丙酮一步法合成甲基异丁基酮催化剂研究

用浸渍法制备了丙酮一步法合成甲基异丁基酮负载型催化剂，考察了载体的预处理温度、添加镧助剂对催化剂性能的影响；用BET法测定了催化剂的表面积；采用H2-O2滴定法测定Pd的分散度．结果发现，用经过1．023K焙烧过的Al2O3为载体的催化剂具有较好的催化性能，添加镧助剂后催化剂的分散度、活性有较大的提高．     

氯化聚乙烯对甲基丙烯酸甲酯／苯乙烯共聚动力学的影响

将甲基丙烯酸甲酯（ＭＭＡ）／苯乙烯（Ｓ）在氯化聚乙烯（ＣＰＥ）存在下进行悬浮溶胀接枝共聚，考察了ＣＰＥ对ＭＭＡ／Ｓ共聚动力学行为的影响．ＣＰＥ提高了聚合体系的粘度，使自动加速提前，扩散因素增加，对共聚有阻滞作用．ＣＰＥ是链转移剂，使ＭＭＡ／Ｓ共聚物分子量降低．ＣＰＥ对ＭＭＡ的吸附渗透优于对Ｓ的吸附，造成接技部分与非接技部分组成的差异．ＣＰＥ含量、溶胀时间、转化率、硫酸用量对共聚组成均有影响。     

KPS—CuSO4—Na2SO3参与的无皂液聚合

研究了MMA-St在氧化还原引发剂KPS-CuSO_4-Na_2SO_3存在下的快速无皂乳液聚合.当[MMA]=0.51mol/L、[St]=0.49 mol/L、70℃对,在[KPS]=2.77×10~(-3)mol/L、[CuSO_4]=1.50×10~(-5)mol/L、[Na_2SO_3]=2.77×10~(-3) mol/L条件下反应100min,转化率大于90％;讨论了胶乳的分子量及其分布;求出了聚合反应活化能E_a=81.6 kJ/mol和聚合反应速率常数k_p=321.9 L/mol·s.     

Emulsion polymerization of methyl methacrylate under pulsed microwave irradiation

Emulsion polymerization of methyl methacrylate (MMA) under pulsed microwave irradiation (PMI) with higher peak pulse power was studied. The effects of various parameters of PMI on the polymerization were analyzed and compared with that under conventional heating (CH) process. The results were summarized, as compared with that under CH, as follows. The amount of initiator used to reach constant conversion reduced by 50% at the same polymerization time; at the same initiator concentration 0.15 and 0.2 wt.%, the polymerization rate increased by 131% and 163%, respectively. The molecular weight of polymer obtained was 1.1-2.0 times larger than that under CH; at the same irradiation energy, the conversion achieved using a lower pulse power was greater than that using a higher pulse power. There seemed to be a factor of the irradiation energy efficiency; in other words, for the monomer conversion, the irradiation energy of low pulse power had a higher efficiency. The conversion achieved using a 3.5 μs pulse width was almost the same as that using a 1.5 μs pulse width. The results indicated that PMI had a significant non-thermal effect on the emulsion polymerization of MMA so as to effectively enhance the polymerization rate. The glass transition temperature (T_g), the polydispersity index (PDI) and the regularity of the polymer obtained using two processes were similar, indicating that the physical properties and microstructure of the polymer were not modified by the use of microwaves.     

Kinetic spectrophotometric determination of trace manganese (II) with dahlia violet in nonionic microemulsion medium

A new catalytic kinetic spectrophotometric method has been developed for the determination of trace amount of manganese (II) in nonionic microemulsion medium. The method is based on the catalytic effect of manganese (II) on the oxidation of dahlia violet by potassium periodate with nitrilotriacetic acid as an activitor in the presence of nonionic microemulsion. Under the optimum conditions, the calibration graph is linear in the range of 0.0004-0.0056 μg ml⁻¹ of manganese (II) at 580 nm. The detection limit achieved is 3.75×10⁻⁵ μg ml⁻¹. Manganese (II) in foodstuff samples was determined with satisfactory results.     

A facile electrochemical synthesis of caffeic acid derivatives in the presence of acetylacetone or methyl acetoacetate in aqueous medium

The anodic oxidation of caffeic acid in the presence of acetylacetone or methyl acetoacetate in aqueous solution has been studied by cyclic voltammetry and controlled-potential electrolysis techniques. The result showed that caffeic acid was oxidized to the corresponding o-benzoquinone, which underwent further Michael-addition with acetylacetone or methyl acetoacetate to produce caffeic acid derivative 3,4-dihydroxy-6-(1-acetylacetone)-yl cinnamic acid 4a or 3,4-dihydroxy-6-(1-acetyl-methylacetate)-yl cinnamic acid 4b.     

Effect of initiators on grafting in the initial stage of the emulsion polymerization of methyl methacrylate using poly(vinyl alcohol) as a protective colloid

 To make clear the reason of unsuitability of poly(vinyl alcohol) (PVA) protective colloid for the emulsion polymerization of conjugated monomers, a model experiment of emulsion polymerization of methyl methacrylate (MMA) was carried out with ammonium persulfate (APS) or azobis(isobutyronitrile) (AIBN) initiators, where a small amount of MMA (1/100th of the concentration compared with ordinary emulsion polymerization) was employed. This corresponds to the initial stage of the emulsion polymerization. Grafting of MMA onto PVA took place remarkably irrespective of the kind of the initiators. Formation of homo-poly(MMA) was observed to a small extent. The formation of new emulsion particles smaller than 100 nm continued to increase to almost the end of the polymerization. PVA molecules in the grafted polymer are supposed to act as stabilizers of newly formed particles. From kinetic treatment using the experimental data, the important issues were derived as follows. Firstly, the sulfate anion radical from APS is much more reactive than the isobutyronitrile radical from AIBN in terms of hydrogen abstraction from PVA. Secondly, high grafting ability of the latter initiator system, notwithstanding the much lower reactivity in the hydrogen abstraction compared with the APS system, is attributed to the relative reactivity of the primary radicals, i.e., hydrogen abstraction reaction from PVA to initiation reaction with MMA. The much slower rate of addition of the isobutyronitrile radical to the monomer compared with that of hydrogen abstraction from PVA facilitates the grafting, although the rate constant of hydrogen abstraction is far smaller than that with the sulfate anion radical by 10⁻⁴ times. Received: 26 April 2001 Accepted: 6 September 2001     

Gas–liquid partition coefficients and Henry's law constants of methyl mercaptan in aqueous solutions of Fe(II)–CDTA chelate complex

Utilization of ferric chelate complex of trans-1,2-cyclohexanediaminetetraacetic acid (CDTA) for the oxidative scrubbing of H₂S and CH₃SH in Kraft mill streams can be beneficial from the standpoints of iron protection against precipitation and oxygen-mediated regenerative oxidation of the ferrous chelate CDTA. The physical solubility of methyl mercaptan in CDTA–Fe(III) complex cannot be measured directly because of oxidation of the sulfur-bearing gaseous species with the ferric chelate. Therefore, this investigation was carried out to determine the gas–liquid partition coefficients and Henry's law constants of methyl mercaptan in aqueous iron-free CDTA solutions and non-reacting ferrous chelate solutions (CDTA–Fe(II) complex), using the static headspace method with an estimated accuracy of about 2%. Experiments with aqueous solutions of chelate concentrations varying between 38 and 300 mol m⁻³ were carried out at temperatures between 298 and 333 K and atmospheric pressure. It was shown that the methyl mercaptan solubility decreases with increasing temperature for all systems but was not much influenced, in the studied conditions, by the chelate concentration especially at larger temperatures.     

负载型非晶态Cu/SiO2催化剂的非晶性质

以超细ＳｉＯ２为载体，用ＫＢＨ４还原Ｃｕ＾２＋盐溶液制备了非负载型Ｃｕ和负载型Ｃｕ／ＳｉＯ２催化剂，ＸＲＤ，ＴＥＭ和电子衍射分析结果表明，负载型Ｃｕ／ＳｉＯ２为完全非晶态，而非负载型Ｃｕ中存在着少量晶态Ｃｕ，ＤＳＣ结果表明，非晶态Ｃｕ／ＳｉＯ２的热稳定性明显高于非负载型Ｃｕ，说明超细ＳｉＯ２具有稳定非晶结构的作用，ＸＰＳ结果表明，还原产物中的铜原子呈Ｃｕ状态，ＩＣＰ分析结果表明，样品中的Ｂ含量均低     

以乙基紫为活性物质的聚氯乙烯膜氰化亚金电极的研制和应用

以碱性染料为活性物质制备２０余种不同组分ＰＶＣ膜Ａｕ（ＣＮ）２＾－电极，确定较佳膜组成为乙基紫０．９９％，邻苯二甲酸二丁酯６９．２％，ＰＶＣ粉２９．８％。该电极对Ａｕ（ＣＮ）２＾－浓度在５．０×１０＾－７￣１．０×１０＾－２ｍｏｌ／Ｌ范围内接近能斯特响应；斜率为５５．７ｍＶ（３０℃）。稳定性与选择性较好。该电极制备简单，使用方便，已成功用于氰化镀金液中金的测定。