01×10^?6 mol L^?1, with detection and quantification limits of 5.00×10^?9 and 1.70×10^?8 mol L^?1, respectively. The repeatability of the method evaluated for 10 consecutive measurements at concentrations of 1.70×10^?7 mol L^?1 and 1.70×10^?6 mol L^?1, showed relative standard deviation of 3.56 and 0.57 %, respectively. The sensor based in SPCE/Gr was successfully applied in wastewater samples collected from a drinking water treatment plant and validated by comparison with HPLC‐DAD method with good accuracy.     

光纤传感器和压电作动片对薄板振动控制的分析

利用双模模态域光纤传感器的模间干涉感知薄板结构中应变的变化、获得薄板结构振动变化状况，进一步利用压电体作为动元件，减小振幅，实现振动的主动控制，采用振型叠加法和直接积分相结合的方法，从理论上论证薄板分别受到正弦波激振力，脉冲激振力和方波激振力时的振动主动控制，并由脉冲激振下的响应得到控制前后的幅频特性曲线和相频特性曲线．。     

跳马项目的三维实时动态测量系统

为跳马项目研究的电测系统中引入数字信号处理的传递函数及频谱分析的方法,采集和处理了因人体冲击三维力对信号的耦合干扰造成的十分复杂的响应信号,具有较高的动态测试精度.可以获得跳马动作的全部运动生物力学参数.现已用于中国国家体操队进行计算机辅助训炼.     

基于光纤智能夹层传感结构的应力测量研究

制作了一种模块化的光纤传感夹层,对夹层内的光纤传感器的应力特性进行了实验研究。分析了应变对传感系数的影响,对埋入到光纤智能夹层中的两种光纤传感器的输出特性进行了比较。实验结果表明:光纤Bragg光栅传感器的波长漂移与应变之间具有理想的线性关系,但应变灵敏度由1.2pm/με降至1.15pm/με;由于制作工艺的局限,对于非本征F-P光纤传感器,当应变达到350με后,应变与载荷具有较好的线性响应。与非本征F-P光纤传感器相比,光纤Bragg光栅传感器是光纤智能夹层首选的应变传感器。将埋入了Bragg光栅传感器的智能夹层粘贴于某型飞机的翼-身连接构件内部进行监测,实验结果为光纤智能夹层应用于复合材料结构的应变监测提供了参考。     

CoFeSiB非晶丝弱磁场测量仪的研制

设计了以Co基非晶丝为敏感元件的传感器探头,多谐振荡励磁电路,信号处理电路,单片机显示电路,且对该磁场测量仪进行了标定。     

航天光学遥感器在轨调制传递函数神经网络评价方法

通过对航天光学遥感器在轨调制传递函数模型和遥感图像的分析,找出遥感图像中与调制传递函数有关的特征信息,采用神经网络为工具,完成利用遥感器传输下来的任意一幅地面景物图像进行调制传递函数的评价。首先模拟出包含不同调制传递函数等级的遥感图像,组成训练样本集,再从图像中分别提取出直接与调制传递函数有关的特征参量和与景物结构有关的特征参量,作为神经网络的输入,网络通过对训练样本集中模拟出的大量调制传递函数已知的遥感图像训练后,当再次输入一幅调制传递函数未知的遥感图像时,便能够正确估计出其调制传递函数值。这种方法不需要在地面铺设靶标或预先获得调制传递函数已知的同一地面景物的航空图像作为参考,只需获得任意一幅地面景物图像即可完成对遥感器调制传递函数的评价。实验结果表明,当不考虑噪声对调制传递函数的影响时,对调制传递函数的评价误差约为6%,而在考虑噪声时,评价误差约为9%。