Quantitative determination of UV filters in sunscreen lotions using microemulsion electrokinetic chromatography

Microemulsion electrokinetic chromatography (MEEKC) has been applied to the separation of some UV filters (Eusolex 4360, Eusolex 6300, Eusolex OCR, Eusolex 2292, Eusolex 6007, Eusolex 9020, Eusolex HMS, Eusolex OS, and Eusolex 232) commonly used in sunscreen lotions. Use of a MEEKC buffer with a mixed surfactant system to stabilize the oil droplets and an organic modifier in the aqueous phase allowed separation of most of the selected analytes in a single run in a system fitted with a diode array detector recording three wavelengths (240 nm, 300 nm, and 380 nm) simultaneously. The microemulsion employed consisted of 2.25 g of SDS, 0.75 g of Brij 35, 6.6 g 1‐butanol, 0.8 g n‐octane, 17.5 g 2‐propanol, and 72.1 g of 10 mM borate buffer (pH 9.2). Detection limits from 0.65 to 6.0 μg/mL were obtained and the calibration plots were linear over at least one order of magnitude for all analytes. The developed method could be applied to the determination of UV filters in several sun protection products including lotions, milks, and oils. Comparison of the obtained data with those from an HPLC method described in the literature showed acceptable agreement.     

Determination of atrazine, desethyl atrazine and desisopropyl atrazine in environmental water samples using hollow fiber-protected liquid-phase microextraction and high performance liquid chromatography

A new method based on hollow fiber-protected liquid-phase microextraction (LPME) was developed for the simultaneous determination of atrazine, desethyl atrazine and desisopropyl atrazine in environmental water samples. In LPME, analytes were extracted into 1-octanol immobilized in the micropores of a poly(vinylidene fluoride) porous hollow fiber membrane, and back extracted into the acceptor (4 M HCl) filled in the lumen of the hollow fiber. After LPME, the analytes trapped in the acceptor were analyzed with high-performance liquid chromatography after neutralization. The effect of extraction factors such as sample pH, acceptor pH, salinity, extraction time, stirring rate, and humic acid were studied. Under the optimized conditions, the limits of detection and relative standard deviations were respectively in the range of 0.5–1.0 μg L⁻¹ and 3.9–4.7% (n = 5). The proposed method was applied to determine atrazine, desethyl atrazine and desisopropyl atrazine in wastewater and groundwater samples. The three analytes were below the limits of detection, but good relative spiked recoveries over 90.1 ± 5.9% at 5 μg L⁻¹ spiked level were obtained.     

Diffusion coefficients from stopped-flow gas chromatography

Summary Mutual diffusion coefficients of two gases A and B can be determined in an empty gas chromatographic column by letting component B enter at an intermediate position of the column and continuously flow through a part only of it, as a carrier gas. The other component A is injected in a small amount instantaneously at the closed end of the column with the detector placed at the other end. By repeatedly stopping and then restoring after a short time the flow of B, narrow extra peaks are produced on the chromatographic elution curve, owing to diffusion of A into B. An equation is derived giving the area under the curve of each stop-peak as a function of time of the corresponding stop. Plotting the experimental data according to this equation permits the determination of the diffusion coefficient of A into B. Some results obtained by this method show negligible variations with changes in the experimental parameters.     

Evaluation of a complete HPLC solvent optimization system involving piece-wise quadratic modelling

Summary Interpretive methods are accepted to give the best possible results for selectivity optimization in HPLC. However the methods are very complex, and most work so far has been detailed academic studies. This paper describes an evaluation of a complete integrated system incorporating peak labelling, modelling of retention behaviour and calculation of response surfaces, with particular emphasis on the retention modelling. The peak labelling section has been discussed previously.A piece-wise quadratic function is investigated for the modelling of retention times across an isoeluotropic plane to effect selectivity optimization in HPLC. This requires 10 data-points on the isoeluotropic plane. The predicted global optimum and local optima are evaluated by comparison of calculated and experimental retention data, for a nine component sample. Seven interstitial points, distributed across the whole plane between the data-points, are similarly evaluated for a related sample. The typical error (in retention time) is less than 2%, often 1%, and the maximum error is 4.2%. At the global optimum the error was found be less than 1.3% for all 9 peaks.     

Gas chromatographic analysis of bifunctional amines after derivatization with methyldichlorophosphine and sulfur

Summary A derivatization procedure for the gas chromatographic analysis of bifunctional amines likeβ-adrenergic blocking drugs is described. The method consists of a two-step reaction with methyldichlorophosphine and sulfur in presence of triethylamine to form cyclic methylphosphonothioic derivatives. The properties of these compounds are discussed and the application of the method to the quantitation of ephedrine in human body fluids is presented. Presented at the 15th International Symposium on Chromatography, Nürnberg, October 1984     

氮杂冠醚研究Ⅶ、双仲胺型氮杂冠醚对过渡金属离子的选择性萃取作用

合成了五种新型双仲胺型氦杂冠醚，研究了它们对过渡金属离子进行液—液萃取，并用原子吸收法测定其浓度。实验结果表明：这类冠醚对Ａｇ￣＋、Ｐｄ￣（２＋）、和Ｐｔ￣（４＋）等贵金属离子有较强的选择配位性能，对选择性分离这些金属离子有重要的意义。     

The calculation of retention and selectivity in reversed-phase liquid chromatography II. Methanol-water eluents

Summary To calculate retention in reversed-phase, high-performance liquid chromatography a method based on the molecular structure of the analyte and the characteristics of sorbents and mobile phases has been employed. Characteristics of different ODS-columns in water-methanol eluents have been determined.     

Theoretical study of the effect of frit quality on chromatography using computational fluid dynamics

Summary Frits at both ends of a chromatographic column, especially for a preparative column, have significant influence on the flow distribution within the column and thus the column efficiency. However, frits have received little attention from chromatographers in the past. Here a theoretical study was conducted with the aid of CFD software FLUENT to investigate the effect of frits on the performance of homogeneous and heterogeneous chromatographic columns. A dimensionless number,FQ, was applied to characterize frit quality. This study visualized how frit quality affects the flow distribution and the concentration band, the shape of eluted pulse at the colum exit and column efficiency. Simulation results show that the development length of the flow distribution is related toFQ but has nothing to do with the packing heterogeneity. The curvature of the concentration band in a column depends onFQ and packing quality. This study shows column efficiency can be improved significantly by increasingFQ and/or frit permeability.     

Non isothermal heat capacities and chemical reactions using a modulated DSC

An evaluation of measurements of heat capacities by modulated differential scanning calorimetry, MDSC is presented. Heat capacities were obtained from 130 to 550 K by a non isothermal technique in which a periodic modulation was added to the linear heating rate. Effects of amplitude and period of modulation, sample weight, sample type, pan type, and cell imbalance are described. Results are compared with those obtained using the isothermal technique. Heat capacity could be measured well into the decomposition region and separated from the non reversing signal due to chemical reaction (degradation), thus allowing a precise detection of onsets of the thermal degradation. This additional information will aid in the interpretation of the degradation chemistry, a field vital for the petroleum-industry.Dedicated to Professor Bernhard Wunderlich on the occasion of his 65th birthdayPart of this paper was presented at the 23rd Conference of the North American Thermal Analysis Society, Toronto, Canada, September 25–28, 1994.The author (MVN) acknowledges the experimental assistance provided by J. Balogh of Exxon Research and Engineering Company, Linden. Helpful discussions with A. Boller of the University of Tennessee at Knoxville, Dr. Y. Jin, General Electrical, and Dr. S. Sauerbrunn formerly of TA Instruments are also acknowledged.