制备方法对Pt-Sn-K-Mg/γ-Al2O3催化剂正十二烷脱氢性能的影响

以正十二烷脱氢反应为探针反应,采用顺序浸渍、乙醇共浸渍、盐酸共浸渍的方法制备了Pt-Sn-K-Mg/γ-Al2O3催化剂,并采用NH3-TPD、CO脉冲吸附、H2-TPR、准原位XPS等表征手段探究浸渍顺序和溶剂对催化剂构效关系的影响。结果表明,盐酸水溶液共浸渍的方法制备的催化剂表现出了最佳的初始活性和较好的稳定性。催化剂的弱酸性位点的增加有利于Pt的分散,从而提高催化性能。采用乙醇为溶剂的共浸渍方法更有利于PtSn间形成更强的相互作用生成更多的PtSn合金,这对初始活性不利,但对选择性影响较小。     

NAD(P)H辅酶模型在Mg2+离子催化条件下还原N-芳基芴亚胺反应的研究

对Hantzsch酯在Mg²⁺存在和不存在的情况下还原N-芳基芴亚胺的反应进行了研究, 并与BNAH的类似还原做了系统的比较.研究结果表明:Mg²⁺在该还原反应中起亲电催化剂的作用;还原能力较BNAH弱的Hantzsch酯在反应中所呈现的强的反应性是由于其3, 5-位两个极性谈基氧通过静电作用降低过渡态的能量的缘故;本文反应届H-一步转移机理.     

Preparation of SiO2-TiO2 Aerogels Using Supercritical Impregnation

The preparation of SiO₂-TiO₂ aerogels by supercritical impregnation of titanium alkoxides into silica alcogels was investigated. A mixture of CO₂ and 2-propanol with dissolved titanium tetraisopropoxide modified with acetylacetone was used as the impregnation medium. Prior to the experiments, the supercritical behaviour of the impregnation solution was investigated. The microstructure and properties of aerogels prepared by the supercritical impregnation method were almost identical to those generated by the liquid impregnation. However, the time for impregnation was substantially decreased and the homogeneity of the impregnated titanium distribution on the aerogel increased.     

催化剂活性组分的负载方法对CVD法制备碳纳米管的影响

催化剂是影响CVD法制备碳纳米管的主要因素。本文报道了用配合浸渍法制备的催化剂在碳纳米管制备中的应用。XRD和TEM研究表明：与普通浸渍法制备的催化剂（B－Co/SiO2)相比,用配合浸渍法制备的催化剂（A－Co/SiO2)颗粒小,金属分散度高,生成碳纳米管的温度低。对于配合浸渍法制备的催化剂（A－Co/SiO2),低温（650－750℃）有利于生成直径小且管径均匀的碳纳米管;高温（800－900℃）容易生成直径大且层数多的碳纳米管或碳纳米棒。     

Oxidation of Carbon Monoxide over Cu/CeO_2 Catalysts Prepared by SMAI

Introduction Carbon monoxide is ubiquitous air pollutants emitted by many sources. Total oxidation of carbon monoxide to carbon dioxide is employed to meet environmental regulations in an economic way. Precious metals (Pt, Pd) are well-known oxidation catalysts with high activity and stability, and are widely used for exhaust gas emission control. However, the high cost of precious metals and their sensitivity to sulfur poisoning have long motivated the search for substitute catalysts. …     

溶剂化金属原子浸渍法制备高分散Au/TiO2低温CO氧化催化剂

用溶剂化金属原子浸渍法制备了不同金含量的高分散Ａｕ／ＴｉＯ２催化剂,ＸＲＤ和ＴＥＭ测定结果表明,随着金含量的增加,金颗粒度增大,但直径都在１．８～３．５ｎｍ范围内,ＸＰＳ研究表明上于金属态,Ａｕ／ＴｉＯ２在低温下就显示出较高的ＣＯ知性,３２３Ｋ时ＣＯ的转化率可达到１００％,金颗粒度为１．８ｎｍ的Ａｕ／ＴｉＯ２催化剂活性最高。     

固相浸渍法和湿浸渍法制备CuO/CeO2催化剂及其CO氧化性能的对比研究

采用固相浸渍法和常规湿浸渍法制备了一系列CuO/CeO₂催化剂,并结合X射线衍射（XRD）、氢气-程序升温还原（H₂-TPR）、激光拉曼光谱（LRS）、原位漫反射红外光谱（in situ DRIFTS）、X射线光电子能谱（XPS）等手段考察了制备方法对催化剂结构性质及其在CO氧化反应中性能的影响. XPS和H₂-TPR结果表明,固相浸渍法更有利于得到高分散的铜物种,并促进CuO物种的还原. LRS结果表明,相比于湿浸渍法,固相浸渍法能产生更多氧空位,而这些氧空位可以活化参与反应的O₂. CO氧化活性测试结果表明,当铜负载量相同时,固相浸渍法制备的催化剂相比于湿浸渍法表现出更好的催化性能. 结合多种表征结果发现,催化剂CO氧化性能与其表面氧空位和Cu⁺-CO浓度紧密相关,提出了CuO/CeO₂催化剂在CO氧化反应中可能的协同作用机制.     

改性纳米HZSM-5沸石催化剂上C5～C8混合烷烃的芳构化反应

在小型固定床反应器上研究了水蒸气钝化及过渡金属(Ni,Co,Cu,Zn)改性对调变纳米HZSM-5沸石催化剂上C5~C8混合烷烃芳构化反应的作用.采用NH3-TPD和Py-FT-IR方法表征了改性催化剂的表面酸性质,并与其催化芳构化性能进行了关联.结果表明,在450℃下进行水蒸气钝化能显著提高催化剂的芳构化选择性,减少甲烷和乙烷等低碳烷烃的生成;催化剂进一步用锌盐或铜盐溶液浸渍改性,可以显著提高催化剂的抗积炭失活能力.这是由于水蒸气钝化能适当减少沸石表面的酸量,降低酸强度,而铜、锌改性可进一步减少B酸中心,增加L酸中心,并与B酸中心协同作用形成具有脱氢活性的催化中心,从而影响混合烷烃的活化方式与芳构化路径.     

制备方法对Pd催化剂上丙烯选择性还原NO反应性能的影响

 采用三种不同方法制备了氧化铝负载的Pd催化剂．比表面积测定\r\n结果表明,与浸渍法相比,溶胶－凝胶加浸渍法和溶胶－凝胶法制备的\r\nPd／Al2O3样品具有较大的比表面积,但抗烧结性能不佳．其中采用溶\r\n胶－凝胶法制备的样品中,由于Pd分散于体相中,表面的活性位相对较\r\n少,造成催化剂在NO选择性还原反应中的活性较差;而将Pd浸渍于溶胶\r\n－凝胶法制得的Al2O3载体上所获得的催化剂比表面积较大,活性较好\r\n．添加CeO2的样品活性总体上比Pd／Al2O3样品高．其中采用溶胶－凝\r\n胶法制备的样品比表面积不大,并且XRD数据表明Al2O3和CeO2是高度分\r\n散并均匀地搀杂在一起的,不象在浸渍法制备的样品中那样以大晶粒的\r\n形式存在,因而CeO2的助剂作用没有充分体现出来,催化剂的活性比浸\r\n渍法制备的样品差一些．     

Anti-idiotypic nanobody-alkaline phosphatase fusion proteins: Development of a one-step competitive enzyme immunoassay for fumonisin B1 detection in cereal

A rapid and sensitive one-step competitive enzyme immunoassay for the detection of FB₁ was developed. The anti-idiotypic nanobody–alkaline phosphatase (Ab2β−Nb−AP) was validated by the AP enzyme activity and the properties of bounding to anti-FB1-mAb (3F11) through colorimetric and chemiluminescence analyses. The 50% inhibitory concentration and the detection limit (LOD) of colorimetric enzyme-linked immunosorbent assay (ELISA) for FB₁ were 2.69 and 0.35 ng mL⁻¹, respectively, with a linear range of 0.93–7.73 ng mL⁻¹. The LOD of the chemiluminescence ELISA (CLIA) was 0.12 ng mL⁻¹, and the IC₅₀ was 0.89 ± 0.09 ng mL⁻¹ with a linear range of 0.29–2.68 ng mL⁻¹. Compared with LC-MS/MS, the results of this assay indicated the reliability of the Ab2β−Nb−AP fusion protein based one-step competitive immunoassay for monitoring FB₁ contamination in cereals. The Ab2β−Nb−AP fusion proteins have the potential to replace chemically-coupled probes in competitive enzyme immunoassay systems.