Kinetic optimisation of open-tubular liquid-chromatography capillaries coated with thick porous layers for increased loadability

The kinetic optimisation of open-tubular liquid chromatography (OTLC) columns has been revisited by taking the thick-film effects for porous coatings on retention, column resistance, band broadening and mass loadability into account. Considering the most advantageous case (i.e. where the retentive layer allows for the same high internal diffusion coefficient as conventional porous particles), calculations show the need for the development of coating procedures leading to porous films filling up approximately 50-70% of the total column diameter. Furthermore, to achieve optimum kinetic performance for separations of small molecules with total analysis times of less than 8h (k'=9), total column diameters should be less than 6 μm with lengths typically greater than 0.8m for N values of 125,000-500,000 at a pressure of 400 bar. The use of elevated temperature LC (90°C) is also shown to increase the allowable total column diameter to up to 9 μm for a larger range of N values (100,000-880,000).     

Monolithic capillary columns synthesized from a single phosphate-containing dimethacrylate monomer for cation-exchange chromatography of peptides and proteins

Monoliths containing phosphoric acid functional groups were synthesized from only one monomer, bis[2-(methacryloyloxy)ethyl] phosphate (BMEP), in 75-μm i.d. UV transparent fused-silica capillaries by photo-initiated polymerization for cation exchange chromatography of peptides and proteins. Various synthetic conditions, including porogen solvents, monomer concentration, and polymerization time, were studied. The hydrophobicities of the resulting monoliths were evaluated using propyl paraben under reversed-phase conditions and synthetic peptides under ion-exchange conditions. These monoliths exhibited low hydrophobicities and relatively low porosities due to their highly cross-linked structures. A dynamic binding capacity (lysozyme) of 73 mg/mL of column volume was measured using the best performing monolith. Synthetic peptides were eluted in approximately 30 min without addition of acetonitrile to the mobile phase, yielding a peak capacity of 28. Efficiencies of 52,900 plates/m for peptides and 71,000 plates/m for proteins were obtained under isocratic conditions. The effects of separation conditions, i.e., mobile phase pH and salt gradient rate, were studied. Good run-to-run reproducibility was achieved with a relative standard deviation (RSD) less than 1.5% for retention times of proteins. The column-to-column retention time reproducibility for peptides was less than 3.5% RSD. A monolithic column was used to follow the deamidation of ribonuclease A. The kinetics of deamidation were founded to be first order with a half life of 195 h. A cytochrome C digest was also separated using a linear gradient of sodium chloride.     

Use of pressure drop profiles to assess the accuracy of Total Pore Blocking measurements of the external porosity of chromatographic columns

By comparing the pressure drop in a column where the meso-pores of the particles have been blocked using the Total Pore Blocking (TPB) method to measure the interstitial volume of the column with that in the same column when the particle meso-pores are fully open, it could be demonstrated in a very sensitive way that the interstitial volume is completely devoid of any significant amount of remaining pore blocking agent in the final phase of a TPB experiment. Monitoring the pressure signal until it returns to its original value can hence be used as a reliable indicator that all blocking agent has been removed from the interstitial void at the end of the flushing period. As a consequence, any small molecular weight dead volume marker that is employed in this phase can explore the full interstitial volume, so that the value of the latter can be measured without being underestimated by the fact that some fractions of the interstitial void would still be occupied by the blocking agent.     

Micro liquid-liquid extraction combined with large-volume injection gas chromatography-mass spectrometry for the determination of haloacetaldehydes in treated water

Haloacetaldehydes (HAs) are becoming the most widespread disinfection by-products (DBPs) found in drinking water, besides trihalomethanes and haloacetic acids, generated by the interaction of chemical disinfectants with organic matter naturally present in water. Because of their high potential toxicity, HAs have currently received a singular attention, especially trichloroacetaldehyde (chloral hydrate, CH), the most common and abundant compound found in treated water. The aims of this study are focused on the miniaturisation of EPA Method 551.1, including some innovations such as the use of ethyl acetate as the extracting solvent, the enhancement of HAs stability in aqueous solutions by adjusting the pH ~3.2 and the use of a large-volume sample injection (30 μL) coupled to programmed temperature vaporizer-gas chromatography-mass spectrometry to improve both sensitivity and selectivity. In optimised experimental conditions, the limits of detection for the 7 HAs studied ranged from 6 to 20 ng/L. Swimming pools have recently been recognized as an important source of exposure to DBPs and as a result, in this research for the first time, HAs have been determined in this type of water. Two HAs have been found in the analysed water: CH at concentrations between 1.2-38 and 53-340 μg/L and dichloroacetaldehyde between 0.07-4.0 and 1.8-23 μg/L in tap and swimming pool waters, respectively.     

High-resolution separations of protein isoforms with liquid chromatography time-of-flight mass spectrometry using polymer monolithic capillary columns

The separation of intact proteins, including protein isoforms arising from various amino-acid modifications, employing a poly(styrene-co-divinylbenzene) monolithic capillary column in high-performance liquid chromatography coupled on-line to a time-of-flight mass spectrometer (MS) is described. Using a 250 mm × 0.2 mm monolithic capillary column high-sensitivity separations yielding peak capacities of >600 were achieved with a 2h linear gradient and formic acid added in the mobile phase as ion-pairing agent. The combination of high-resolution chromatography with high-accuracy MS allowed to distinguish protein isoforms that differ only in their oxidation and biotinylation state allowing the separation between structural isoforms. Finally, the potential to separate proteins isoforms due to glycosylation is discussed.     

Structural, optical and magnetic properties of Cr doped ZnO microrods prepared by spray pyrolysis method

A series of Cr-doped ZnO micro-rod arrays were fabricated by a spray pyrolysis method. X-ray diffraction patterns of the samples showed that the undoped and Cr-doped ZnO microrods exhibit hexagonal crystal structure. Surface morphology analysis of the samples has revealed that pure ZnO sample has a hexagonal microrod morphology. From X-ray photoelectron spectroscopy studies, the Cr 2p3/2 binding energy is found to be 577.3 eV indicating that the electron binding energy of the Cr in ZnO is almost the same as the binding energy of Cr³⁺ states in Cr₂O₃. The optical band gap E_g decreases slightly from 3.26 to 3.15 eV with the increase of actual Cr molar fraction from x = 0.00 to 0.046 in ZnO. Photoluminescence studies at 10 K show that the incorporation of chromium leads to a relative increase of deep level band intensity. It was also observed that Cr doped samples clearly showed ferromagnetic behavior; however, 2.5 at.% Cr doped ZnO showed remnant magnetization higher than that of 1.1 at.% and 4.6 at.% Cr doped samples, while 4.6 at.% Cr doped ZnO samples had a coercive field higher than the other dopings.     

Evolution of SiGe nanoclusters and micro defects in the Si1−xGex layer fabricated by two-step ion implantation and subsequent thermal annealing

The Si_1−xGe_x thin layer is fabricated by two-step Ge ion implantation into (0 0 1) silicon. The embedded SiGe nanoclusters are produced in the Si_1−xGe_x layer upon further annealing. The number and size of the nanoclusters changed due to the Ge diffusion during annealing. Micro defects around the nanoclusters are illustrated. It is revealed that the change of Si-Si phonon mode is causing by the nanoclusters and micro defects.     

气相色谱-双柱双电子捕获检测器测定土壤及沉积物中23种有机氯农药

建立了微波萃取,弗罗里硅土固相萃取柱及铜粉除硫净化,双柱双电子捕获检测器(ECD)-气相色谱法(GC)测定5种不同质地土壤及5处不同来源沉积物中的23种有机氯农药(OCPs)。采用内标法定量,在0.005～0.5 mg/L的质量浓度范围内,替代物和各种农药标准品的线性相关系数(r2)均大于0.997。5种土壤及5处沉积物中23种OCPs的平均加标回收率分别为50%～119%和52%～120%,相对标准偏差分别为0.9%～16.1%(n=6)和0.3%～28.4%(n=6),检出限为0.00005～0.0005 mg/kg。结果表明,该方法重现性好、灵敏度高、线性关系好,可以满足简便、快速、准确测定农药残留的要求,可大范围推广使用。     

X-ray fluorescence (conventional and 3D) and scanning electron microscopy for the investigation of Portuguese polychrome glazed ceramics: Advances in the knowledge of the manufacturing techniques

This work shows the first analytical results obtained by X-Ray Fluorescence (XRF) (conventional and 3D) and Scanning Electron Microscopy with Energy Dispersive System (SEM-EDS) on original Portuguese ceramic pieces produced between the 16th and 18th centuries in Coimbra and Lisbon. Experts distinguished these productions based only on the color, texture and brightness, which originates mislabeling in some cases.Thanks to lateral and spatial resolution in the micrometer regime, the results obtained with μ-XRF were essential in determining the glaze and pigment thicknesses by monitoring the profile of the most abundant element in each “layer”. Furthermore, the dissemination of these elements throughout the glaze is different depending on the glaze composition, firing temperature and on the pigment itself. Hence, the crucial point of this investigation was to analyze and understand the interfaces color/glaze and glaze/ceramic support.Together with the XRF results, images captured by SEM and the corresponding semi-quantitative EDS data revealed different manufacturing processes used by the two production centers. Different capture modes were suitable to distinguish different crystals from the minerals that confer the color of the pigments used and to enhance the fact that some of them are very well spread through the glassy matrix, sustaining the theory of an evolved and careful procedure in the manufacturing process of the glaze.     

On Coprimely Packed Rings

Let R be a coprimely packed ring and S a multiplicatively closed subset of R. In this article we investigate conditions under which S^?1R is a coprimely packed. It is also proved that if R is a Noetherian integrally closed domain, then R[X] is a coprimely packed ring if and only if R is a semilocal principal ideal domain.