Surface Modification of Fine Particles with a SnO<Subscript>2</Subscript> Film by Using a Polyhedral-Barrel Sputtering System

Fine particles were modified with a thin film of SnO₂ by using a barrel sputtering system that is a dry process. The conditions for the preparation of SnO₂ were studied by reactive sputtering onto a glass plate substrate. The optimal conditions for the preparation of tetragonal SnO₂ were identified as 60% partial oxygen pressure and 1.0 Pa total gas pressure with the substrate at room temperature. Under the optimized conditions, the surfaces of Al flake particles were modified with a thin film of SnO₂. XRD and SEM/EDS analysis of the prepared samples showed that the Al particle surfaces were uniformly modified by a thin film of SnO₂ in all cases. The film thicknesses were 80, 130, and 180 nm at RF outputs of 195, 350, and 490 W. These measured thicknesses coincided with the values estimated from the interference colors of the samples.     

Optimization of a portable microanalytical system to reduce electrode fouling from proteins associated with biomonitoring of lead (Pb) in saliva

There is a need to develop reliable portable analytical systems for on-site and real-time biomonitoring of lead (Pb) from both occupational and environmental exposures. Saliva is an appealing matrix since it is easily obtainable, and therefore a potential substitute for blood due to existing reasonably good correlation between Pb levels in blood and saliva. The microanalytical system is based on flow-injection/stripping voltammetry with a wall-jet (flow-onto) microelectrochemical cell. Samples that contain as little as 1% saliva can cause electrode fouling, resulting in significantly reduced responsiveness and irreproducible quantitations. In addition, incomplete Pb release from salivary protein can also yield a lower Pb response than expected. This paper evaluates the extent of in vitro Pb-protein binding and the optimal pretreatment for releasing Pb from the saliva samples. Even in 50% by volume of rat saliva, the electrode fouling was not observed, due to the appropriate sample pretreatment and the constant flow of the sample and acidic carrier that prevented passivation by the protein. The system offered a linear response over a low Pb range of 1-10 ppb, low detection limit of 1 ppb, excellent reproducibility, and reliability. It also yielded the same Pb concentrations in unknown samples as did the ICP-MS. These encouraging results suggest that the microanalytical system represents an important analytical advancement for real-time non-invasive biomonitoring of Pb.     

Molecular weight effect on the photoinduced birefringence and surface relief gratings formation of a methacrylate azopolymer

Samples of a methacrylic side-chain azopolymer were synthesized by a radical copolymerization of methyl-methacrylate with the methacrylic derivative of the commercial dye Disperse Red-13 (DR13). Copolymers with different molecular weight were obtained by varying the reaction time and the concentration of initiator. Samples with molecular weight averages (M_w) from 3 to 8 × 10⁴ g/mol and 1.4-1.7 polydispersity were obtained. The glass transition temperature of the samples increased linearly from the lower to the highest molecular weight. Optical quality cast films were prepared for all samples and photoinduced birefringence was successfully carried out in all samples as well as surface relief gratings could be inscribed in the cast films.     

Serum Chloride Optical Sensors Based on Dynamic Quenching of the Fluorescence of Photo-Immobilized Lucigenin

This article describes the preparation and performance of an optical sensor for continuous measurement of chloride at extracellular (serum) levels (20–200mM). The sensor is based on dynamic quenching of the fluorescence of lucigenin which was photo-immobilized on a hydrogel. Quenching occurs via a collisional mechanism, and the decrease in fluorescence intensity on exposure to 100mM chloride typically is –60%. It allows the determination of chloride in the 1 to 200mM concentration range, with a precision of ±3mM at 120mM. Bromide, iodide and salicylate act as interferents, while the effect of pH and oxygen is negligibly small. The sensor displays strong fluorescence intensity, excellent reproducibility, long-term stability, response times in the order of 2–5min, and is used in a commercial serum and blood chloride analyzer.Received January 21, 2003; accepted April 6, 2003 Published online July 28, 2003     

Oscillation condition for a series piezoelectric sensor. Application to the determination of urease activity in plant seeds

The oscillating conditions for a series piezoelectric quartz crystal (SPQC) are proposed and verified experimentally. The influence of the cell constant and oscillator phase on the oscillational ability of the SPQC was investigated. It is shown that the SPQC possesses excellent oscillational ability in low or high conductivity solutions, but in solution of intermediate conductivity, the oscillational ability decreases with increasing oscillator phase or decreasing cell constant, sometimes resulting in a cease-to-oscillate zone. The SPQC was applied to determine the urease activity in plant seeds with a detection limit of 0.004 U ml⁻¹, based on the change in conductivity.     

5,6—二亚甲基双环[2.2.1]庚—2—醇及其衍生物的旋光与构型

从（－）－（１Ｓ，２Ｒ，４Ｓ）－５，６－二亚甲基双环［２．２．１］庚－２－醇（Ｉ）和（－）－（１Ｓ，２Ｓ，４Ｓ）－５，６－二亚甲基双环［２．２．１］庚－２－醇（Ⅱ）出发，合成了它们的醚类和取代苯甲酸酯类光学纯的衍生物。通过［α］Ｄ测定和构型分析，发现它们是含有３个手性碳（Ｃ１，Ｃ２和Ｃ４）的桥环化合物，其旋光性与构型的关系均符合可极化度多级圆球不对称性模型。     

基于杯芳烃的阳离子荧光分子传感器的研究进展

按照荧光团的种类, 综述了基于杯芳烃的荧光分子传感器对阳离子选择性荧光传感性能的研究进展.     

Spacer effect of appended moieties for molecular recognition in doubly-sodium anthranilate modified γ-cyclodextrin

-Cyclodextrin with two sodium anthranilate moieties (1) has been prepared as a sensor for detecting organic compounds including terpenoids and steroids. Compound1 shows a pure monomer fluorescence whose intensity is increased or decreased upon addition of the guest species examined. In this system, the sodium anthranilate moieties act either as a spacer, which enables the cyclodextrin to form a 1:1 host-guest complex by narrowing the -cyclodextrin cavity, or as a hydrophobic cap.1 recognizes steroids with much higher sensitivity than terpenoids, in which the appended moieties act as a hydrophobic cap for terpenoids and a spacer for steroids, respectively.     

JD树脂刻蚀及涂层的XPS研究

ＪＤ光学树脂表面刻蚀过程的ＸＰＳ研究表明，引进树脂遥ＣＯＨ，Ｃ＝Ｏ，Ｃ－ＳＯ３Ｈ，ＣＯＯＨ等基因随刻蚀温度的提高或时间的延长而增加，对其相对含量进行了计算，固化后的耐磨涂层具有ＳｉＯ２结构，ＪＤ板材的最佳刻蚀条件为２０℃，２０ｍｉｎ。     

Molecular structure and nanosecond optical limiting property of a typical silver cubane-like cluster containing tetraselenotungstate

A typical silver cubane-like heteroselenometallic cluster, (μ₃-WSe₄)Ag₃(PPh₃)₃Cl·0.5SePPh₃, was synthesized from reaction of [Et₄N]₂[WSe₄] and Ag(PPh₃)₂(NO₃) in CH₂Cl₂ solution and structurally characterized by X-ray crystallography. The compound crystallizes in the trigonal space group R3 with a=16.258(4), b=22.80(3) Å, V=5217(7) ų, and Z=3. The structure contains a strongly distorted cubane-like {WAg₃Se₃Cl} core. The coordination geometries of the W center and each Ag atom are tetrahedral. The mean W-Ag separation is 3.010(3) Å. Optical nonlinearity of this cubane-like cluster was studied. Large optical limiting effect with threshold of 0.45 J/cm² was observed with the laser pulses of 7 ns at 532 nm.