八信道高温超导多路器的实验研究

文中首先分析八信道高温超导多路器设计的方案,以及实现八信道高温超导多路器的技术;给出了用MgO基片为衬底,YBCO超导膜制备的高温超导滤波器设计仿真曲线及实际测试曲线;并对多路器所用制冷器的制冷量进行了计算;最后给出八信道高温超导多路器的实际测试曲线。     

基于抛光基材的热蒸镀铜箔生长高平整单层石墨烯薄膜

在石墨烯的化学气相沉积工艺中,铜箔是决定石墨烯薄膜质量的重要因素。传统铜箔由于制备工艺的限制,存在大量的缺陷,导致石墨烯薄膜的成核密度较高。本工作选用抛光铝板、抛光不锈钢板、微晶玻璃和SiO₂/Si作为基材,用热蒸镀法制备了不同粗糙度的铜箔,并详细讨论了以该系列铜箔生长高平整度石墨烯薄膜的条件及铜箔对石墨烯薄膜品质的影响。实验结果表明,铜箔以(111)取向为主,与基材分离后,表面具有纳米级平整度。在生长石墨烯后,从SiO₂/Si剥离的铜箔成核密度是4种基材中最小的。同时,从SiO₂/Si剥离的铜箔晶体结构变化最不明显,具有良好的结晶性,表面几乎不存在铜晶界缺陷。当压强为3 000 Pa,氢气和甲烷流速分别为300 mL/min和0.5 mL/min时,可以获得约1 mm横向尺寸的石墨烯单晶晶畴。     

气相传输平衡法在(11-20)面蓝宝石上制备γ铝酸锂膜

为了寻找可能替代蓝宝石作为氮化镓外延的新型衬底,通过48 h的气相传输平衡,分别在1000℃、1030℃、1050℃、1070℃和1100℃制备了一层单相多晶的γ铝酸锂膜。X射线衍射和扫描电镜分别用于表征膜的物相、取向和表面形貌。结果显示,γ铝酸锂择优取向的好坏取决于气相平衡传输温度,在1050℃制备的γ铝酸锂具有高度的[100]择优取向;在γ铝酸锂(001)面上的双轴拉应力可能有助于[100]择优取向的形成;γ铝酸锂晶粒表面裂纹的方向一致性与其择优取向紧密相关。上述结果表明在合适的工艺条件下,气相传输平衡法制备的γ铝酸锂/蓝宝石可能成为一种很有前景且适合(1-100)面氮化镓生长的复合衬底。     

气相传输平衡技术制备LiGaO2薄膜

为获得与GaN薄膜晶格失配小的衬底材料,报道了利用气相传输平衡技术(VTE)在(100)-βGa2O3单晶衬底上制备高度[001]取向LiGaO2薄膜的方法。经过X射线衍射分析表明得到的薄膜是由单相LiGaO2组成。利用扫描电镜(SEM)观察表面形貌,发现经气相传输平衡技术处理得到的薄膜表面形貌主要受温度的影响,表面晶粒尺寸随温度上升而增大。而X射线衍射测试表明随着温度上升,所得到的薄膜也从多晶向单晶化转变。在经过退火处理后,通过观察吸收谱发现LiGaO2薄膜中产生色心,并且色心的种类与温度有关。表明可以通过气相传输平衡技术技术,在远低于LiGaO2熔点的温度制备外延GaN用(001)LiGaO2∥(100)β-Ga2O3复合衬底。     

昆明物理研究所分子束外延碲镉汞薄膜技术进展

碲镉汞(MCT)自从问世以来一直是高端红外(IR)探测器领域的首选材料,分子束外延碲镉汞技术具有低成本异质外延、材料能带精准调控、原位成结等优势,是第三代红外焦平面陈列(FPA)器件研制的重要手段。本文报道了昆明物理研究所分子束外延(MBE)MCT薄膜技术进展,包括材料结构、晶体质量、表面缺陷、材料均匀性、掺杂浓度等参数优化控制的研究结果。异质衬底、碲锌镉衬底上MCT薄膜尺寸分别为4英寸(10.16 cm)及2.5 cm×2.5 cm,材料EPD值分别在1×10⁶ cm^-2附近及(3~30)×10⁴ cm^-2范围,表面宏观缺陷密度分别在30 cm^-2附近及100~300 cm^-2范围,薄膜质量与国内外先进水平相当。采用分子束外延MCT薄膜实现了2 048×2 048中波红外(MWIR)、2 048×2 048短波甚高分辨率红外(SWIR)焦平面、640×512中短双色红外(S-MWIR)、320×256中中双色红外(M-MWIR)FPA探测器的研制和验证。     

Imaging and tracking an electrostatic charge micro-domain by Kelvin force microscopy as evidence of water adsorption on mica surface

Muscovite mica is a widely accepted substrate for scanning probe microscopy (SPM) investigations. However, mica has intrinsic properties that alter samples and obstruct their analysis due to free charges build-up, ionic exchange and water adsorption taking place at the surface. In addition to interfacial phenomena, there is a growing interest in electrostatic charges on insulators as they are crucial in diverse applications. Despite the high demand for studies of this nature, experimental set-ups capable of resolving charge build-up at the micro-scale are still scarce and technically limited. Here, we report the imaging of surface charge dissipation on freshly cleaved mica by Kelvin-probe Force Microscopy (KPFM). A local electrostatic charge micro-domain was generated by friction between an atomic force microscope (AFM) tip and mica, and its decay was tracked by two-dimensional mapping using KPFM. We found time-dependent charge dissipation, which is attributed to the adsorption of water molecules on mica surface.     

溅射参数对ZnO薄膜物性的影响

采用磁控溅射方法分别在ITO玻璃和硅片上成功制备了具有良好C轴取向的ZnO薄膜.并研究了溅射气压,基底温度,以及氧偏压对ZnO薄膜物性的影响,从而确定了制备ZnO薄膜的最佳溅射条件.     

有机磷农药酶生物传感器研究进展

酶生物传感器（EBS）以简单、廉价、易于微型化等优势成了有机磷农药（OPs）传统分析方法的最佳替代品。本文从识别OPs的酶及识别机理、电化学EBS、酶的固定化技术、高分子材料的酶固定载体不同角度综述了有机磷农药酶生物传感器研究近况,并重点介绍了一次性丝网印刷酶电极。     

Synthesis of an enzyme-like imprinted polymer with the substrate as the template, and its catalytic properties under aqueous conditions

Transition state analogues (TSAs) have long been regarded as ideal templates for the preparation of catalytically active synthetic imprinted polymers. In the current work, however, a new type of molecularly imprinted polymer (MIP) was synthesized with the substrate (homovanillic acid, HVA) as the template and hemin introduced as the catalytic center, with the use of plural functional monomers to prepare the active sites. The MIP successfully mimicked natural peroxidase, suggesting that it may not be imperative to employ a TSA as the template when preparing enzyme-like imprinted polymers and that the imprinted polymer matrix provided an advantageous microenvironment around the catalytic center (hemin), essentially similar to that supplied by apo-proteins in natural enzymes. Significantly, by taking advantage of the special structure of hemin and multiple-site interactions provided by several functional monomers, the intrinsic difficulties for MIPs in recognizing template molecules in polar solutions were overcome. The newly developed polymer showed considerable recognizing ability toward HVA, catalytic activity, substrate specificity and also stability, which are the merits lacked by the natural peroxidase. Meanwhile, the ease of recovery and reuse the MIP implies the potential for industrial application.     

白藜芦醇分子印迹聚合物合成及其对中药虎杖提取液活性成分的分离

白藜芦醇分子印迹聚合物合成及其对中药虎杖提取液活性成分的分离;分子印迹聚合物;白藜芦醇;虎杖;结合能力;选择性