矩形微槽道纳米流体饱和沸腾临界热流密度特性

针对纳米流体在微小尺度传热领域的应用,在常压下对微槽道中纳米流体的流动沸腾临界热流密度进行实验研究。分别以体积浓度为0.2%、0.5%的水基Al2O3纳米流体为工质进行试验,研究不同质量流速、槽道尺寸以及体积浓度等因素对沸腾CHF的影响。对比水为工质实验结果,表明:槽道尺寸、质量流速对于水-Al2O3纳米流体和纯水的CHF影响一致。其它参数一定的工况下,纳米流体CHF比纯水大,且随着纳米流体体积浓度增大,出口壁面过热度会增大。最后介绍一个微槽道沸腾CHF的预测模型,在评价其不足的基础上提出一个关于CHF的预测公式,与实验数据进行对比,验证该公式的适用性。     

基于无信息变量消除法与岭极限学习机的新型变量选择方法：以CO气体浓度反演为例

变量选择是光谱分析领域一个重要的组成部分。为了克服传统区间选择法的缺点与不足,基于无信息变量消除法和岭极限学习机提出一种新型的变量选择与评价方法。首先,利用无信息变量消除法剔除整个光谱区间中无信息的波长点;其次,为了解决传统建模方法(偏最小二乘法、BP神经网络等)存在的共线性问题,采用岭极限学习机方法建立回归模型;最后,最佳的特征光谱波长点组合利用特征选择路径图和稀疏度-误差折中曲线进行确定。CO气体的浓度反演实验结果表明：(1)利用无信息变量消除法可以有效筛选出最能表征CO气体透过光谱的特征波长点;(2)岭极限学习机方法具有快速建模、避免共线性和高精度等优点(CO气体浓度反演模型的决定系数可达0.995);(3)特征选择路径图和稀疏度-误差折中曲线可以直观地帮助用户寻找出最佳的特征波长点组合。     

作物生长的土壤中氧气浓度场的稳态数值模拟

建立了一个描述土壤中热、湿、气耦合迁移的数学模型,对有冬小麦生长的圆柱形土壤床中的氧气浓度场进行 了数值模拟。结果表明,土壤床中的氧气浓度场与冬小麦的生长发育阶段、上壤的孔隙率以及土壤床的高度等因素密切相 关。     

Concentration on curves for a nonlinear Schrödinger problem with electromagnetic potential

We prove the existence of solutions to the nonlinear Schrödinger equation ${\epsilon }^2{(i\mathrm{?}+\mathit{A})}^{2}u+V(y)u?|u{|}^{p?1}u=0$ in ${\mathbb{R}}^2$ with a magnetic potential $\mathit{A}=(A_1,A_2)$. Here V represents the electric potential, the index p is greater than 1. Along some sequence $\{{\epsilon }_n\}$ tending to zero we exhibit complex-value solutions that concentrate along some closed curves.     

On concentration of solution to a Schrödinger logarithmic equation with deepening potential well

In this work, we prove the existence of positive solution for the following class of problems where λ>0 and is a potential satisfying some conditions. Using the variational method developed by Szulkin for functionals, which are the sum of a C¹ functional with a convex lower semicontinuous functional, we prove that for each large enough λ>0, there exists a positive solution for the problem, and that, as λ→+∞, such solutions converge to a positive solution of the limit problem defined on the domain Ω=int(V^?1({0})).     

Experiment on relationship between the magnetic gradient of low-carbon steel and its stress

In geomagnetic field, a series of tensile experiments on the low-carbon steel sticks were carried out. A special homemade detector was used to measure the magnetic gradient on the material surface. The results showed that the relationship between the magnetic gradient and the stress varied with different conditions of measurement. There was no obvious correlation between the magnetic gradient and the tensile stress if the sample remained on the material test machine. If the sample was taken off from the machine, the measured magnetic gradient was linear with the prior maximum stress. In Nanjing, PR China, a place of 32°N latitude, the slope of the linear relationship was about 67 (uT/m)/MPa. This offered a new method of non-destructive stress testing by measuring the magnetic gradient on the ferromagnetic component surface. The prior maximum applied stress of the sample could be tested by measuring the present surface magnetic gradient. Actually this phenomenon was the metal magnetic memory (MMM). The magnetic gradient near the stress concentration zone of the sample, the necking point, was much larger than other area. Thus, the hidden damage in the ferromagnetic component could be detected early by measuring the magnetic gradient distribution on its surface. In addition, the magnetic memory signal gradually weakened as the sample was taken off and laid aside. Therefore, it was effective for a given period of time to detect the stress or stress concentration based on the MMM testing.     

Free convection of a dusty‐gas flow along a semi‐infinite vertical cylinder

An analysis is performed to study the free convection of a dusty‐gas flow along a semi‐infinite isothermal vertical cylinder. The governing equations of the flow problem are transformed into non‐dimensional form and the resulting nonlinear, coupled parabolic partial differential equations have been solved numerically using an implicit finite difference scheme of Crank–Nicholson type. The flow variables such as gas–velocity, dust‐particle velocity and temperature, shearing stress and heat transfer coefficients are calculated numerically for various parameters occurring in the problem. It is observed that due to the presence of dust particles, the gas velocity is found to decrease. Copyright © 2009 John Wiley & Sons, Ltd.     

Synthesis and Characterization of Silicone Modified Polyurethane Surfactant Useable at High Temperature

A series of novel silicone modified polyurethane (Si-PU) surfactants were successfully synthesized by using hydroxypropyl-terminated polydimethylsiloxane (HPMS), polyethylene glycol (PEG), dimethylolpropionic acid (DMPA) and isophoronediisocyanate (IPDI). The chemical structure of the surfactant was confirmed by FTIR and ¹H-NMR. TEM photographs showed that the micelles of the Si-PU surfactants dispersed in aqueous solution were spherical with the particle size in the range of 100–400 nm. Surface tension measurements indicated that these surfactants had low surface tension to 29.9 mN·m^?1and a definite critical micelle concentration to, approximately 5.0×10^?4–7.5×10^?4mol·L^?1. When the content of HPMS was 20 wt%, the surfactant's, emulsifying performance was superior to the traditionally available Span80/Tween80 mixed emulsifiers. In addition to that, no phase transition temperature was detected from 20°C to 90°C by fluorescence probe and DSC measurements, confirming the high thermal stability of the micelles.     

Solvent effects on oxygen atom transfer reaction between manganese(V)-oxo corrole and alkene

Pseudo-first order reaction rate constants of 5,10,15-tris（pentafluorophenyl）corrole Mn（V）-oxo (F₁₅CMn（V）-oxo),5,15-bis（pentafluorophenyl）-10-（phenyl）corrole Mn（V）-oxo(F₁₀CMn（V）-oxo),5,15- bis（phenyl）-10-（pentafluorophenyl）corrole Mn（V）-oxo（F₅CMn（V）-oxo） and 5,10,15-tris（phenyl）corrole Mn（V）-oxo（F₀CMn（V）-oxo） with a series of alkene substrates in different solvents were determined by UV-vis spectroscopy.The results indicated that the oxygen atom transfer pathway between Mn（V）-oxo corrole and alkene is solvent-dependent.     

Simultaneous,real-time measurement of nitric oxide and oxygen dynamics during cardiac ischemia-reperfusion of the rat utilizing sol-gel-derived electrochemical microsensors

In this study, we simultaneously measured nitric oxide (NO) and oxygen (O₂) dynamics in the myocardium during myocardial ischemia-reperfusion (IR) utilizing sol-gel modified electrochemical NO and O₂ microsensors. In addition, we attempted to clarify the correlation between NO release in the ischemic period and O₂ restoration in the myocardium after reperfusion, comparing a control heart with a remote ischemic preconditioning (RIPC)-treated heart as an attractive strategy for myocardial protection. Rat hearts were randomly divided into two groups: a control group (n = 5) and an RIPC group (n = 5, with RIPC treatment). Myocardia that underwent RIPC treatment (182 ± 70 nM, p < 0.05) released more NO during the ischemic period than those of the control group (63 ± 41 nM). The restoration value of oxygen tension (pO₂) in the RIPC group significantly increased and was restored to pre-ischemic levels (92.6 ± 36.8%); however, the pO₂ of the control group did not increase throughout the reperfusion period (5.7 ± 7.5%, p = 0.001). Myocardial infarct size measurements revealed a significant decrease in cell death in the myocardium region of the RIPC group (41.44 ± 6.42%, p = 0.001) compared with the control group (60.05 ± 10.91%). As a result, we showed that the cardioprotective effect of RIPC could be attributed to endogenous NO production during the ischemic period, which subsequently promoted reoxygenation in post-ischemic myocardia during early reperfusion. Our results suggest that the promotion of endogenous formation during an ischemic episode might be helpful as a therapeutic strategy for protecting the myocardium from IR injury. Additionally, our NO and O₂ perm-selective microsensors could be utilized to evaluate the effect of drug or treatment.