水中酚的膜萃取分离流动注射技术测定的研究

本文提出了硅橡胶膜在线萃取分离流动注射技术测定水样中苯酚的方法。由于水样中的苯酚透过硅橡胶进入萃取液的萃取量随时间的增加和温度的升高而增大，故采用停流技术及升高温度以降低酚的检出限。     

功能液晶膜的新进展

论述了功能液晶膜的新近研究结果和发展动向,指出功能液晶膜具有优异的气体分离、液体分离和电光性能,可望作为高效气体分离膜、高效液体分离膜和大面积光控膜,具有较重大的理论与实际意义。     

Mass transfer and benzene removal from air using latex rubber tubing and a hollow-fiber membrane module

A dense-phase latex rubber tube and a polyporous propylene hollow-fiber membrane module (HFMM) were investigated for control of benzene-contaminated gas streams. The abiotic mass flux observed through the latex tube was 3.9–13 mg/(min·m²) for 150 ppm of benzene at various gas and liquid flow rates, while a 100-fold lower mass flux was observed in the HFMM. After seeding with an aromatic-degrading culture enriched from activated sludge, the observed removal was 80% of 150 ppm, corresponding toa mass flux of 45 mg/(min·m²). The observed mass flux through the HFMM during biofiltration also rose, to 0.4 mg/(min·m²). Because the HFMM had a 50-fold higher surface area than the latex tube, the observed ben zene removal was 99.8%. Compared to conventional biofilters, the two reactors had modest elimination capacities, 2.5–18 g/(m³·h) in the latex tube membrane bioreactor and 4.8–58 g/(m³·h) in the HFMM. Although the HFMM had a higher elimination capacity, the gas-phase pressure drop was much greater.     

Electrochemical Preparation of Poly(Malachite Green) Film Modified Nafion‐Coated Glassy Carbon Electrode and Its Electrocatalytic Behavior Towards NADH,Dopamine and Ascorbic Acid

Poly(malachite green) film modified Nafion‐coated glassy carbon electrodes have been prepared by potentiodynamic cycling in malachite green solution. The pH of polymerisation solution has only minor effect on film formation. Electrochemical quartz crystal microbalance (EQCM) was used to monitor the growth of the poly(malachite green) film. Cyclic voltammogram of the poly(malachite green) film shows a redox couple with well‐defined peaks. The redox response of the modified electrode was found to be depending on the pH of the contacting solution. The peak potentials were shifted to a less positive region with increasing pH and the dependence of the peak potential was found to be 56 mV per pH unit. The electrocatalytic behavior of poly(malachite green) film modified Nafion‐coated glassy carbon electrodes was tested towards oxidation of NADH, dopamine, and ascorbic acid. The oxidation of dopamine and ascorbic acid occurred at less positive potential on poly(malachite green) film compared to bare glassy carbon electrode. In the case of NADH, the overpotential was reduced substantially on modified electrode. Finally, the feasibility of utilizing poly(malachite green) film electrode in analytical estimation of ascorbic acid was demonstrated in flow injection analysis.     

Novel Membrane Potentiometric Thiocyanate Sensor Based on Tribenzyltin(IV) Dithiocarbamate

A novel PVC membrane ion‐selective electrode based on tribenzyltin(IV) dithiocarbamate [Sn(IV)–TBDTB] as neutral carrier was developed for thiocyanate (SCN^?) determination. The electrode exhibits a near‐Nernstian response for SCN^? with a slope of 62.8±2.0 mV per decade over a wide concentration range 1.0×10^?1–2.0×10^?6 mol L^?1 and a detection limit of 1.0×10^?6 mol L^?1 in MES–NaOH buffer, pH 6.0, at 25 °C. The electrode prepared with 1.5 wt.% Sn(IV)–TBDTB, 32.5 wt.% PVC and 66.0 wt.% 2‐nitrophenyloctyl ether (o‐NPOE) shows optimal response characteristics. Anti‐Hofmeister selectivity sequence for a series of anions shown by the electrode was as follows: SCN^?>Sal^?>I^?>ClO >phCOO^?>CH₃COO^?>Br^?>Cl^?>NO >NO >Citrate>SO₄^2?. The useful pH range for the electrode was found to be 3–7 with a response time 30–40 s. The electrode has been used for direct determination of thiocyanate in wastewater with satisfactory results.     

高硅ZSM—5沸石填充硅橡胶膜的醇—水渗透蒸发分离性质

高硅ZSM－5沸石填充疏水性硅橡胶蓦地低浓度醇－水体度醇－水体的渗透蒸发性质的研究有明，提高沸石硅铝比，增加填充量以及进行酸处理皆有利于改善膜对醇－水的分离系数和通量。料液的成，浓度以及温度对膜的分离性质也有显著影响。     

Integrated Microanalytical System Coupling Permeation Liquid Membrane and Voltammetry for Trace Metal Speciation. Technical Description and Optimization

A new minicell coupling the liquid‐liquid extraction technique called permeation liquid membrane (PLM) with an integrated Ir‐based Hg‐plated microelectrode array for voltammetric detection has been developed for the speciation of heavy metals in natural waters. Lead and cadmium have been used as model compounds. The PLM consists of a carrier (0.1 M 22DD+0.1 M lauric acid) dissolved in 1 : 1 mixture of toluene/phenylhexane held in the small pores (30 nm) of a hydrophobic polypropylene membrane (Celgard 2500). One side of this membrane is in contact with a flowing source solution, containing the metal ions of interest. An acceptor or strip solution (pyrophosphate) is placed on the other side of the PLM with the microelectrode array placed at 480 μm of the PLM. The analyte is transported by the carrier from the source solution to the strip solution. The originality of the new minicell is that accumulation in the strip solution is voltammetrically followed by the integrated microelectrode array in real time, and at low concentration level, using square‐wave anodic stripping voltammetry (SWASV). In order to protect the Hg microelectrodes from the adsorption of the hydrophobic carrier, the microelectrodes are embedded in a thin gel layer (280 μm) of 1.5% LGL agarose gel containing 10% of hydrophobic silica particles C18. The choice of optimum conditions is discussed in details in this article. Due to the very small effective strip volume of the new cell (less than 1 μL), high enrichment factor can be obtained (e.g., 330 for Pb) after 2 hours of accumulation. No deaeration of the solutions is required for SWASV measurements. Detection limits under these conditions are 2 pM and 75 pM for Pb and Cd, respectively, using a voltammetric deposition time of 5 min. In addition, no fouling effects were observed with natural water samples.     

肝素化壳聚糖季铵盐／壳聚糖复合膜抗凝血性能的研究

以壳聚糖季铵盐，壳聚糖为基本原材料，选用戊二醛为交剂剂及固定剂，制备一种物理机械性能较优的抗凝血材料。探讨了戊二醛及肝素钠两者用量对肝素化程度及血液生的影响。     

Review of time lag permeation technique as a method for characterisation of porous media and membranes

The time lag permeation technique has proven to bean effective method for characterisation. Because of the simple nature of the permeation experiment, transport parameters can be directly obtained from experimental data hence avoiding the intensive mathematical treatment required by other techniques. The method has historically been applied to diffusion and adsorption in porous membranes and diffusion in polymer membranes. Since its origins in 1920, interest in the time lag method has expanded because of its value in characterising simple permeation processes and also complex systems of diffusion with simultaneous adsorption and surface diffusion. This review focuses on presenting the asymptotic solution of the mass balance diffusion equations and includes applications of time lag analysis, in order to give a critical and broad perspective of this method as a tool for characterisation. It includes much of the previously published literature in order to show that for most cases the asymptotic solution of the transport equations is simple, and for more complex cases that an analytical solution is possible hence avoiding cumbersome numerical techniques.     

Tetrachloroferrate(III)-selective liquid membrane electrode based on crystal violet

An extract of crystal violet-tetrachloroferrate(III) in nitrobenzene was used to prepare a tetrachloroferrate(III)-selective liquid membrane electrode with a poly(vinyl chloride) support. The optimal conditions to determine 2.5 × 10^–5 – 5.0 × 10^–2 M iron(III) as tetrachloroferrate(III) (anionic slope 56 mV/decade, detection limit 7.9 × 10^–6 M) were found to be 4.0–5.5.M total chloride in 0.75–1.5M hydrochloric acid. The electrode was reliably applied to determine iron in human blood, haematite and mineralized vitamin syrup by direct potentiometry, standard and sample additions as well as standard subtraction techniques.