Characteristic of a broadband Ti:LiNbO3 optical modulator with buried electrodes and etched grooves in the buffer layer

Traveling wave Ti:LiNbO₃ Mach-Zehnder optical modulators with buried electrodes and etched grooves in the SiO₂ buffer layer are analyzed by the finite element method. The tradeoff between the bandwidth BW and the half-wave voltage Vπ is discussed. The value of BW/Vπ is used to weight the total performance of the modulator. Taking a thick buffer layer and etching deep grooves in the buffer layer are demonstrated as two effective methods to improve the performance of the modulator. A 3-dB optical bandwidth of 18 GHz with half-wave voltage 5V at a wavelength of 1.55 pm could be obtained even though the electrode is not very thick. When the requirement of half-wave voltage is not very critical, a bandwidth of more than 100 GHz can be obtained.     

Contributions to the synthesis of some ferrocene-containing antibiotics

This Review discusses the synthesis and characterization by our Group of new antibiotics belonging to the class of penicillins, cephalosporins and rifamycins with ferrocenyl and 1, 1′-ferrocenilene residues in the molecule. As reactants for 6-aminopenicillanic acid (6-APA) and 7-aminocephalosporanic acid (7-ACA) the following were used: 1, 1-bis(chlorocarbonyl)ferrocene, ferrocenyl sulfochloride, 1, 1′-ferrocenylenedisulfochloride and thioglycolic acids S-modified with ferrocene. In the synthesis of rifamycins, the hydrazides of the thioglycolic acids, S-modified with ferrocene, were employed as nucleophilic agents. The synthesized intermediates were characterized by elemental analysis, TLC, IR, UV and ¹H NMR spectra. The characterization of new antibiotics was made by TLC, IR and UV spectral analysis. Biological activity was tested on Gram-negative and Gram-positive bacteria. Good activity is reported towards Gram-positive bacteria in the case of derivatives containing residues of thioglycolic acid S-modified with ferrocene, the antibacterial activity being similar to that of amoxicillin, carbenicillin and cephalothin. All compounds are inactive towards Gram-negative bacteria.     

用激活性非线性介质Nd：MgO：LiNbO3产生二次谐波

以Nd:MgO:LiNbO_3同时兼作激活介质和非线性光学材料,研究自倍频激光器。用小型氙灯泵浦,在室温下获得二次谐波激光(0.547μm) 阈值小于4.8'J,最大输出400μJ/shot,工作温度范围大于20℃～45℃,无光损伤。     

微微秒自动调谐参量激光的研究

采用一对MgO:LiNbO_3角度调谐覆盖了红近外波段0.7～2.2μm,并配以自动波长扫描。文中分析了影响脉冲宽度与线宽的因素,与实验结果相吻合。脉宽<30ps,线宽～1nm(简并波长附近～10nm),单脉冲峰功率达MW级,参量光总能量转换效率达5.4％。     

停流—荧光动力学分析法测定痕量钛的研究

利用自行组装的停流-荧光动力学分析仪,采用停流法汇合流体动力注入技术,研究了钛与3.5-二溴水杨基荧光酮的荧光增强动力学反应性质,讨论了流速、进样时间对方法灵敏度和精密度的影响,提出了一个快速、简便、精确测定钛的分析方法,并用于稀土样品及合成样品中痕量钛的测定.方法检测限为8×10~(-3)ppm,大多数元素的干扰均可用动力学方法消除.     

纳米WO3的制备及其光解水析氧性能研究

用溶胶凝胶法,灼烧法合成了纳米级WO3,采用X-射线衍射、紫外可见漫反射光谱对WO3进行表征.在Fe3 为电子受体、溶液酸度pH为2.0情况下,研究了纳米级WO3在365nm紫外辐射下光解水析氧的光催化活性,并讨论了不同方法制备的催化剂活性差异的原因.结果表明,结晶程度越高、尺寸越小、比表面积越大的纳米级WO3具有更高的光分解水析氧活性,电子受体的浓度、溶液的酸度对析氧活性有明显的影响.     

Recycling in telomerization of butadiene with D‐xylose: Pd(TPPTS)n‐KF/Al2O3 as an active catalyst

A palladium‐TPPTS catalyst heterogenized on KF/alumina has been shown to be effective and recyclable for the selective formation of monooctadienylxylopyranosides via the telomerization of butadiene with D ‐xylose. Copyright © 2007 John Wiley & Sons, Ltd.