溶剂浓度对PVDF相转换膜大孔结构的影响

提出决定大孔能否发展的初始分相点处溶剂浓度临界点的概念 ,认为初始分相点处较高的溶剂浓度有利于大孔的发展 ,溶剂浓度低于一定的界限后 ,大孔停止发展 ,转为海绵状结构 .实验考察了不同凝胶液组成下制得的PVDF中空膜的结构 ,建立了相应的传质模型 ,模拟不同制膜条件下初生态膜内的组成分布情况 ,根据初始分相点处溶剂浓度临界点的概念 ,预测膜的形态结构 .模拟结果与相应制膜条件下的电镜照片有很好的对应关系 ,证明了上述大孔形成机理的正确性 .     

MORPHOLOGIES AND GAS SEPARATION PROPERTIES OF MELT-SPUN ASYMMETRIC POLY(4-METHYL-1-PENTENE)HOLLOW FIBER MEMBRANES*

Poly(4-methyl-1-pentene) (PMP) hollow fiber membranes were prepared by the melt-spun and cold-stretch(MSCS) method. Scanning electronic microscopy (SEM) was used to characterize the section and surface structures of themembranes with special asymmetric structure. The preliminary results of gas permeation measurements indicated that the resultant hollow fiber membranes have the potential ability for oxygen/nitrogen separation.     

水中酚的膜萃取分离流动注射技术测定的研究

本文提出了硅橡胶膜在线萃取分离流动注射技术测定水样中苯酚的方法。由于水样中的苯酚透过硅橡胶进入萃取液的萃取量随时间的增加和温度的升高而增大，故采用停流技术及升高温度以降低酚的检出限。     

Electrochemical Preparation of Poly(Malachite Green) Film Modified Nafion‐Coated Glassy Carbon Electrode and Its Electrocatalytic Behavior Towards NADH,Dopamine and Ascorbic Acid

Poly(malachite green) film modified Nafion‐coated glassy carbon electrodes have been prepared by potentiodynamic cycling in malachite green solution. The pH of polymerisation solution has only minor effect on film formation. Electrochemical quartz crystal microbalance (EQCM) was used to monitor the growth of the poly(malachite green) film. Cyclic voltammogram of the poly(malachite green) film shows a redox couple with well‐defined peaks. The redox response of the modified electrode was found to be depending on the pH of the contacting solution. The peak potentials were shifted to a less positive region with increasing pH and the dependence of the peak potential was found to be 56 mV per pH unit. The electrocatalytic behavior of poly(malachite green) film modified Nafion‐coated glassy carbon electrodes was tested towards oxidation of NADH, dopamine, and ascorbic acid. The oxidation of dopamine and ascorbic acid occurred at less positive potential on poly(malachite green) film compared to bare glassy carbon electrode. In the case of NADH, the overpotential was reduced substantially on modified electrode. Finally, the feasibility of utilizing poly(malachite green) film electrode in analytical estimation of ascorbic acid was demonstrated in flow injection analysis.     

Novel Membrane Potentiometric Thiocyanate Sensor Based on Tribenzyltin(IV) Dithiocarbamate

A novel PVC membrane ion‐selective electrode based on tribenzyltin(IV) dithiocarbamate [Sn(IV)–TBDTB] as neutral carrier was developed for thiocyanate (SCN^?) determination. The electrode exhibits a near‐Nernstian response for SCN^? with a slope of 62.8±2.0 mV per decade over a wide concentration range 1.0×10^?1–2.0×10^?6 mol L^?1 and a detection limit of 1.0×10^?6 mol L^?1 in MES–NaOH buffer, pH 6.0, at 25 °C. The electrode prepared with 1.5 wt.% Sn(IV)–TBDTB, 32.5 wt.% PVC and 66.0 wt.% 2‐nitrophenyloctyl ether (o‐NPOE) shows optimal response characteristics. Anti‐Hofmeister selectivity sequence for a series of anions shown by the electrode was as follows: SCN^?>Sal^?>I^?>ClO >phCOO^?>CH₃COO^?>Br^?>Cl^?>NO >NO >Citrate>SO₄^2?. The useful pH range for the electrode was found to be 3–7 with a response time 30–40 s. The electrode has been used for direct determination of thiocyanate in wastewater with satisfactory results.     

Integrated Microanalytical System Coupling Permeation Liquid Membrane and Voltammetry for Trace Metal Speciation. Technical Description and Optimization

A new minicell coupling the liquid‐liquid extraction technique called permeation liquid membrane (PLM) with an integrated Ir‐based Hg‐plated microelectrode array for voltammetric detection has been developed for the speciation of heavy metals in natural waters. Lead and cadmium have been used as model compounds. The PLM consists of a carrier (0.1 M 22DD+0.1 M lauric acid) dissolved in 1 : 1 mixture of toluene/phenylhexane held in the small pores (30 nm) of a hydrophobic polypropylene membrane (Celgard 2500). One side of this membrane is in contact with a flowing source solution, containing the metal ions of interest. An acceptor or strip solution (pyrophosphate) is placed on the other side of the PLM with the microelectrode array placed at 480 μm of the PLM. The analyte is transported by the carrier from the source solution to the strip solution. The originality of the new minicell is that accumulation in the strip solution is voltammetrically followed by the integrated microelectrode array in real time, and at low concentration level, using square‐wave anodic stripping voltammetry (SWASV). In order to protect the Hg microelectrodes from the adsorption of the hydrophobic carrier, the microelectrodes are embedded in a thin gel layer (280 μm) of 1.5% LGL agarose gel containing 10% of hydrophobic silica particles C18. The choice of optimum conditions is discussed in details in this article. Due to the very small effective strip volume of the new cell (less than 1 μL), high enrichment factor can be obtained (e.g., 330 for Pb) after 2 hours of accumulation. No deaeration of the solutions is required for SWASV measurements. Detection limits under these conditions are 2 pM and 75 pM for Pb and Cd, respectively, using a voltammetric deposition time of 5 min. In addition, no fouling effects were observed with natural water samples.     

Review of time lag permeation technique as a method for characterisation of porous media and membranes

The time lag permeation technique has proven to bean effective method for characterisation. Because of the simple nature of the permeation experiment, transport parameters can be directly obtained from experimental data hence avoiding the intensive mathematical treatment required by other techniques. The method has historically been applied to diffusion and adsorption in porous membranes and diffusion in polymer membranes. Since its origins in 1920, interest in the time lag method has expanded because of its value in characterising simple permeation processes and also complex systems of diffusion with simultaneous adsorption and surface diffusion. This review focuses on presenting the asymptotic solution of the mass balance diffusion equations and includes applications of time lag analysis, in order to give a critical and broad perspective of this method as a tool for characterisation. It includes much of the previously published literature in order to show that for most cases the asymptotic solution of the transport equations is simple, and for more complex cases that an analytical solution is possible hence avoiding cumbersome numerical techniques.     

Tetrachloroferrate(III)-selective liquid membrane electrode based on crystal violet

An extract of crystal violet-tetrachloroferrate(III) in nitrobenzene was used to prepare a tetrachloroferrate(III)-selective liquid membrane electrode with a poly(vinyl chloride) support. The optimal conditions to determine 2.5 × 10^–5 – 5.0 × 10^–2 M iron(III) as tetrachloroferrate(III) (anionic slope 56 mV/decade, detection limit 7.9 × 10^–6 M) were found to be 4.0–5.5.M total chloride in 0.75–1.5M hydrochloric acid. The electrode was reliably applied to determine iron in human blood, haematite and mineralized vitamin syrup by direct potentiometry, standard and sample additions as well as standard subtraction techniques.     

液膜法分离钒(Ⅳ)的研究

本文用P204-兰113A-煤油组成的滤膜体系处理钒(Ⅳ)的溶液,并考察了表面活性剂、载体、外相pH值、内相酸度、起始钒(Ⅳ)浓度以及乳水比等因素对分离的影响。