La_(1-x)Ca_xMn_(1.03)O_3外延薄膜的输运性质

本文报道了用溶胶 -凝胶 (sol- gel)方法 ,在 La Al O3 (10 0 )衬底上制备 L a1-x Cax Mn1.0 3 O3 外延薄膜的输运性质 .Ca含量 x在 0 .2～ 0 .6 2 1范围内 ,电阻率随温度的变化关系 ,是从类半导体行为向金属导电行为转变 ,在 x≥ 0 .5的 4个样品中并没有发现电荷有序绝缘体 (COI)和反铁磁绝缘体 (AFI)现象 .Tc最高达 2 75K,MR最大可达 10 4 % (x =0 .2 ,H =1.5T) .在 T >Tp 或 Tc的温区内 ,电阻率ρ∝exp(- E/ k T) ,说明载流子的迁移是以热激活方式进行的 ,热激活能为 0 .32～ 18.3me V.当 T 0 .4 ) .     

Enhanced energy storage and pyroelectric properties of highly (100)-oriented (Pb1−x−yLaxCay)Ti1−x/4O3 thin films derived at low temperature

Highly (100)-oriented (Pb_1?x?yLa_xCa_y)Ti_1?x/4O₃ ($x=0.15$, $y=0.05$; $x=0.1$, $y=0.1$; $x=0.05$, $y=0.15$) thin films were deposited on Pt/Ti/SiO₂/Si substrates at a low temperature of 450?°C via a sol–gel route. It was found that all the (Pb_1?x?yLa_xCa_y)Ti_1?x/4O₃ thin films could be completely crystallized and the content of La/Ca showed a significant effect on the electrical properties of films. Among the three films, the (Pb_1?x?yLa_xCa_y)Ti_1?x/4O₃ ($x=0.1$, $y=0.1$) thin film exhibited the enhanced overall electrical properties, such as a low dielectric loss ($\tan ?\delta <0.08$) and leakage current ($J～4.6\times {10}^{?5}$ A/cm²), a high recoverable energy density (W_re ～ 15 J/cm³), as well as a large pyroelectric coefficient (p ～ 190 μC/m²K) and figure of merit ($F_{\mathrm{d}}^{\prime }～77\mathrm{\mu }\text{C}/{\text{m}}^2$K). The findings suggest that the fabricated thin films with a good (100) orientation can be an attractive candidate for applications in Si-based energy storage and pyroelectric devices.     

Correlation between photophysical properties and lasing performances of Rhodamine-19 in three types of sol–gel glass hosts

Rhodamine-19 (Rh-19) incorporated three types of sol–gel samples (mentioned as dope route-I, dope route-II and dip method) were prepared by using two different methods of dye impregnation. The photophysical properties of all the three types of Rh-19 incorporated sol–gel solids were studied by using the UV–Visible absorption and the fluorescence spectroscopy. A single photon counting technique was used to estimate the lifetime of fluorescent species. From the study of fluorescence spectra, the coexistence of dimers (fluorescent and non-fluorescent both) and monomer of Rh-19 was observed. The photophysical properties of Rh-19 were found to be the best in dip sample, medium in dope route-II sample and low in dope route-I sample. After studying photophysical properties, the samples were subjected to laser study under nitrogen laser pumping at 337.1 nm at the rate of 1.5 Hz in transverse dye laser cavity. The highest laser efficiency and photostability of the dye were observed in dip sample, medium in dope route-II sample and small in dope route-I sample. A comparison between photophysical properties and laser performance of these materials showed a very good correlation.     

Synthesis and characterization of immobilized activated carbon doped TiO2 thin films

Immobilized activated carbon doped TiO₂ thin films were prepared by sol–gel dip coating method by using Titanium IV isopropoxide as a precursor. Aim of our work is to synthesize and investigate the structural, surface morphology and optical properties of the synthesized thin film. X-ray diffraction pattern reveals that the crystallinity of the film increases with increase in temperature. Also, the structural parameters such as particle size, microstrain and dislocation density have been calculated. The formation of nanosphere of diameter ranging from 300 nm to 500 nm has been confirmed by Scanning electron microscope. Photocatalytic active large optical band gap at 3.75 eV was found by using UV–visible sspectrum.     

Synthesis and characterization of nanostructured strontium hexaferrite thin films by the sol–gel method

Nanostructured single phase strontium hexaferrite, SrFe₁₂O₁₉, thin films have been synthesized on the (100) silicon substrate using a spin coating sol–gel process. The thin films with various Fe/Sr molar ratios of 8–12 were calcined at different temperatures from 500 to 900 °C. The composition, microstructure and magnetic properties of the SrFe₁₂O₁₉ thin films were characterized using Fourier transform infrared spectroscopy, differential thermal analysis, thermogravimetry, X-ray diffraction, electron microscopy and vibrating sample magnetometer. The results showed that the optimum molar ratio for Fe/Sr was 10 at which the lowest calcination temperature to obtain the single phase strontium hexaferrite thin film was 800 °C. The magnetic measurements revealed that the sample with Fe/Sr molar ratio of 10, exhibited higher saturation magnetization (267.5 emu/cm³) and coercivity (4290 Oe) in comparison with those synthesized under other Fe/Sr molar ratios.     

Enhancement of electrical properties due to Cr substitution in Co-ferrite nanoparticles synthesized by two chemical techniques

Nanocrystalline cobalt ferrites with nominal composition CoCr_xFe_2−xO₄ ranging from x=0.0 to 0.5 with step increment of 0.25 were prepared by sol–gel auto combustion and chemical co-precipitation techniques. A comparative study of structural, electrical and magnetic properties of these ferrites has been measured using different characterization techniques. Structural and micro-structural studies were measured using X-ray diffraction, Fourier transform infra-red spectroscopy (FTIR), scanning electron microscopy and atomic force microscopy. Crystallite sizes of the series are within the range of 12–29±2 nm. Lattice parameters decrease by increasing Cr³⁺ concentration. FTIR confirms the presence of two lattice absorption bands. DC electrical resistivity increases to a value of ∼10¹⁰ Ω-cm with increase in Cr³⁺ concentration, but the most significant increase is in samples prepared by sol–gel combustion. Dielectric properties have been measured as a function of frequency at room temperature. Dielectric loss decreases to 0.1037 and 0.0108 at 5 MHz for chemical co-precipitation and sol–gel combustion, respectively. Impedance measurements further helped in analyzing the electrical properties and to separate the grain and grain boundary resistance effects using a complex impedance analysis. Magnetic parameters were studied using a vibrating sample magnetometer in the applied field of 10 kOe. The saturation magnetization decreased from 63 to 10.8 emu/gm with increase in Cr³⁺ concentration.     

Investigation of structural and optical properties of ZnO films co-doped with fluorine and indium

Undoped ZnO film and ZnO films, which are co-doped with F and In (FIZO) at different concentrations, were synthesized by sol–gel technique and the effects of co-doping of F and In on structural and optical properties of ZnO thin films were investigated. The concentration ratio of [F]/[Zn] was altered from 0.25 to 1.75 with 0.50 step at.% mole and [In]/[Zn] was altered from 0.25 to 1.00 with 0.25 step at.% mole. X-ray diffraction analysis indicates that the films have polycrystalline nature and the (0 0 2) preferred orientation is the stronger peak. No extra phases involving zinc, fluorine and indium compounds were observed even at high F and In content. The grain size of undoped ZnO and FIZO thin films varied between 15 and 20 nm with a small fluctuation. From the SEM images, although the undoped ZnO had a smooth and particle-shaped surface, FIZO films had nanofiber-networks shapes over the surface with average size of 500 nm. The surface morphologies and crystallite sizes for the F and In doped films were slightly different from than those of undoped film. From the optical study, a slight shrinkage of band gap was backwardly observed from 3.36 to 3.25 eV with the increasing of F and In content.     

Sol–gel synthesis of 8 nm magnetite (Fe3O4) nanoparticles and their magnetic properties

Magnetite (Fe₃O₄) nanoparticles were successfully synthesized by a sol–gel method. The obtained nanoparticles were characterized by X-ray diffraction (XRD), field emission scanning electron microscopy (FE-SEM), energy dispersive analysis by X-ray (EDAX), transmission electron microscopy (TEM), superconducting quantum interference device (SQUID) and Mössbauer spectrometry. XRD and Mössbauer measurements indicate that the obtained nanoparticles are single phase. TEM analysis shows the presence of spherical nanoparticles with homogeneous size distribution of about 8 nm. Room temperature ferromagnetics behavior was confirmed by SQUID measurements. The mechanism of nanoparticles formation and the comparison with recent results are discussed. Finally, the synthesized nanoparticles present a potential candidate for hyperthermia application given their saturation magnetization.     

D3→FJ emission of Tb doped sol–gel silica

Amorphous silica samples doped with 0.1 and 1 mol% of terbium (Tb) were synthesized by the sol–gel method. In addition to the green light associated with ⁵D₄→⁷F_J transitions of Tb³⁺, the sample containing 0.1 mol% also emitted blue light as a result of ⁵D₃→⁷F_J transitions during photoluminescence (PL) measurements. As a result of concentration quenching this blue emission was not observed for the samples doped with the higher concentration (1 mol%). However the blue ⁵D₃ →⁷F_J emission was observed in the 1 mol% doped samples during cathodoluminescence (CL) measurements. Since a rough calculation indicated that the excitation rate in the CL system where the blue emission is observed may be similar to a laser PL system under conditions where the blue emission is not observed, the difference is attributed to the nature of the excitation sources. It is suggested that during the CL excitation incident electrons can reduce non-luminescent Tb⁴⁺ ions in the silica, substituting for Si⁴⁺ ions, to the excited (Tb³⁺)? state and that these are responsible for the blue emission, which does not occur during PL excitation.     

Preparation of Nd-doped BiFeO3 films and their electrical properties

The Nd-doped BiFeO₃ thin films were prepared on SnO₂(FTO) substrates spin-coated by the sol–gel method using Nd(NO₃)₃·6H₂O, Fe(NO₃)₃·9H₂O and Bi(NO₃)₃·5H₂O as raw materials. The microstructure and electric properties of the BiFeO₃ thin films were characterized and tested. The results indicate that the diffraction peak of the Nd-doped BiFeO₃ films is shifted towards right as the doping amounts are increased. The structure is transformed from the rhombohedral to pseudotetragonal phase. The crystal grain is changed from an elliptical to irregular polyhedron. Structure transition occurring in the Bi_0.85Nd_0.15FeO₃ films gives rise to the largest Pr of 64 μC/cm². The leakage conductance of the Nd doped thin films is reduced. The dielectric constant and dielectric loss of Bi_0.85Nd_0.15FeO₃ thin film at 10 kHz are 190 and 0.017 respectively.