流动注射在线共沉淀预富集火焰原子吸收法测定痕量铜

研究了以Ｎｉ＾２＋－ＤＤＴＣ为共沉淀载体，流动注射在线共沉淀预富集－火焰原子吸收光谱法测定痕量铜的体系，在０．３ｍｏｌ．Ｌ＾－１的硝酸介质中，铜离子在编织反应器中与Ｎｉ＾２＋－ＤＤＴＣ（产生共沉淀，并被收集在编织器内壁上，用甲基异丁基酮（ＭＩＢＫ）在线洗脱沉积物并引入火争原子化器中测定。当富集时间为４０ｓ时，４０μｇ．Ｌ＾－１的铜１０次测定的相对标准偏差为３．０％，灵敏度提高６０倍，检出限（３σ）     

The role of various binding materials for trace elemental analysis of powder samples using laser-induced breakdown spectroscopy

Study of various binding materials like potassium bromide, poly(vinyl alcohol), starch, silver and aluminum has been carried out using laser-induced breakdown spectroscopy (LIBS). The role of matrix effects using these five binders on LIBS signal intensity was investigated for better performance of LIBS technique as a quantitative analytical tool. For comparative study of different binders, the signal intensity of different Mg lines at 518.3, 517.2, 383.8 and 279.5 nm wavelengths were recorded for pellets prepared with known concentrations of Mg in these binders. The influence of laser energy on ablated mass under different binding materials and its correlation with LIBS signal intensity has been explored. Optical scanning microscopy images of the ablated crater were studied to understand the laser ablation process. The study revealed that the binding material plays an important role in the generation of LIBS signal. The relative signal intensity measured for a standard Mg line (at 518.3 nm) were 735, 538, 387, 227 and 130 for potassium bromide, starch, poly(vinyl alcohol), silver and aluminum as binders, respectively. This indicates clearly that potassium bromide is better as a binder for LIBS studies of powder samples.     

Effect of Enzyme Modification of Corn Grits on their Properties as an Adsorbent in a Skarstrom Pressure Swing Cycle Dryer

Corn grits have been tested as a desiccant in a pressure swing adsorption (PSA) system to produce dry air. Two sizes of unmodified corn grits were tested in the PSA system: 2.16 and 0.978 mm in diameter, which dried moist air to dew points of –42°C and –69°C, respectively. A modification technology has been developed for the corn grits that gives an increase in the operational adsorptive capacity in a pressure swing adsorption system, so that they remove as much moisture from air as molecular sieves at the same conditions. After modification, 2.16 mm corn grits dry moist air to a –56°C dew point and the 0.978 mm corn grits dry air to a –80°C dew point. The modification process creates surface modifications on the corn grits apparently making more adsorption sites easily available. The modification procedure increases the specific surface area of the grits and possibly decreases the crystallinity, which would make more hydroxyl groups available for adsorption of water. Possible applications of using corn grits in the pressure swing adsorption system include industrial gas dryers, sorptive cooling air conditioners, and recycling equipment for industrial solvents.     

Theory of measurement of gas-adsorption equilibria by rotational oscillations

The gas adsorbed on the inner surface of a highly porous material like activated carbon or zeolite can be measured by slow damped oscillations of a torsional pendulum. The physical principles and the theory of this method are outlined. Formulas are given relating the increase in mass due to adsorption to changes of the frequency and the logarithmic decrement of slow, damped rotational oscillations of the pendulum. Preliminary measurements of gas adsorption equilibria of nitrogen on activated carbon show that the ratio of the mass adsorbedm, to the mass of the adsorbentm ^s , can be determined by this method with mean absolute error |m/m ^s |0.04%.Dedicated to the memory of Joseph Kestin (1913–1993).     

Measurement of Diffusion in Zeolites—A Never Ending Challenge?

A review is given on the main problems associated with the determination and interpretation of molecular diffusion in zeolites. It is shown that the diffusivities may most decisively depend on the relevant space and time scales of observation, as well as on the physical state under which the measurements are carried out. Special emphasis is given to the microscopic techniques and their most recent evidence on the existence of transport resistances distributed over the intracrystalline space.     

Selective Determination of Trace Mercury (II) after Preconcentration with 4-(2-Pyridylazo)-Resorcinol-Modified Nanometer-Sized SiO2 Particles from Sample Solutions

A rapid, selective method that utilize 4-(2-Pyridylazo)-resorcinol (PAR)-modified nanometer SiO₂ (nanometer SiO₂–PAR) as a new solid-phase extractant for preconcentration of trace mercury (II) has been developed. The adsorption property of nanometer SiO₂–PAR for metal ions was studied by selectively extracting different metal ions from aqueous solutions. The results revealed an excellent affinity of the nanometer SiO₂–PAR for mercury (II) in presence of interfering metal ions at pH 4. The main parameters of solid-phase extraction such as shaking time, elution and sample dilution effect were studied. The extractant shows rapid kinetic sorption, and the adsorption equilibrium of mercury (II) on nanometer SiO₂–PAR was achieved in less than 2 min. The adsorbed mercury (II) was easily eluted by 4 mL of 6 mol L⁻¹ HCl. The maximum preconcentration factor was 50. The maximum static adsorption capacity was 276 μmol g⁻¹ at pH 4. The detection limit (3σ) was 0.43 μg L⁻¹ for cold vapor atomic absorption spectrometry (CVAAS), and the relative standard deviation of the eight replicate determinations was 2.4% for the determination of 2.0 μg of Hg(II) in 100 mL water sample. The method was applied to the determination of trace mercury (II) in sample solutions with satisfactory results.     

Molecular and nanoscale materials and devices in electronics

Over the past several years, there have been many significant advances toward the realization of electronic computers integrated on the molecular scale and a much greater understanding of the types of materials that will be useful in molecular devices and their properties. It was demonstrated that individual molecules could serve as incomprehensibly tiny switch and wire one million times smaller than those on conventional silicon microchip. This has resulted very recently in the assembly and demonstration of tiny computer logic circuits built from such molecular scale devices. The purpose of this review is to provide a general introduction to molecular and nanoscale materials and devices in electronics.     

A new apparatus for the extraction of organic compounds from aqueous solutions

A new apparatus for the extraction of organic compounds from sea water is described. With this apparatus it is possible to extract 54 standard compounds with high recovery percentages from 9 1 of sea water with 3 ml ofn-hexane. The analysis time (about 1 h) is appreciably lower than those of the extraction methods based on RP-18 and Carbopack-B adsorption (about 15 h). Furthermore, it is possible to analyze samples without filtration. An application of this method to the analysis of Tirreno sea water is reported.     

Characteristics and production of thermostable α-amylase

Thermostable α-amylases have application in a variety of industrial processes and enzymes from a substantial number of thermophilic bacteria and fungi have been screened and characterized to varying degrees. The characteristics of these enzymes are summarized in this review. The genetics of α-amylase production inBacillus subtilis is reviewed and classical and recombinant DNA approaches to increasing α-amylase production are discussed.     

On-line enrichment system for manganese determination in water samples using FAAS

An on-line preconcentration procedure for the determination of manganese using flow-injection approach with flame atomic absorption spectrometry as a detection method is described. The proposed method is based on the complexation between Mn(II) and 5,10,15,20-tetrakis(4-carboxyphenyl)porphyrin (TCPP). Two approaches were investigated for enrichment of manganese; the formation of Mn-TCPP complex in a solution followed by its retention on a sorbent and the sorption of manganese ions onto the TCPP-modified resin. The best results was obtained for the first approach when 10⁻⁵ M reagent was on-line mixed with an aqueous sample solution and passed through the microcolumn packed with anion-exchange resin Amberlite IRA-904 for 5 min. The sorbed complexes were then eluted with 0.5 ml of 2 M HNO₃. A good precision (2.2-3.1% R.S.D. for 50 μg l⁻¹ manganese) and the enrichment factor of 30 were obtained with the detection limit of 12 μg l⁻¹ for 5 min loading time. The interference of anions and cations has been studied to optimize the conditions and the method was applied for determination of manganese in natural water samples. The results obtained by FI-FAAS and ETAAS (as a reference method) were not statistically different for a significance level of 0.05.