多孔硅的电化学制备

单晶硅在氢氟酸溶液中阳极氧化可制得多孔硅, 多孔硅是一种以新形态存在的硅, 与单晶硅相比, 它表现出独特的物理性质和化学活性。荧光光谱峰的蓝移表明, 在p-型低掺杂衬底硅上形成的多孔硅中存在量子尺寸效应, 新近获得的Raman光谱也证实了这一点。     

石英晶体微天平技术研究纳米TiO_2表面Cu(Ⅱ)吸附与光化学还原过程

环境中排放的重金属离子Cu!对水生和陆生生物有强的毒害性。饮用水中Cu!的浓度高于1.0mg·L-1时,将会导致人畜得血色沉着病和胃肠粘膜病[1]。Cu!无法进行生物降解,除去废水中Cu!的常见方法有离子交换、置换、化学沉淀等[2],然而这些方法需要消耗大量的化学试剂,成本高。近来,研     

Mass spectrometric analysis of low molecular mass polyesters by laser desorption/ionization on porous silicon

A low molecular mass polyester was analyzed by desorption/ionization on porous silicon (DIOS) mass spectrometry. The results were compared with those of matrix-assisted laser desorption ionization (MALDI) mass spectrometry using matrixes of alpha-cyano-4-hydroxycinnamic acid (CHCA) and 10,15,20-tetrakis(pentafluorophenyl)porphyrin (F20TPP). The CHCA matrix was not suitable for characterization of low molecular mass components of the polyester because the matrix-related ions interfered with the component ions. On the other hand, the F20TPP matrix showed no interference because no matrix-related ions appeared below m/z 822. However, the solvent selection for determining optimal conditions of sample preparation was limited, because F20TPP does not dissolve readily in any of the available organic solvents. In the DIOS spectra, the polymer ions were observed at high sensitivity without a contaminating ion. No matrix is needed for DIOS spectra of low molecular mass polyesters, facilitating sample preparation and selectivity of a precursor ion in post-source decay measurements.     

二氧化碳与丙烯直接合成甲基丙烯酸用CuPMo／TiO2催化剂的研究

 用溶胶－凝胶法以磷钼酸（MPA）的铜盐溶液水解钛酸四丁酯制备了CuPMo／TiO2催化剂，并用ICP，XRD，TG－DTA，IR，TPD－MS和微反技术研究了催化剂的化学组成、热稳定性、化学吸附性质和催化性能．结果表明：杂多钼酸盐与TiO2表面通过O2－桥发生键联．在623K下，杂多阴离子仍保持其原有的Keggin结构；CO2在Lewis酸位Cu（Ⅱ）和Lewis碱位Cu－O－Mo桥氧的协同作用下形成卧式吸附态Cu（Ⅱ）←O－（CO）←（O－－Cu）；丙烯以分子吸附态在催化剂上吸附；在空速1500h－1，压力1MPa和温度563K的反应条件下，丙烯的转化率为4．2％，甲基丙烯酸的选择性为96％．     

Influence of the conditions of manufacture of nanomeric zirconium dioxide,stabilized with yttrium oxide,on its catalytic properties in the oxidation of CO

The morphological and catalytic properties of samples of nanomeric zirconium dioxide, stabilized with yttrium oxide, manufactured via the effect of a UHF field during the process of drying precipitated zirconium hydroxide and calcination at temperatures from 300 to 1000 °C, were studied. It was shown that the highest activity in the oxidation of CO occurred with 40 nm particles of zirconium dioxide prepared at 1000 °C. __________ Translated from Teoreticheskaya i éksperimental’naya Khimiya, Vol. 43, No. 2, pp. 96–101, March–April, 2007.     

The gas phase reaction between CO2 and lanthanide atoms. A test of a model for the isokinetic effect

Summary Co₃O₄, NiCo₂O₄ and LaCo₂O₄catalysts were synthesizedby the citric acid-ligated method. These catalysts containing Co-oxide active components can largely lower the temperature of soot combustion under tight contact conditions. Under the conditions of loose contact NiCo₂O₄ cannot promote soot combustion, but LaCo₂O₄ can effectively promote soot combustion because the nanometric perovskite-type catalyst LaCoO₃produced in the LaCo₂O₄sample.</o:p>     

二氧化碳氧化剂在烷烃催化转化反应中的应用研究进展

本文综述了近年来国内外有关利用二氧化碳作为氧化剂在烷烃催化转化反应中的研究状况。担载型的金属氧化物催化剂具有较好的催化活性。催化剂表面碱性位的存在可稳定活性中心并且有利于CO2的活化，CO2的作用是与烷烃脱氢产物H2和生成的表面积炭反应，从而提高反应活性及催化剂的稳定性。     

XPS,AFM, ATR and TPD evidence for terraced,dihydrogen terminated, 1×1 (100) silicon

Heating (100) silicon at high temperature (say, higher than 850 °C) in H₂, cooling to 670–700 °C in the same ambient, and quenching to room temperature in N₂ results in environmentally robust, terraced 1 × 1 (100) SiH₂. Evidence for this conclusion is based on angle‐resolved x‐ray photoelectron spectroscopy, atomic force microscopy, infrared absorption spectroscopy in the attenuated total reflection mode, thermal programmed desorption, and reflection high‐energy electron diffraction. Copyright © 2005 John Wiley & Sons, Ltd.     

用碘酸钾滴定法标定二氧化硫标准溶液

用KIO3滴定法标定SO2标准溶液,RSD≈0.10%,标定结果与标准法结果无显著性差异,相对误差<±0.3%。