Polycrystalline silicon films prepared by metal-induced crystallisation using pre- and post-deposited aluminium on amorphous silicon

We report on the successful fabrication of polycrystalline silicon films by aluminium-induced crystallisation (AIC) of Radio frequency (rf) plasma-enhanced chemical vapour deposited (PECVD) a-Si films. The effects of annealing at different temperatures (300 and 400°C), below the eutectic temperature of the Si–Al binary system, on the crystallisation process have been studied. This work emphasises the important role of the position of the Al layer with respect to the Si layer on the crystallisation process. The properties of the crystallised films were characterised using X-ray diffraction, Raman spectroscopy, ellipsometry, field-emission scanning electron microscopy (FESEM) and atomic force microscopy (AFM). With an increase in the annealing temperature, it was found that the degree of crystallisation of annealed a-Si/Al and Al/a-Si films increased. The results showed that the arrangement where the Al was on top of the a-Si had a more prominent effect on crystallisation enhancement than when Al was below the a-Si. The interfacial layer between the Al and a-Si film is crucial because it influences the layer-exchange process during annealing. The oxide layer formed between the Al and the a-Si layers greatly retards the crystallisation process in the case of the Al/Si arrangement. Our investigations suggest that polycrystalline Si films formed by AIC can be used as a seed layer in solar cell fabrication.     

(Ni0.81Fe0.19)1-xCrx作为种子层对NiFe/FeMn交换偏置的影响

采用一种新的种子层材料:(Ni081Fe019)1-xCrx,通过改变种子层中Cr原子的含量,使得在其上生长的NiFeFeMn双层膜的织构和晶粒尺寸产生极大的差异,系统研究了NiFeFeMn双层膜中FeMn晶粒尺寸和织构对交换偏置的影响.实验结果表明,在FeMn的γ相(111)织构较好的前提下,交换偏置场的大小与织构的差异没有关系;FeMn的晶粒尺寸对交换偏置场有很大影响,较小的反铁磁层晶粒对交换偏置场有利,过大的反铁磁层晶粒不利于交换偏置场.将(Ni081Fe019)05Cr05与传统的种子层材料Ta进 关键词： 交换偏置 晶粒尺寸 织构 种子层     

不同组分InxGa1-xAs(0≤x≤0.3)覆盖层对自组织InAs量子点的影响

研究了不同In组分的In_xGa_1-xAs(0≤x≤0.3)覆盖层对自组织InAs量子点的结构及发光特性的影响.透射电子显微镜和原子力显微镜表明,InAs量子点在InGaAs做盖层时所受应力较GaAs盖层时有所减小,并且x＝0.3时,InGaAs在InAs量子点上继续成岛.随x值的增大,量子点的光荧光峰红移,但随温度的变化发光峰峰位变化不明显.理论分析表明InAs量子点所受应力及其均匀性的变化分别是导致上述现象的主要原因. 关键词： 量子点 盖层 应力 红移     

太赫兹波在一维反铁磁/电介质准周期光子晶体的传输性质

本文利用传递矩阵方法研究了电磁波倾斜入射时,一维反铁磁/电介质准周期光子晶体的透射性质.反铁磁层和电介质层按Fibonacci数列排列构成准周期光子晶体.通过数值模拟发现光子禁带中有透射峰出现, 而且随着准周期光子晶体级数的增加透射峰的数目也在增加.此外,透射峰受电介质层的介电常数、入射角度和电磁波偏振影响明显. 关键词： 反铁磁层 准周期光子晶体 太赫兹波传输性质     

机械抛光铜金属表面对罗丹明的荧光增强效应

应用激光光谱学方法,研究了铜表面Rh6G分子的荧光增强效应对于金属衬底表面所形成的氧化层的依赖关系,探索了由于空气氧化而形成的氧化层在表面荧光增强效应中的重要意义和作用机理.实验采用罗丹明6G荧光探针分子,在532 nm连续光激发下,研究机械抛光铜金属衬底在经历不同氧化时间,对吸附其表面的Rh6G分子的荧光增强效果.研究结果表明,适当控制金属样品表面的氧化时间,金属铜表面对若丹明分子的荧光发射表现出猝灭和增强效应.金属氧化层起到了隔离荧光分子与金属表面的作用,减弱了由于激发态荧光分子向金属转移非辐射能量和在金属表面诱导反向偶极子而产生的荧光猝灭效应,从而提高了纯金属铜表面荧光增强辐射行为.因此在微纳金属衬底的荧光增强效应研究中,采用适当的实验手段,精确控制隔离层间距,是表面增强光谱获取的重要途径之一.     

有机层界面对双层有机发光二极管复合效率的影响

建立了双层有机发光二极管中载流子在有机层界面复合的无序跳跃理论模型.由于有机分子材料的空间及能带结构的无序性，采用刚体模型处理有机层界面问题是不恰当的，而采用无序跳跃模型比较合理.复合效率及复合电流由载流子跳跃距离、有机层界面的有效势垒高度及该界面处的电场强度分布所决定：在双层器件ITO/α-NPD/Alq₃/Al中，当所加电压小于19.5V时，复合效率随着载流子跳跃距离的增加而增加，而大于19.5V时，复合效率随着其距离的增加而减少；复合效率随着有机层界面有效势垒高度的增加而增加； 关键词： 有机层界面 双层有机发光二极管 复合效率 有效势垒高度 无序跳跃模型     

原子层沉积技术沉积的FeOx包裹层显著提高Pd/C催化剂在甲酸分解放氢反应中的催化活性

Hydrogen generation from formic acid (FA) has received significant attention.The challenge is to obtain a highly active catalyst under mild conditions for practical applications.Here atomic layer deposition (ALD) of FeO_x was performed to deposit an ultrathin oxide coating layer to a Pd/C catalyst,therein the FeO_x coverage was precisely controlled by ALD cycles.Transmission electron microscopy and powder X-ray diffraction measurements suggest that the FeO_x coating layer improved the thermal stability of Pd nanoparticles (NPs).X-ray photoelectron spectroscopy measurement showed that deposition of FeO_x on the Pd NPs caused a positive shift of Pd3d binding energy.In the FA dehydrogenation reaction,the ultrathin FeO_x layer on the Pd/C could considerably improve the catalytic activity,and Pd/C coated with 8 cycles of FeO_x showed an optimized activity with turnover frequency being about 2 times higher than the uncoated one.The improved activities were in a volcanoshape as a function of the number of FeO_x ALD cycles,indicating the coverage of FeO_x is critical for the optimized activity.In summary,simultaneous improvements of activity and thermal stability of Pd/C catalyst by ultra-thin FeO_x overlayer suggest to be an effective way to design active catalysts for the FA dehydrogenation reaction.     

A layer potential analysis for transmission problems for Brinkman‐type systems in Lipschitz domains in

The aim of this paper is to establish a well‐posedness result for a boundary value problem of transmission‐type for the standard and generalized Brinkman systems in two Lipschitz domains in , the former being bounded, and the latter, its complement in . As a first step, we establish a well‐posedness result for a transmission problem for the standard Brinkman systems on complementary Lipschitz domains in by making use of the Potential theory developed for such a system. As a second step, we prove our desired result (in L²‐based Sobolev spaces) by using a method based on Fredholm operator theory and the well‐posedness result from the previous step.     

A mixed hp FEM for the approximation of fourth‐order singularly perturbed problems on smooth domains

We consider fourth‐order singularly perturbed problems posed on smooth domains and the approximation of their solution by a mixed Finite Element Method on the so‐called Spectral Boundary Layer Mesh. We show that the method converges uniformly, with respect to the singular perturbation parameter, at an exponential rate when the error is measured in the energy norm. Numerical examples illustrate our theoretical findings.     

Comparative XPS study between experimentally and naturally weathered pyrites

A comparative study has been carried out between experimentally and naturally weathered pyrites. Both were found to share similar species of weathering products and a similar weathering mechanism. The weathering products could be divided into sulphur-bearing or iron-bearing groups. The sulphur-bearing group was comprised of sulphate, sulphite, thiosulphate, elemental sulphur, polysulphide, and mono-sulphide. The iron-bearing group was comprised of goethite, hematite or magnetite, and iron sulphate. The weathering structural profile was also similar for both types of weathering, being composed of a surficial layer and a transitional layer. The surficial layer was made up of both the sulphur-bearing and the iron-bearing products, while the transitional layer was comprised of goethite, and hematite or magnetite. The inward migration of the weathering interface was stimulated by the diffusion of oxygen and moisture. The oxygen was considered to preferably squeeze the iron to form goethite, and the ferric ions of goethite to have acted as a bridge for electron transfer between the oxygen and bulk S₂²⁻ and Fe²⁺ of pyrite.