三正辛胺修饰电极伏安测定痕量金的研究

用化学修饰电极伏安测定痕量金,Kalcher K等曾采用阴离子交换剂碳糊修饰电极及打萨宗碳糊修饰电极检测100～300μg/L的金。本文采用三正辛胺(TOA)修饰玻碳电极,在1.5 mol/L介质中,Au(Ⅲ)在+0.16 V(vs SCE)处有一灵敏的不可逆还原峰。检出限为0.1μg/L。灵敏度比文献方法高千倍。Au(Ⅲ)浓度在5×10~(-7)～5×10~(-9)mol/L范围内峰高与浓度     

壳聚糖修饰玻碳电极卷积伏安法测定环境水中的EDTA

制备了壳聚糖修饰玻碳电极 ,研究了Fe(EDTA) -在修饰电极上的吸附还原行为 ,用卷积伏安法通过Fe(EDTA) -的检测测定了环境水中的EDTA。在优化的实验条件下 ,峰电流值与 8.0× 1 0 -7～ 5 .0× 1 0 -6mol L的EDTA呈线性关系 ,回归方程为epp′ =0 .75 2 5c - 0 .661 3,r =0 .991 ,最低检出限为 5 .0× 1 0 -7mol L ,5次测定的相对标准偏差小于 5 .8%。对实际样品测定的回收率为98 1 %～ 1 0 5 % ,对比HPLC的结果 ,相对偏差小于 5 %。     

THE SYNTHESIS OF MODIFIED DIPHENYL OXIDE RESIN

1. INTRODUCTION Poly (diphenyl oxide) (DPO) resins are a series of heat-resisting thermosetting resins. In 1960s, the West House Company applied them to make H class insulting materials and got an extensive use successfully [1]. But due to the three main…     

Renewable sol-gel carbon ceramic electrodes modified with a Ru-complex for the amperometric detection of l-cysteine and glutathione

A renewable three-dimensional chemically modified carbon ceramic electrode containing Ru [(tpy)(bpy)Cl] PF₆ was constructed by sol-gel technique. It exhibits an excellent electro-catalytic activity for oxidation of l-cysteine and glutathione at pH range 2-8. Cyclic voltammetry was employed to characterize the electrochemical behavior of the chemically modified electrode. The electrocatalytic behavior is further exploited as a sensitive detection scheme for l-cysteine and glutathione by hydrodynamic amperometry. Optimum pH value for detection is 2 for both l-cysteine and glutathione. The catalytic rate constants for l-cysteine and glutathione were determined, which were about 2.1×10³ and 2.5×10³ M⁻¹ s⁻¹, respectively. Under the optimized condition the calibration curves are linear in the concentration range 5-685 and 5-700 μM for l-cysteine and glutathione determination, respectively. The detection limit (S/N=3) and sensitivity is 1 μM, 5 nA/μM for l-cysteine and 1 μM, 7.8 nA/μM for glutathione. The relative standard deviation (RSD) for the amperogram's currents with five injections of l-cysteine or glutathione at concentration range of linear calibration is <1.5%. The advantages of this amperometric detector are: high sensitivity, good catalytic effect, short response time (t<3 s), remarkable long-term stability, simplicity of preparation and reproducibility of surface fouling (RSD for six successive polishing is 3.31%). This sensor can be used as a chromatographic detector for analysis of l-cysteine and glutathione.     

Development of an Amperometric Sensor Highly Selective For Dopamine and Analogous Compounds Determination Using Bis(2,2′‐Bipyridil) Copper(II) Chloride Complex

The use of [Cu(bipy)₂]Cl₂?6H₂O as a biomimetic catalyst in the construction of an amperometric sensor for dopamine determination is reported. The sensor was prepared modifying a glassy carbon electrode with a Nafion membrane doped with [Cu(bipy)₂]Cl₂?6H₂O complex. The sensor presented a higher response in 0.25 mol L^?1 phosphate buffer solution (pH 7.0), with an applied potential of ?50 mV (vs. SCE). In the optimized operational conditions, a linear response range between 35 and 240 μmol L^?1, with a sensitivity of 2.02±0.07 nA l μmoL^?1 cm^?2 and detection limit of 8.0 μmol L^?1 were typically observed for the sensor. The response time presented for this sensor was 0.5 s, presenting the same response for at least 40 successive measurements, with good repeatability (3.0%) expressed as relative standard deviation for n=6. The difference of the response between four sensor preparations was 4%. A detailed investigation about the sensor response for other sixteen phenolic compounds and interfering species were carried out. The sensor was applied in the determination of dopamine in pharmaceutical preparation with success.     

聚苯胺修饰超微盘电极上镉(Ⅱ)的表面络合吸附波

用直径7 μm的碳纤维组合成超微圆盘电极,以聚苯胺修饰电级.以阶梯扫描法、循环伏安法、双阶跃计时电量法和交流阻抗法等,研究了Cd2＋在该电极上的表面络合吸附特性和电极过程.在循环伏安图上出现两个还原峰,实验和理论都证明,由于电极表面的聚苯胺对Cd2＋的特性吸附,形成电活性的表面吸附态络合物.因此,这种表面络合物首先被还原,形成峰电位－0.90 V处的表面络合吸附波,还原峰电位比Cd2＋直接还原电位（－0.98 V）正移,循环反扫时,氧化波无峰形.根据实验数据推测了电极过程的反应机理,证实该还原波具有扩散和表面反应同时控制的表面络合吸附波的特性.理论计算与实验基本一致,并求得了表面吸附态配合物的形成常数、吸附量和表面络合反应的动力学参数.实验还证实,在峰电位－1.06 V 处的还原波,是Cd2＋的表面吸附还原态诱导而产生的催化氢波.     

NADH Electrooxidation Using Bis(1,10-phenanthroline-5,6-dione) (2,2'-bipyridine)ruthenium(II)-Exchanged Zirconium Phosphate Modified Carbon Paste Electrodes

We present a carbon paste electrode (CPE) modified using the electron mediator bis(1,10‐phenanthroline‐5,6‐dione)(2,2′‐bipyridine)ruthenium(II) ([Ru(phend)₂bpy]²⁺) exchanged into the inorganic layered material zirconium phosphate (ZrP). X‐Ray powder diffraction showed that the interlayer distance of ZrP increases upon [Ru(phend)₂bpy]²⁺ intercalation from 10.3 Å to 14.2 Å. The UV‐vis and IR spectroscopies results showed the characteristic peaks expected for [Ru(phend)₂bpy]²⁺. The UV‐vis spectrophotometric results indicate that the [Ru(phend)₂bpy]²⁺ concentration inside the ZrP layers increased as a function of the loading level. The exchanged [Ru(phend)₂bpy]²⁺ exhibited luminescence even at low concentration. Modified CPEs were constructed and analyzed using cyclic voltammetry. The intercalated mediator remained electroactive within the layers (E°′=–38.5 mV vs. Ag/AgCl, 3.5 M NaCl) and electrocatalysis of NADH oxidation was observed. The kinetics of the modified CPE shows a Michaelis–Menten behavior. This CPE was used for the oxidation of NADH in the presence of Bakers' yeast alcohol dehydrogenase. A calibration plot for ethanol is presented.     

A study of the electrocatalytic oxidation of aspirin on a nickel hydroxide-modified nickel electrode

The electrocatalytic oxidation of aspirin has been investigated on a nickel oxide-modified nickel electrode in alkaline solution. The process of oxidation and its kinetics have been investigated by using cyclic voltammetry, chronoamperometry, and electrochemical impedance spectroscopy techniques and also steady-state polarization measurements. Voltammetric studies have indicated that in the presence of aspirin, the anodic peak current of low-valence nickel species increases, followed by a decrease in the corresponding cathodic current. This indicates that aspirin was oxidized on the redox mediator immobilized on the electrode surface via an electrocatalytic mechanism. The rate constant of the catalytic oxidation of aspirin and the electron transfer coefficient have been found to be 1.15×10⁵ cm³ mol⁻¹s⁻¹ and 0.49, respectively. Impedance measurements show that aspirin is diffused into the bulk of the modifier film, and the oxidation process of aspirin occurs in the bulk of nickel oxide film. It has been shown that by using this modified electrode, aspirin can be determined with a detection limit of 4.8×10⁻⁵ and successfully applied for determination of aspirin in tablet.