Structure and mechanical properties of Al/AlN multilayer with different AlN layer thickness

Nanometer scale Al/AlN multilayers have been prepared by dc magnetron sputtering technique with a columnar target. A set of Al/AlN multilayers with the Al layer thickness of 2.9 nm and the AlN layer thickness variation from 1.13 to 6.81 nm were determined. Low angle X-ray diffraction (LAXRD) was used to analyze the layered structure of multilayers. The phase structure of the coatings was investigated with grazing angle XRD (GAXRD). Mechanical properties of these multilayers were thoroughly studied using a nanoindentation and ball-on-disk micro-tribometer. It was found that the multilayer hardness and reduced modulus showed no strong dependence on the AlN layer thickness. Al2.9 nm/AlN1.13 nm multilayer had more excellent tribological properties than single layers and other proportion multilayers with a lowest friction coefficient of 0.15. And the tribological properties of all the multilayers are superior to the AlN single layer.     

LiNbO3∶Cr∶Cu晶体吸收特性及非挥发全息存储研究

研究了LiNbO3∶Cr∶Cu晶体的吸收特性,发现LiNbO3∶Cr∶Cu（含0.14 wt.% Cr2O3 和 0.011 wt.% CuO）晶体存在两个明显的吸收峰,中心波长分别位于480 nm和660 nm; 随着Cr的含量逐渐减小,Cu的含量逐渐增大,短波段不存在明显吸收峰,掺Cr的含量越大,中心波长在660 nm处的吸收越大；633 nm红光虽然位于中心波长为660 nm的吸收峰内,但它无助于光折变过程.分别采用390 nm紫外光和488 nm蓝光作为敏化光,514 nm绿光作为记录光的记录方案,实现了非挥发全息记录,掺入适量的Cr( 比如NCr=2.795×1025 m－3,NCr/ NCu=1)有助于全息记录性能的提高.     

Study of the structural and optical properties of GaN/AlN quantum dot superlattices

We study GaN/AlN Quantum Dot (QD) superlattices utilizing the STREL environment which allows the building of atomistic models, relaxation of the structures, the calculation of the electronic states and optical transitions and the visualization of the results. The forces are calculated using an appropriate Keating or Stillinger–Weber interatomic potential model and the electronic states and optical transitions using a tight-binding formulation which is economical and produces realistic electronic properties. The relaxed structure has strains mainly in the GaN region which are compressive and small tensile strains in the AlN region, mainly below the QD. In the calculation of the electronic states and of the optical transitions the strains are included realistically at the atomistic level. The study of the wavefunctions close to the fundamental gap show how these strains influence the form and spatial extent of the wavefunction. Very close to the fundamental gap the valence and some conduction states are confined in the QD and have considerable oscillator strength.     

Adhesion studies of latex film surfaces on the meso- and nanoscale

In this paper the effects of surface roughness and annealing temperature (T) of latex coating films on adhesion are discussed for the different stages of the film formation process. The surface free energy of latex films was assessed in terms of practical work of adhesion (W) (or adherence) using a custom-built adhesion-testing device (ATD), atomic force microscopy (AFM), and contact angle measurements. For preannealed latex films surface roughness averages (R_a) were determined from AFM height images and were related to the values of W obtained from ATD measurements at room temperature. The results obtained using these tests exhibiting surface behavior on different length scales indicate a dependence of the measured adhesion on surface roughness and temperature, as well as on the length scale of the measurements.First preannealed samples were studied, which were obtained by heat treatment above the respective glass transition temperatures (T_g). Increasing the temperature of preannealing resulted in a decrease of the adherence observed in ATD experiments at room temperature. However, on the nanoscale, using AFM, no significant variation of the adherence was observed. This observation can be explained by roughness arguments. Preannealing decreases roughness which results in lower adherence values measured by ATD while for essentially single asperity AFM experiments roughness has an insignificant effect. Specimens were also annealed over a constant period of time (90 min) at different temperatures. At the end of the heat treatment, adhesion was measured at the treatment temperature by ATD. The amplified effect of temperature observed in this case on adherence is attributed to the combination of roughness decrease and increasing test temperature. In a third set of experiments completely annealed samples were studied by ATD as well as by AFM as a function of temperature. With increasing T values ATD showed a decrease in adherence, which is attributed to a decreasing surface free energy of the annealed films at elevated T values. AFM, on the other hand, showed an opposite trend which is assigned to increasing penetration of the tip into the tip/wetting polymer samples versus increasing temperature. Finally, annealing isotherms as a function of time were investigated by ATD in situ at different temperatures. This last set of experiments allowed us to optimize annealing time and temperature to achieve complete curing.     

AlGaN/GaN HEMTs grown on silicon (001) substrates by molecular beam epitaxy

We report the realization of an AlGaN/GaN HEMT on silicon (001) substrate with noticeably better transport and electrical characteristics than previously reported. The heterostructure has been grown by molecular beam epitaxy. The 2D electron gas formed at the AlGaN/GaN interface exhibits a sheet carrier density of 8×10¹² cm⁻² and a Hall mobility of 1800 cm²/V s at room temperature. High electron mobility transistors with a gate length of 4 μm have been processed and DC characteristics have been achieved. A maximum drain current of more than 500 mA/mm and a transconductance g_m of 120 mS/mm have been obtained. These results are promising and open the way for making efficient AlGaN/GaN HEMT devices on Si(001).     

乳液聚合阶段Ⅱ动力学研究的进展

本文简述了乳浓聚合动力学研究的进展,着重于澳大利亚Sydney大学Gilbert等在乳液聚合阶段Ⅱ动力学方面的研究概况。介绍了不同水溶性单体的小尺寸种子乳液体系的SmithEwart递推方程的求解方法及其解析解形式和乳液聚合动力学数据的处理。同时讨论了该研究的局限性。     

Adaptive application of operators in standard representation

Recently adaptive wavelet methods have been developed which can be shown to exhibit an asymptotically optimal accuracy/work balance for a wide class of variational problems including classical elliptic boundary value problems, boundary integral equations as well as certain classes of noncoercive problems such as saddle point problems. A core ingredient of these schemes is the approximate application of the involved operators in standard wavelet representation. Optimal computational complexity could be shown under the assumption that the entries in properly compressed standard representations are known or computable in average at unit cost. In this paper we propose concrete computational strategies and show under which circumstances this assumption is justified in the context of elliptic boundary value problems. Dedicated to Charles A. Micchelli on the occasion of his 60th birthday Mathematics subject classifications (2000) 41A25, 41A46, 65F99, 65N12, 65N55. This work has been supported in part by the Deutsche Forschungsgemeinschaft SFB 401, the first and third author are supported in part by the European Community's Human Potential Programme under contract HPRN-CT-202-00286 (BREAKING COMPLEXITY). The second author acknowledges the financial support provided through the European Union's Human Potential Programme, under contract HPRN-CT-2002-00285 (HASSIP) and through DFG grant DA 360/4–1.     

Deposition of Au/TiO2 film by pulsed laser

Au nanoparticles, which were photoreduced by a Nd:YAG laser in HAuCl₄ solution containing TiO₂ colloid and accompanied by the TiO₂ particles, were deposited on the substrate surface. The film consisting of Au/TiO₂ particles was characterized by the absorption spectra, scanning electron microscopy (SEM) and X-ray diffraction (XRD) analysis. The adhesion between the film and substrate was evaluated by using adhesive tape test. It was found that the presence of TiO₂ dramatically enhanced the adhesion strength between the film and the substrate, as well as the deposition rate of film. The mechanism for the deposition of Au/TiO₂ film was also discussed.     

s波超导体绝缘层dx2-y2波超导体结的直流Josephson电流

在s波超导体绝缘层dx2-y2波超导体结(sId)中,考虑到结界面粗糙散射,运用BogoliubovdeGennes(BdG)方程和FurusakiTsukada(FT)电流公式,计算超导结中的准粒子传输系数和直流Josephson电流.结果表明:sId超导结的直流Josephson电流随温度以及结两侧的相位差变化的关系曲线强烈地依赖于d波超导体的晶轴方位;结界面的粗糙散射对Josephson电流有抑制作用 关键词： s/I/d超导结 dx2-y2波超导体 直流Josephson电流     

离子辐照引起的金属／绝缘体界面混合与相变研究

载能离子穿过固体界面引起界面原子迁移使界面原子混合和物质成分变化，从而导致界面发生材料相变。简要介绍了载能离子辐照引起金属／绝缘体界面混合效应及相变现象的主要实验研究进展、低能离子和高能离子辐照引起金属／绝缘体界面现象差异，并对离子辐照引起界面混合及相变的机制进行了初步探讨。When penetrating an interface between two kind of solids, energetic ions can induce atomic diffusion at both sides of the interface and then result in intermixing, atom re-distribution or composition change, as well as phase transformation. Main progress on the study of intermixing and phase change at metal/insulator interface induced by energetic ion irradiations, the difference of phenomena occurred at metal/insulator interfaces induced by high-and low-energy ions were briefly reviewed. Furthermore, the possible mechanisms related to intermixing and phase change at metal/insulator interface produced by energetic ion irradiations were also discussed in short words.