Improved relativistic energy-consistent pseudopotentials for 3d-transition metals

Energy-consistent relativistic pseudopotentials for 3d-transition metals Sc to Ni based on modified valence energies are proposed. The pseudopotentials are adjusted at the finite difference level within the intermediate coupling scheme with respect to multi-configuration Dirac–Hartree–Fock data based on the Dirac–Coulomb Hamiltonian with an estimate of the Breit contributions in quasidegenerate perturbation theory. Typically a few hundred to thousand J levels arising from about 35 to 40 configurations ranging from the anion down to the highly charged cation are considered as references. It is shown that introducing a small common energetic shift of all valence energies reduces the errors in the parameter adjustment considerably. Results of highly correlated atomic and molecular test calculations using large basis sets and basis set extrapolation techniques are presented. To be submitted to Theoretical Chemistry Accounts (special volume on the occasion of Prof. Dr. H. Stoll's 60th birthday)     

Cu-Mg/Al复合氧化物催化碳颗粒物燃烧性能的研究

恒定二价与三价阳离子比为3(nM2+/nM3+=3),采用共沉淀法制备不同Cu含量的系列水滑石前驱物, 800 ℃焙烧4 h形成复合氧化物(CuO质量百分数分别为0％、5％、10％、15％、20％、30％、40％)用作柴油车排放碳颗粒物燃烧的催化剂,并采用XRD、BET、TG-DSC、FT-IR、TPR等表征手段研究了Cu、Mg含量对材料前驱物物化性能的影响及对其衍生复合氧化物催化碳颗粒物燃烧性能的影响．结果表明,Cu、Mg含量对材料的热稳定性、比表面和催化氧化活性有显著的影响. Mg有助于提高催化剂的热稳定性; Cu含量增加,催化剂比表面下降,但比表面不是影响催化剂活性的主要因素. CuO含量为15％时,催化剂具有最好的催化活性和稳定性,碳颗粒物的起燃温度(T10)和半转化温度(T50)分别为336 ℃和409 ℃.在CuO含量≤30％时可以形成结构完整的水滑石前驱物, CuO含量为40％时出现Cu(OH)2杂相; CuO含量< 20％时,经高温焙烧可得到均匀的复合氧化物, CuO含量≥20％时出现CuO偏析． TPR结果表明焙烧温度和复合氧化物的组成决定了材料的可还原性能．     

Stereocontrol in Organic Synthesis Using the Diphenylphosphoryl Group

In 1959, Horner showed that metalated alkyldiphenylphosphane oxides react with aldehydes or ketones to give alkenes. With this reaction, the diphenylphosphoryl (Ph₂PO) group made its entrance into synthetic organic chemistry. In the thirty-six years since that date, extensive research has shown that this olefination, the Horner–Wittig reaction, has unique properties that make it much more than simply the phosphane oxide cousin of the more famous phosphorus-based olefinations—the Wittig reaction (based on phosphonium salts) and the Wadsworth–Emmons reaction (based on phosphonate esters). Early work on the Horner–Wittig reaction concentrated on the reactivity of phosphane oxides and the regioselectivity of their reactions, but more recently the power of the Ph₂PO group to control the stereochemistry of alkenes, and to produce “on demand” either stereoisomer in high stereochemical purity, has emerged. From the study of these stereocontrolled Horner–Wittig reactions arose the realization that the Ph₂PO group is useful not only for the control of the two-dimensional stereochemistry of alkenes, but also of three-dimensional stereochemistry in general. After a brief introduction to phosphane oxide chemistry, this review will examine the Horner–Wittig reaction, in both its original and “stereocontrolled” varieties. From there, we will move on to an account of the stereoselective construction of molecules containing the Ph₂PO group, concentrating on the stereochemical directing effects of the Ph₂PO group and on the role of its unique combination of attributes—steric bulk, electronegativity, and Lewis basicity—in controlling these reactions. Finally, we will present what is intended as a practical guide to this chemistry, covering the type of functionalized alkenes that have been made with the help of the Ph₂PO group and giving guidelines that we hope will help the organic chemist to make the most of the chemistry the Ph₂PO group has to offer.     

Phase Equilibria and Crystal Structure of Complex Oxides in the La–Sr–Co–Ni– System

Phase equilibria in the La–Sr–Co–Ni–O system were studied in air at 1100°. The samples for the study were synthesized by the standard ceramic and citrate processes. The limiting solubility and structure of La_1-xSr_xCo_1-yNi_yO_3- and (La_1-xSr_x)₂Co_1-yNi_yO₄ solid solutions were determined by Xray powder diffraction analysis. La_1-xSr_xCo_1-yNi_yO₃- solid solutions with 0 x 0.5 have a distorted rhombohedral perovskitelike structure (R c space group). An increase in the strontium concentration reduces the rhombohedral distortions, and the compounds with x < 0.5 have an ideal cubic structure (Pm3m space group). (La_1-xSr_x)₂Co_1-yNi_yO₄ crystals have a tetragonal K₂NiF₄ type unit cell (I4/mmm space group). The relationships between unit cell parameters and compositions were obtained for singlephase La_1-xSr_xCo_1-yNi_yO_3- and (La_1-xSr_x)₂Co_1-yNi_yO₄ samples. The existence regions of La_1-xSr_xCo_1-yNi_yO₃- and La_1-xSr_x)₂Co_1-yNi_yO₄ solid solutions were distinguished on P–T phase diagrams.     

用水合五氧化二锑分离放射性母子体的研究─—一个新的~(201)Pb—~(201)T1发生器的制备

本文研究了无机离子交换剂—水合五氧化二锑（Sb2O5·nH2O）的制备，并用它分离了放射性母子体，制备了一个新的201Pb—201Tl放射性发生器。结果表明，末发生器具有高效、快速、简便的特点，此外还讨论了离子交换反应的机理。     

Reaction of dibenzylphosphine oxide with α,β-unsaturated O-methyloximes

The reaction of dibenzylphosphine oxide with O-methyloximes of some ,-unsaturated ketones results in the phosphorylation at the -carbon atom to form methoxyiminophosphine oxides, whereas the reaction of dibenzylphosphine oxide with O-methyloximes of ,-unsaturated aldehydes affords aminodihydrophosphole oxides.     

V2O5/TiO2 Catalytic Xerogels Raman and EPR Studies

Raman spectroscopy and Electron Paramagnetic Resonance (EPR) studies were performed on a series of V₂O₅/TiO₂ catalysts prepared by a modified sol-gel method in order to identify the vanadium species. Two species of surface vanadium were identified by Raman measurements, monomeric vanadyls and polymeric vanadates. Monomeric vanadyls are characterized by a narrow Raman band at 1030 cm^–1 and polymeric vanadates by two broad bands in the region from 900 to 960 cm^–1 and 770 to 850 cm^–1. The Raman spectra do not exhibit characteristic peaks of crystalline V₂O₅. These results are in agreement with those of X-ray Diffractometry (XRD) and Fourier Transform Infrared (FT-IR) previously reported (C.B. Rodella et al., J. Sol-Gel Sci. Techn., submitted). At least three families of V⁴⁺ ions were identified by EPR investigations. The analysis of the EPR spectra suggests that isolated V⁴⁺ ions are located in sites with octahedral symmetry substituting for Ti⁴⁺ ions in the rutile structure. Magnetically interacting V⁴⁺ ions are also present as pairs or clusters giving rise to a broad and structureless EPR line. At higher concentration of V₂O₅, a partial oxidation of V⁴⁺ to V⁵⁺ is apparent from the EPR results.     

Block copolymerization initiated by Mn(III)-poly(ethylene glycol) redox system — general features and kinetics

The kinetics and mechanism of thermal polymerization of acrylonitrile initiated by Mn(III) pyrophosphate — poly(ethylene glycol) (PEG, molecular weight 6000) redox system in aqueous sulfuric acid medium was studied in the temperature range 30–60°C. The overall rates of polymerization and the disappearance of Mn³⁺ were determined. The polymerization was initiated by the organic free radical produced from the Mn³⁺-PEG reaction and the termination was by the metal ions. The rate of polymerization of acrylonitrile was found to be directly proportional to the square of the monomer concentration and first power of PEG concentration, and inversely proportional to the concentration of Mn³⁺. The rate of manganic ion disappearance was found to be directly proportional to manganic ion concentration and PEG concentration, and independent of the monomer concentration. Based on these observations, a plausible reaction scheme was suggested and suitable kinetic expressions were evaluated.     

Reduced-size polarized basis sets for calculations of molecular electric properties. IV. First-row transition metals

Recent studies of the perturbation-dependent basis sets have indicated the possibility of a significant reduction of the size of the usual CGTO sets without considerable loss of accuracy in calculations of molecular electric properties. The resulting (ZPolX) basis sets have been developed for several atoms of the first and second row of the Periodic Table. The same method of the ZPolX basis set generation is extended for the first-row transition metals and the corresponding contracted ZPolX basis sets of the size [6s5p3d1f] are determined for both nonrelativistic and scalar relativistic calculations. The performance of the ZPolX basis sets is verified in calculations on the first-row transition metal oxides at the level of the ROHF, ROHF/CASPT2, and ROHF/CCSD(T) approximations. Also the study of the dipole polarizability of TiCl₄ confirms the excellent features of these very compact basis sets. The ZPolX basis sets for nonrelativistic and relativistic calculations of molecular electric properties are available on the web page http://www.chem.uni.torun.pl/zchk/basis-sets.html.     

Über Oxide mit dem “Butterfly-Motiv”: Rb6[Fe2O5] und K6[Fe2O5]

New Oxides with the “Butterfly-Motive”: Rb₆[Fe₂O₅] and K₆[Fe₂O₅] Rb₆[Fe₂O₅] and K₆[Fe₂O₅] were obtained for the first time by annealing intimate mixtures of “Rb₆CdO₄” with CdO (molar ratio 1 : 1.1) and KO_0.48 with CdO (molar ratio 5.9 : 1) respectively in closed Fe-cylinders. Determination and refinement of the crystalstructure confirms the space group C2/m (four-circle-diffractometer data). Rb₆[Fe₂O₅]: Ag Kα , 720 out of 1220 Io(hkl), R = 9.68%, R_w = 6.09%; a = 718.9pm, b = 1183.1 pm, c = 695.4pm, β = 95.05°, Z = 2; K₆[Fe₂O₅]: MoKα , 1214 Out of 12141_o(hkl), R = 3.20070, R_w = 2.48%, a = 691.21 pm, b = 1142.78pm, c = 665.50pm, β = 93.82°, Z = 2. The binuclear unit [O₂FeOFeO₂]^6? already known to be planar with oxoferrates(II) now was observed to be angular here and closely related to Na₆[Be₂O₅].