分子筛修饰电极的研究（Ⅰ）──氢醌／醌电对在分子筛修饰电极上的电化学行为

考察了中性分子电对Ｈ_２Ｑ／Ｑ在１３Ｘ型分子筛修饰电极上的电化学行为。发现Ｈ_２Ｑ／Ｑ电对在修饰电极上电响应迅速，为双电子可逆反应，不受溶液温度及电极与溶液相对运动的影响，而与溶液的ｐＨ值有关。当ｐＨ≤２．０时，修饰电极对Ｈ_２Ｑ／Ｑ电对的氧化／还原有明显的催化作用．     

钴-5,10,15,20-四(3-甲氧基-4-羟基苯基)卟啉修饰玻碳电极的L-抗坏血酸化学传感器研究

将水合 5,10,15,20-四-(3-甲氧基-4-羟基苯基)钴卟啉(CoTMHPP)修饰在玻碳电极表面,制成CoTMHPP修饰电极.电极稳定性好且灵敏度高,对抗坏血酸有良好的电催化氧化作用,测定线性响应范围为1.0×10(-5)～1.0×10(-2)mol/L,响应时间小于12s.本文研究了电极的性质和应用,并用于药物中抗坏血酸的测定,其测定结果与碘量法一致.     

Feasibility of using solid sampling graphite furnace atomic absorption spectrometry for speciation analysis of volatile and non-volatile compounds of nickel and vanadium in crude oil

A method for the direct determination of volatile and non-volatile nickel and vanadium compounds in crude oil without previous treatment using direct solid sampling graphite furnace atomic absorption spectrometry is proposed. The crude oil samples were weighed directly onto solid sampling platforms using a microbalance and introduced into a transversely heated solid sampling graphite tube. In previous work of our group losses of volatile nickel and vanadium compounds have been detected, whereas other nickel and vanadium compounds were thermally stable up to 1300 and 1600 °C, respectively. In order to avoid this problem different chemical modifiers (conventional and permanent) have been investigated. With 400 μg of iridium as permanent modifier, the signal started to drop already after two atomization cycles, possibly because of an interaction of nickel (which is a catalyst poison) with iridium. Twenty micrograms of palladium applied in each determination was found to be optimum for both elements. The palladium was deposited on the platform and submitted to a drying step at 150 °C for 75 s. After that the sample was added onto the platform and submitted to the furnace program. The influence of sample mass on the linearity of the response and on potential measurement errors was also investigated using four samples with different nickel content. For the sample with the lowest nickel concentration the relationship between mass and integrated absorbance was found to be non-linear when a high sample mass was introduced. It was suspected that the modifier had not covered the entire platform surface, which resulted in analyte losses. This problem could be avoided by using 40 μL of 0.5 g L⁻¹ Pd with 0.05% Triton X-100. Calibration curves were established with and without modifier, with aqueous standards, oil-in-water emulsions and the certified reference material NIST SRM 1634c (trace metals in residual fuel oil). The sensitivity for aqueous standards and emulsions was close to that for SRM 1634c, making possible the use of aqueous standards for calibration. The limits of detection and quantification obtained for nickel and vanadium under this condition were found to be 0.02 and 0.06 μg g⁻¹, respectively, for both elements, based on 10 mg of sample. Nickel and vanadium were determined in the samples with (total Ni and V) and without the use of Pd (thermally stable compounds), and the concentration of volatile compounds was calculated by difference. The results were compared with those obtained by high-resolution continuum source graphite furnace atomic absorption spectrometry by emulsion technique; no significant differences were found for total Ni and V at the 95% confidence level according to a Student's t-test.     

Structural and electrochemical studies of annealed LiNiVO4 thin films

We prepared stoichiometric lithium nickel vanadate amorphous thin films by using r.f. magnetron sputtering under controlled oxygen partial pressure. The amorphous films were heated at various temperatures, 300–600 °C, for 8 h. The as‐deposited and annealed thin films were characterized by Rutherford backscattering spectroscopy, nuclear reaction analysis, Auger electron spectroscopy, X‐ray diffraction, scanning electron microscopy and atomic force microscopy. The electrochemical behavior of the various films was studied by the galvanostatic method. The cells were tested in a liquid electrolyte at room temperature, with lithium metal used as the counter and reference electrode. The best electrochemical storage value was obtained with the thin film annealed at 300 °C, which showed superior capacity and small capacity loss during cycling. Copyright © 2007 John Wiley & Sons, Ltd.     

辣根过氧化物酶活性膜结构及生物电催化性能

通过分子沉积法研究了在聚对苯二甲酸乙二醇酯（PET）表面及金电极表面组装辣根过氧化物酶（HRP）/聚对苯乙烯磺酸钠（PSS）多层生物活性膜，用原子力显微镜(AFM)研究了组装膜的表面形貌，并研究了组装膜的形貌、粗糙度和活性关系.应用循环伏安法（CV）研究了组装HRP膜后电极对H2O2的电化学催化还原作用.实验发现，采用亚甲基蓝（MB）溶液为介质，在H2O2浓度为0.2～5.0 mmol•L－1时，其响应电流对H2O2浓度变化基本呈线性.     

聚合物-Ni(II)膜电极的研究

Ni(Ⅱ)离子可与聚8羟基喹啉、聚邻氨基酚、聚邻苯二胺和聚苯胺络合。聚合物-Ni(Ⅱ)膜电极的循环伏安图有明显的氧化还原蜂, 和彼此相似的电化学特性。聚8羟基喹啉膜(聚邻氨基酚, 聚邻苯二胺)可用以交换Ni(Ⅱ)与H~+离子和分离Ni(Ⅱ)、Co(Ⅱ)和Fe(Ⅱ)离子。     

Bridged bis-pyridinylimino dinickel(II) complexes: Syntheses, characterization, ethylene oligomerization and polymerization

A series of bridged bis(pyridinylimino) ligands were efficiently synthesized through the condensation reaction of 4,4′-methylene-bis(2,6-disubstituted aniline) with 2-pyridinecarboxaldehyde or 2-benzoylpyridine. They reacted with (DME)NiBr₂ to form dinuclear Ni(II) complexes. All resultant compounds were characterized by elemental analysis, IR spectra as well as the single-crystal X-ray diffraction to confirm the structures of ligands and complexes. Activated with methylaluminoxane (MAO), these nickel complexes showed considerably good activities for ethylene oligomerization and polymerization. Their catalytic activities and the properties of PEs obtained were depended on the arched environment of ligand and reaction conditions.     

碘离子选择电极在动力学分析中的应用 Ⅰ.催化电势动力学测锆法研究

本文报道采用碘离子选择电极,系统研究了锆于BO_3~--I~-反应中的定量催化特性,建立了催化电势动力学间接测痕量锆的方法。结果表明,本法专属性较高,55种阴、阳离子均不干扰测锆。     

Vapor pressure,speciation, and chemical activities in highly concentrated sodium borate solutions at 277 and 317°C

The system H₂O-B₂O₃-Na₂O has been studied experimentally at 277 and 317°C. The activities of water and boric acid have been determined at mole ratios Na/B from 0 to 1.5, and total dissolved solids 3 to 80 weight percent. The activity of boric acid has been fitted to within experimental error using a speciation model with eight complex species. This model is consistent with the model previously published by Mesmer et al. The electrolyte properties of the liquid are modeled using the Pitzer-Simonson model of very concentrated electrolyte solutions. The calculated values of water activity agree with experiment, and the activity of NaOH and pOH have also been calculated. The potassium borate system also was briefly studied at 317°C, and is adequately described by a model with five complex species. The potassium borate liquid is more alkaline at K/B= 1 than a sodium borate liquid at the same mole ratio, but pOH in the two systems is the same at lower mole ratios.     

Temperature programmed reduction of silica supported nickel catalysts

Nickel oxide promoted catalysts are prepared by simple precipitation, precipitation from homogeneous solution and impregnation methods and their reduction behavior is monitored with temperature programmed reduction (TPR) technique. The effect of different parameters such as metal loading, method of preparation and heat treatment temperature are also observed on the reducibility of the catalysts. It is observed that reduction temperature increases with the increase of calcination temperature. Results indicate that the interactions between nickel oxide and silica begin with the increase of calcination temperature which leads to the formation of nickel hydrosilicates and are responsible for high temperature reduction peaks.