Determination of Uric Acid and Norepinephrine by Chitosan‐Multiwall Carbon Nanotube Modified Electrode

A novel chemically modified electrode based on the chitosan‐multiwall carbon nanotube (MWNT) coated glassy carbon electrode (GCE) is described, which exhibited an attractive ability to determine uric acid (UA) and norepinephrine (NE) simultaneously. The responses of UA and NE merged into a large peak at a bare GCE, but yielded two well‐defined oxidation peaks at the chitosan‐MWNT modified GCE (MC/GCE). The experimental parameters were optimized, and a direct electrochemical method for the simultaneous determine for UA and NE is proposed. The MC/GCE showed good sensitivity, selectivity and stability.     

在涂层TiO2改性铜催化剂上甲醇脱氢制甲酸甲酯

在常压和２５０℃下，考察了涂层ＴｉＯ２改性铜催化剂上甲醇脱氢生成甲酸甲酯的活性和选择性以及催化剂的稳定性。结果表明，涂层ＴｉＯ２明显提高了铜催化剂的活性和稳定性。在所考察的铜催化剂中，以Ｃｕ／ＴｉＯ２／ＡｌＯ３的催化活性最高，甚至高于离子交换法制备的Ｃｕ（ｅｘ）／ＳｉＯ２催化剂。ＸＰＳ分析表明，Ｃｕ／ＴｉＯ２／ＡｌＯ３中存在着两种化学环境不同的ＣＵ（０），即负载在ｒ－ＡＬＯ３和ＴｉＯ２－Ａｌ２Ｏ３     

SUPERCRITICAL-PHASE PROCESS FOR SELECTIVE SYNTHESIS OF HEAVIER HYDROCARBONS FROM SYNGAS OVER ARu/Al_2O_3 CATALYST

在Ｒｕ／Ａｌ２Ｏ３催化剂上进行了超临界条件下的固定床费托合成。研究了催化剂孔尺寸、α－Ｃ１４烯共进料和反应温度对费托合成产物分布的影响     

New process to control hydrolysis step during sol-gel preparation of sulfated zirconia catalysts

Sulfated zirconia catalysts were prepared by sol-gel process using a new method allowing the control of the hydrolysis step of zirconium alkoxides. Prepared samples were characterized by N₂ adsorption (desorption) at 77 K, XRD, chemical analysis of total sulfur and XPS. Catalytic properties have been evaluated in n-butane and n-hexane isomerization reactions. Obtained results show that time necessary for gelation is significant and depends considerably on the nature of the zirconium precursor. Concerning the properties of the solids obtained by this method, it has been noted that the use of the zirconium propoxide led to a better retention of the sulfate species, which improves activity during isomerization reactions. It has been found also that an initial S/Zr molar ratio equal to 0.5 allowed to obtain an optimal sulfur content and a high specific surface area.     

Simultaneous propane dehydrogenation andco2hydrogenation overCrOx/SiO2catalyst

Summary Single reverse water-gas shift (RWGS) and dehydrogenation of propane with CO₂(DH-CO₂) reactions in the presence and absence of the CrO_x/SiO₂ catalyst have been studied between 673 and 873 K. It was found that the CrO_x/SiO₂ catalyst is active both in the dehydrogenation of propane and in the RWGS reactions. The obtained results suggest that the dehydrogenation of propane to propene in the presence of CO₂on CrO_x/SiO₂can be facilitated by the RWGS reaction.</o:p>     

铂锡双金属催化剂上丙烷脱氢反应研究

对比研究了Ｓｎ／Ｐｔ比为１；１，２，：１和５：１的原子簇担载于γ－Ａｌ２Ｏ３上制成的Ｐｔ＝Ｓｎ原子簇催化剂，和用ＳｎＣｌ２和Ｈ２ＰｔＣｌ６浸渍制备的相应Ｓｎ／Ｐｔ比的催化剂对丙烷脱氢生成丙烯的催化性能。     

Additive telluromolybdates. Structure and catalysis in oxidation

Additive telluromolybdates, MoO₃·2TeO₂ and M^IIO·TeO₂·MoO₃ (M^IITeMoO₆; M^II = Co, Mn, Zn), converted ethyl lactate selectively to pyruvate in a vaporphase fixedbed flow system at 250–300 °C. A synergy in activity was observed for binary TeO₂–MoO₃, and crystalline Te₂MoO₇ was suggested as the active species. The Rietveld analysis of powder XRD patterns of ternary CoTeMoO₆ revealed the layer structure quite different from that of the reference Te₂MoO₇, but tellurium was again located adjacent to molybdenum linked through lattice oxygen.     

Insoluble polystyrene-bound quaternary onium salt catalysts for the synthesis of cyclic carbonates by the reaction of oxiranes with carbon dioxide

The addition reaction of oxiranes ( 26a—e ) with carbon dioxide (CO₂) was performed using insoluble polystyrene beads containing pendant quaternary ammonium or phosphonium salts as catalysts under atmospheric pressure. The reaction of 26a—e with CO₂ proceeded smoothly catalyzed by 1–2 mol % of the polymer-supported quaternary onium salts to give the corresponding cyclic carbonates ( 27a—e ) in high yields at 80–90°C. In this reaction system, the catalytic activity of the polymer-supported quaternary onium salts was strongly affected by the following factors: degree of ring substitution (DRS) of the onium salt residues to the polymer, degree of crosslinking (DC) of the polystyrene beads, chain length of the alkylene spacer between the polymer back-bone and the onium salt, hydrophobicity of the alkyl group on the onium salts, and kind of onium salts. That is, the polymer-supported quaternary phosphonium salts with low DRS and DC and with long alkylene spacer chain were found to have higher catalytic activity than low molecualr weight quaternary onium salts. The above polymer-supported catalysts can easily be separated at the end of a reaction by filtration and can be reused for at least seven runs. It was also found that the rate of reaction was proportional to the products of catalyst concentration and oxirane concentration. © 1993 John Wiley & Sons, Inc.     

Influence of the activation temperature on structural and textural properties of NiMo/Al2O3 hydrodesulfurization catalysts

Investigations of a commercial NiMo/Al₂O₃ hydrodesulfurization (HDS) catalyst are directed towards optimization of the activation procedure of HDS catalyst concerning active phase formation and thermal stability. Structural and textural data obtained with XRD, IR-FTIR, XPS and LTNA reveal that the optimal temperature for the formation of active species on the catalyst surface and an appropriate pore structure is 300°C.     

钙钛矿型复合氧化物Ca_xSr_（1－x）TiO_3催化剂上的甲烷氧化偶联反应

在固定床反应器上，评价了不同温度下钙钛矿型复合氧化物ＳｒＴｉＯ３和ＣａＴｉＯ３的组成变化对甲烷氧化偶联反应的影响．同时，利用ＸＰＳ和ＣＯ２－ＴＰＤ对催化剂的结构及其氧物种的反应特性进行了表征．结果表明：ＳｒＴｉＯ３和少量Ｃａ掺杂的ＣａｘＳｒｌ－ｘＴｉＯ３有利于在较低温度（９２３Ｋ）下催化反应的活性和选择性，而ＣａＴｉＯ３体系则在高温（１０７３Ｋ）下表现出较好的活性和选择性．钙钛矿型复合氧化物ＳｒＴｉＯ３和ＣａＴｉＯ３组成变化对不同温度下反应活性的影响与ＣＯ２－ＴＰＤ的脱附谱图有很好的平行关系．