40,48Ca+90,96Zr融合反应的动力学模型研究

应用改进的量子分子动力学模型,在严格挑选初始核考虑弹靶结构效应的基础上,研究了近垒和垒上融合反应^40,48Ca+^90,96Zr. 研究表明: 4个反应的理论计算截面与实验值很好符合; 丰中子反应⁴⁰Ca+⁹⁶Zr的垒下融合截面比其他3个反应有明显增强的现象.为了理解丰中子反应⁴⁰Ca+⁹⁶Zr与⁴⁰Ca+⁹⁰Zr相比垒下融合截面增强,而Ca+⁹⁶Zr垒下融合截面没有明显增强的原因, 进一步分析了484个反应的融合位垒,中子转移与融合位垒的关系、中子转移与Q值的关系,结果表明: 正反应Q值会引起核子(特别是中子)转移的增强,从而导致动力学融合位垒的下降和垒下融合截面增强.     

Coulomb blockade in molecular quantum dots

The rate-equation approach is used to describe sequential tunneling through a molecular junction in the Coulomb blockade regime. Such device is composed of molecular quantum dot (with discrete energy levels) coupled with two metallic electrodes via potential barriers. Based on this model, we calculate nonlinear transport characteristics (conductance-voltage and current-voltage dependences) and compare them with the results obtained within a self-consistent field approach. It is shown that the shape of transport characteristics is determined by the combined effect of the electronic structure of molecular quantum dots and by the Coulomb blockade. In particular, the following phenomena are discussed in detail: the suppression of the current at higher voltages, the charging-induced rectification effect, the charging-generated changes of conductance gap and the temperature-induced as well as broadening-generated smoothing of current steps.     

自由基CH(X2Π,a4Σ-)的光谱数据从头算研究

用分子轨道从头算方法,对CH自由基的基态(X2Π)和低激发态(a4Σ-)的光谱数据进行了计算.计算结果表明,在基态CH(X2Π)时,在QCISD(T)/6-311G (3df,3pd)水平上,计算所得的键长R=0.1120981nm,偶极矩μ＝1.5891 Debye,ν＝2845.43cm-1均与实验值相吻合,在B3PW91/6-311G (3df,3pd)理论水平上,计算的基态能量为-38.496143 Hartree,误差仅为0.22%;对低激发态CH(a4Σ-),使用含时的密度泛函方法(TDDFT)和大基组6-311 G(3df,3pd)计算所得的R=0.1094nm,垂直跃迁能量为0.926eV,均与实验结果有较好的吻合.     

Gas source MBE grown wavelength extended 2.2 and 2.5 μm InGaAs PIN photodetectors

Using homo-junction structure and relative thin linear graded In_xGa_1−xAs as the buffer layer, extended wavelength InGaAs PIN photodetectors with cut-off wavelength of 2.2 and 2.5 μm at room temperature have been grown by using GSMBE, and their performance over a wide temperature range have been extensively investigated. For those 2.2 or 2.5 μm detectors with 100 μm diameter, the typical dark current (V_R = 10 mV) and R₀A are 57 nA/10.3 Ω cm² or 67 nA/12.7 Ω cm² at 290 K, and 84 pA/4.70 kΩ cm² or 161 pA/3.12 kΩ cm² at 210 K respectively. The thermal activation energies of the dark current are 0.447 eV or 0.404 eV for 2.2 or 2.5 μm detectors respectively.     

Growth and characterization of model oxide catalysts

Oxide catalysts are frequently used to convert toxic species to environmentally benign molecules, and to prevent the formation of toxic species in the first place. In this paper, growth and characterization of model oxide systems employed in both approaches is discussed. An example of the former approach is the selective catalytic reduction (SCR) of NO emitted from power plants by NH₃, which employs tungsten and vanadium oxides supported on the anatase polymorph of TiO₂. To model SCR catalysts, epitaxial titanium, vanadium and tungsten oxide films were grown using molecular beam epitaxy and magnetron sputtering. Two different anatase orientations were grown on LaAlO₃ substrates and their interactions with vanadia were characterized. On LaAlO₃ (0 0 1), anatase exposed a (4 × 1) reconstructed (0 0 1) surface. Vanadia lifted the reconstruction and at 1 ML a (1 × 1) surface with mostly V⁵⁺ was observed. Continued V₂O₅ growth led to loss of order, but at high temperatures epitaxial VO₂ could be grown; vanadia behaved similarly on anatase films on LaAlO₃ (1 1 0). Results suggested that the monolayer is pseudomorphic with O adsorption oxidizing the surface V to 5+, since the anatase structure cannot accommodate more bulk oxygen, only a monolayer can be pseudomorphic and have only V⁵⁺. Thus the vanadia monolayer has unique structural and chemical properties that can help explain why vanadia monolayers on TiO₂ are much more active than bulk V₂O₅. For WO₃, a series of added row reconstructions were observed as the epitaxial films were reduced. The effect of these structures on surface chemistry was characterized by studying 1-propanol adsorption. The results indicated that the structure of the WO₃ surface did not alter its catalytic function but had a strong effect on reaction kinetics. As an example of a system where catalysts prevent the formation of toxic species, the reactivity of oxidized Pd surfaces used in CH₄ catalytic combustion were studied. An ordered PdO-like monolayer was found to be less reactive towards CO than adsorbed O on Pd. On the other hand, the PdO layer favored a lower activation energy C₃H₆ oxidation pathway. The results indicated that Pd oxidation reduces the sticking coefficient of reactive species but once molecules adsorb, the oxide surface can reduce the activation energy for subsequent reaction.     

Structural transition of the human lymphocyte plasma membrane: an ESR approach

Summary The electron spin resonance spectroscopy and the spin label technique have been used to study the thermotropic structural transition of the plasma membrane ofin toto human peripheral blood lymphocytes in the temperature range (25÷41)°C. A discontinuity in the plot probe order parametervs. temperature, at a temperature of about 31°C, is observed. This discontinuity is upward shifted to a temperature of 35°C in the presence of staphylococcal enterotoxinB and is no longer observed when using isolated plasma membrane. These results are interpreted as being due to a change in the structural properties of the lipid phase of plasma membrane during the activation of the lymphocyte cells.     

1H NMR研究β-环糊精与环氧氯丙烷共聚物的反应机理和分子链结构

β-环糊精(cyclodcxtrin)与环氧氯丙烷(Epichlorohydrin)一个系列的共聚物获得,¹H NMR以D₂O或DMSO-d₆为溶剂的测定,其谱峰被归属.共聚合反应机理为以羟基和环氧基为活性中心的亲核取代.当环氧氯丙烷:β-环糊精=n ≤ 3时,聚合物分子链呈现以β-环糊精母体为中心的线状或低枝化状链结构;当n ≥ 5时,分子链出现交联网络结构.n越大(n ≤ 12),分子量越急剧增加,其交联度也越大.     

甲硝唑、替硝唑和奥硝唑的结构与光谱

采用密度泛函理论(DFT)中的杂化密度泛函B3LYP方法,在6-31+G水平上对甲硝唑、替硝唑和奥硝唑的结构进行几何优化,并在同一水平上计算了三种化合物的红外光谱,分析了三种化合物的稳定结构和红外光谱特征.结果表明:咪唑环基本为平面构型,并且环上有一定的芳香性;三种化合物在4000～400 cm-1波数区光谱基本一致,此部分是5-硝基咪唑类化合物的特征光谱,而在400～100 cm-1波数区三种化合物光谱区别较大.因此,可用中红外光谱来鉴定硝基咪唑类化合物,用远红外光谱对以上三种化合物进行鉴别.     

Texture of molybdenum thin films on SrTiO3(1 0 0): A RHEED study

The structure of ultrathin Mo films on SrTiO₃(1 0 0) was studied by in situ reflection high-energy electron diffraction (RHEED). A different structure was observed for films less than 20 Å thick than for thicker films. These films were epitaxial and had a metastable structure. Thicker films had the dimensions of equilibrium bcc Mo(1 1 0). Relaxation processes transformed the metastable Mo into bcc Mo, resulting in the following orientation relationships between Mo and SrTiO₃: (1 1 0)[0 0 1]_bcc Mo ∥ (1 0 0)[0 0 1]_SrTiO3 and (1 1 0)[1 1 1]_bcc Mo ∥ (1 0 0)[0 1 1]_SrTiO3. The formation of such specific orientations is related to transformations via the Bain and Needle Path, respectively.     

Ar-buffer-assisted deposition of Cu13 on Cu(1 1 1) surfaces

In this paper, the deposition of Cu₁₃ onto Cu(1 1 1) surface through argon buffer layers was investigated by molecular dynamics (MD) simulations. The interactions between Cu-Cu, Cu-Ar, and Ar-Ar were described by Finnis-Sinclair (FS) tight-binding potential and L-J potential, respectively. The impact energy was chosen to be 2-6 eV/atom in order to compare with experimental results. It was observed that with Ar-buffer layers, the Cu cluster deposited on the surface may retain its free cluster symmetry (I_h). Whereas, on originally bare Cu surface, the deposited Cu cluster lost its original symmetry completely and was recrystalized to have the same fcc structure as the substrate. The Ar-buffer dissipates most of the translational energy of the incident cluster. Therefore, it prevents the cluster from being overheated upon impinging. Furthermore, the interaction between Ar and Cu benefits the confinement of the cluster structure. Our study shows that with Ar-buffer layers, the lateral spread of deposited clusters is 20% smaller than that on the bare Cu surface. This is consistent with the experimental findings.