Qualitative supercritical fluid extraction coupled to capillary gas chromatography

The usefulness and ease of utilizing supercritical fluid extraction (SFE) directly coupled to capillary gas chromatography (GC) as quantitative or qualitative analytical problem-solving tools will be demonstrated. As an alternative to conventional liquid solvent extractions, SFE presents itself as a means to achieve high extraction efficiencies of different compounds in complex solid matrices in very rapid tims frames. Moreover, SFE has an additional advantage of being able to achieve distinct extraction selectivities as a function of the solubilizing power of the supercritical fluid extracting phase. For on-line SFE/GC, the extraction effluent is directly transferred to the analytical chromatograph. On-line SFE/GC involves the decompression of pressurized extraction effluent directly into a heated, unmodified capillary split injection port of the GC. In this respect, SFE introduction into GC can be used as an alternative means of GC injection, comparable to such modes of injection as pyrolysis and thermal desorption. This paper will show applications of SFE/GC where mass spectrometric detection together with flame ionization detection was used for component identification from environmental, tobacco, and petroleum matrices.     

Comparison by capillary SFC and SFC-MS of soxhlet and supercritical fluid extraction of hamster feces

Components of hamster feces ranging from low molecular weight fatty acids through the expected range of triglycerides have been eluted in a single SFC run with simultaneous pressure and temperature programming. Temperature programming from 140°C to 240°C was required to provide optimum conditions for separation of the fatty acids and to move the elution region of the sterol esters away from that of the triglycerides. Data from chemical ionization and electron impact mass spectrometry of compounds separated by SFC were used to confirm identities suggested by retention measurements and to provide tentative identities of unknown compounds. SFC with flame ionization detection was used to compare Soxhlet extraction, off-line supercritical fluid extraction (SFE), and on-line SFE of the feces. Although samples obtained by Soxhlet extraction and SFE produced very similar chromatograms, SFE required far less time and consumed much smaller quantities of organic solvent.     

Partially concurrent eluent evaporation with an early vapor exit; detection of food irradiation through coupled LC-GC analysis of the fat

This paper reports two subjects. It describes LC-GC transfer by partially concurrent eluent evaporation at a greatly accelerated rate, as required for optimal compatibility with 2–3 mm i.d. LC columns and LC flow rates up to some 500 μl/min. Evaporation rates around 200 μl/min were obtained using a 0.53 mm. i.d. uncoated pre-column and an early vapor exit. A stationary-phasecoated “retaining” pre-column was used for preventing escape of volatile solutes through the vapor exit. The technique was used for the detection of food irradiation by analyzing selected radiolysis products of triglycerides, namely alkanes/alkanes and aldehydes. Extracted fat of chicken, hazel-nuts, and soup mixes was injected in LO and the relevant fractions were transferred on-line to GC. For chicken and nuts, detection of irradiation was possible down to doses below 0.5 kGy. Detection limits were higher for soup mixes due to interfering peaks.     

In-capillary micro solid-phase extraction and capillary electrophoresis separation of heterocyclic aromatic amines with nanospray mass spectrometric detection

A miniaturised technique to analyse and detect heterocyclic aromatic amines (HAs) using micro solid-phase extraction (SPE) coupled on-line (in-capillary) to capillary electrophoresis (CE) separation with nanospray (nESI) mass spectrometry (MS) detection has been developed. HAs are mutagenic and carcinogenic compounds formed at low levels in protein-rich food during cooking. Due to the low concentrations of HAs and the high complexity of the matrix in which they exist, sensitive and selective analytical methods are required for quantification. SPE was performed on a packed bed of C₁₈ particles inside the CE capillary, which minimised the dead volume. The on-line coupling of SPE, CE and nESI-MS reduced the time for extraction and identification to less than half an hour, which will allow for screening of several samples per day. The new technique provides short analysis time, low sample and solvent consumption, and HAs in standard solutions were easily detected at 12–17 fmol injections, and in spiked urine samples at 750–810 fmol injections.     

Coupled LC-GC: The capacity of silica gel (HP)LC columns for retaining fat

Many applications of coupled LC-GC in food analysis require that LC separates large quantities of triglycerides from the components of interest. The capacities of silica gels to retain triglycerides have been determined for n-hexane as mobile phase as well as some eluent mixtures. Conclusions are drawn for practical applications.     

Evaluation of an on-line coupled continuous flow liquid membrane extraction and precolumn system as trace enrichment technique by liquid chromatographic determination of bisphenol A

An on-line coupled continuous flow liquid membrane extraction (CFLME) and C₁₈ precolumn system was developed for sample preconcentration in liquid chromatography determination. After preconcentration by CFLME, which is based on the combination of continuous flow liquid–liquid extraction and supported liquid membrane, bisphenol A (BPA) was enriched in 960 μl of 1 mol l⁻¹ NaOH used as acceptor. This acceptor was on-line neutralized and transported onto the C₁₈ precolumn where analytes were absorbed and focused. Then the focused analytes were injected onto a C₁₈ analytical column for separation and detected at 220 nm with a diode array detector. CFLME related parameters such as flow rates, pH of donor and acceptor, and enrichment time were optimized. The proposed method presents a detection limit of 0.03 μg l⁻¹ (S/N=3) when 60 ml samples was enriched with an enrichment time of 30 min. Compared with C₁₈ based column-switching procedure, this proposed procedure presents similar sample throughput and lower detection limits. The proposed method was successfully applied to determine BPA in tap water, river water, and municipal sewage effluent samples.     

Analysis of turkish lignite tar by coupled LC/GC,GC/MS,and capillary SFC

This work describes the analysis of a pyrolysis product of a lignite sample obtained from the Turkish Goynuk reserve. The aliphatic, aromatic and polar compounds present in the tar are separated and identified by various chromatographic techniques: Capillary gas chromatography/mass spectrometry (GC/MS), on-line high performance microbore liquid chromatography/capillary gas chromatography (LC/GC) and capillary supercritical fluid chromatography (SFC). The suitability of each technique for this particular application is discussed, and semi-quantitative results are presented for the major components detected.     

“线上线下-虚实结合”在有机化学实验教学中的应用探索——以正溴丁烷的制备实验为例

In response to the impact of the Covid-19 epidemic on organic chemistry laboratory teaching, this article analyzes and discusses the current limitation of traditional organic chemistry laboratory teaching. Taking the "preparation of n-bromobutane" as an example, a new "online-offline and virtual-actual combination" teaching mode with the combination of "Tencent Meeting, MLabs, laboratory and WeChat group" is introduced. The practice of the new mode of teaching includes the following steps: pre-class online guiding by teacher, student preview and practice based on the virtual simulation platform, students and teacher discussion and operation in laboratory, and post-classcomprehensive assessment and Q&A", and good teaching effects have been received. It is significant in cultivating and improving the independent innovation and practical ability, and provides reference for the organic chemistry laboratory teaching reform and also lays a foundation for the construction of "outstanding course" of organic chemistry.     

Solid-phase extraction system for Pb (II) ions enrichment based on multiwall carbon nanotubes coupled on-line to flame atomic absorption spectrometry

The present paper proposes the application of multiwall carbon nanotubes (MWCNTs) as a solid sorbent for lead preconcentration using a flow system coupled to flame atomic absorption spectrometry. The method comprises the preconcentration of Pb (II) ions at a buffered solution (pH 4.7) onto 30 mg of MWCNTs previously oxidized with concentrated HNO₃. The elution step is carried out with 1.0 mol L⁻¹ HNO₃. The effect of the experimental parameters, including sample pH, sampling flow rate, buffer and eluent concentrations were investigated by means of a 2⁴ full factorial design, while for the final optimization a Doehlert design was employed. Under the best experimental conditions the preconcentration system provided detection and quantification limits of 2.6 and 8.6 μg L⁻¹, respectively. A wide linear range varying from 8.6 up to 775 μg L⁻¹ (r > 0.999) and the respective precision (relative standard deviation) of 7.7 and 1.4% for the 15 and 200 μg L⁻¹ levels were obtained. The characteristics obtained for the performance of the flow preconcentration system were a preconcentration factor of 44.2, preconcentration efficiency of 11 min⁻¹, consumptive index of 0.45 mL and sampling frequency estimated as 14 h⁻¹. Preconcentration studies of Pb (II) ions in the presence of the majority foreign ions tested did not show interference, attesting the good performance of MWCNTs. The accuracy of the method was assessed from analysis of water samples (tap, mineral, physiological serum and synthetic seawater) and common medicinal herbs submitted to the acid decomposition (garlic and Ginkgo Biloba). The satisfactory recovery values obtained without using analyte addition method confirms the feasibility of this method for Pb (II) ions determination in different type of samples.     

On-line preconcentration and determination of nickel in natural water samples by flow injection-inductively coupled plasma optical emission spectrometry (FI-ICP-OES)

An on-line nickel preconcentration and determination system implemented with inductively coupled plasma optical emission spectrometry (ICP-OES) associated to flow injection (FI) was studied. Trace amounts of nickel were preconcentrated by sorption on a conical minicolumn packed with activated carbon (AC) at pH 5.0. The nickel was removed from the minicolumn with 20% nitric acid. An enrichment factor of 80-fold for a sample volume of 50 ml was obtained. The detection limit (DL) value for the preconcentration method proposed was 82 ng l⁻¹. The precision for ten replicate determinations at the 0.5 μg l⁻¹ Ni level was 3.0% relative standard deviation (R.S.D.), calculated from the peak heights obtained. The calibration graph preconcentration method for nickel was linear with a correlation coefficient of 0.9997 at levels near the detection limits (DL) up to at least 100 μg l⁻¹. The method was successfully applied to the determination of nickel in natural water samples.