甲烷氧化偶联催化剂La2O3／SrCO3—BaCO3的催化活性与表征

在甲烷氧化偶联制Ｃ２烃的研究中，人们发现碱土金属与稀土金属组成的复合氧化物催化剂具有高的催化活性［１，２］．稀土化合物作为有希望的工业催化剂之一，已受到广泛的关注．一般认为，它们含有的氧空位对活化甲烷的有效氧物种有利．Ｄｅｂｅｙ等在１％Ｓｒ／Ｌａ２Ｏ...     

CO2选择性氧化甲烷制C2烃催化剂La2O3/ZnO的氧化还原和CO2吸附性能

Ｌａ２Ｏ３／ＺｎＯ催化剂体系在以二氧化碳作为氧化剂的甲烷氧化偶联反应中具有很高的Ｃ２烃选择性和稳定性．采用ＣＯ２－ＴＰＤ－ＭＳ和ＴＰＲ技术考察了Ｌａ２Ｏ３／ＺｎＯ对ＣＯ２的吸附性质及其氧化还原行为．结果表明：（１）Ｌａ２Ｏ３／ＺｎＯ催化剂体系存在着强、弱两种碱中心，其中弱碱中心数量随样品中Ｌａ２Ｏ３含量增加而减少，强碱中心强度随样品中Ｌａ２Ｏ３含量增加而增强．（２）由于组分相互作用，高温下，Ｌａ２Ｏ３／ＺｎＯ易产生晶格氧空位，使之对ＣＯ２的吸附增强，吸附后的ＣＯ２与晶格氧作用形成立方晶型Ｌａ２Ｏ２ＣＯ３．（３）Ｌａ２Ｏ３／ＺｎＯ表面的Ｌａ３＋和Ｚｎ２＋可以部分被还原，由于组分间的相互作用，使得二者的还原都较单一组分存在时更难．（４）Ｈ２－ＣＯ２－Ｈ２氧化还原循环实验表明，Ｌａ２Ｏ３／ＺｎＯ表面被部分还原后，ＣＯ２可以将部分被还原的表面再氧化．在此基础上对Ｌａ２Ｏ３／ＺｎＯ催化剂上甲烷与ＣＯ２转化为Ｃ２烃的机制也进行了讨论．     

甲醇重整反应中Pt/γ-Al2O3催化剂纳米Pt粒径与催化性能关系研究

利用硝基甲烷还原法在室温条件下得到了纳米Pt粒径可控的担载Pt/γ-Al₂O₃催化剂, 并利用甲醇重整反应为反应探针考察了Pt粒径与催化反应性能之间的关系, 发现催化反应的性能与担载贵金属颗粒粒径之间存在明显的相关性. 通过透射电镜(TEM)、X射线衍射(XRD)、程序升温还原(TPR)等测试手段对催化剂进行表征, 发现钠米Pt的粒径大小不但影响甲醇重整反应的活性, 同时也影响反应的选择性, 即催化剂的催化性能与担载贵金属粒径之间存在明显的尺度效应.     

大气压旋转螺旋状电极辉光放电等离子体催化甲烷偶联

采用新研制的具有旋转螺旋状电极的大气压辉光放电等离子体反应器催化甲烷偶联制碳二烃. 实验采用铜电极和不锈钢电极分别考察了输入电场峰值电压和甲烷、氢气进料流量等参数对甲烷转化率和碳二烃收率、选择性的影响. 在长时间连续反应无明显积碳的情况下, 最佳试验结果是电极材料为金属铜, 进料流量为60 mL•min^-1, V(CH₄ )/V(H₂)=1的条件下, 输入电场峰值电压为2.3 kV时, 甲烷转化率为70.64%, 碳二烃单程收率及其选择性分别为69.85%和 99.14%.     

Ab initio calculation of some low-lying electronic excited states of methane

The energies of some low-lying electronic excited states of methane are calculated by using wave functions built up in terms of plane waves modulated by multicenter Gaussian factors. The wave functions of the various states are evaluated by a two steps iterative process. In the first step, each excited orbital is determined while keeping all other rigid; in the second, rearrangement effects are introduced. Final results are in good agreement with experimental data and allow to enhance an assignement hypothesis for the first electronic transitions.     

碱金属改性Y分子筛的甲苯氧化甲基化反应性能及基酸碱性质

碱金属改性Ｙ分子筛的甲苯氧化甲基化反应性能及其酸碱性质＊周灵萍李伟苏明李赫口亘陶克毅＊＊（南开大学化学系，天津３０００７１）关键词Ｙ型分子筛，甲苯，甲烷，氧化甲基化，苯乙烯，乙苯，酸性，碱性分类号Ｏ６４３／ＴＱ４２苯乙烯和乙苯是重要的化工原料．以往合...     

氧化条件下NOx催化的甲烷均相部分氧化

考察了没有固体催化剂时NOx对甲烷气相氧化的促进作用.实验结果表明，即使在强氧化条件下（O2/CH4=5），NOx对甲烷部分氧化制一氧化碳仍然有明显的催化活性.在CH4-O2体系中加入0.005％～0.2％的NO后，反应温度可降低200-300 ℃.在反应产物中还可观察到甲醛和乙烯，通过改变反应条件可以控制它们的相对浓度.     

Conventional hydrothermal process versus microwave-assisted hydrothermal synthesis of La1−xAgxMnO3+δ (x = 0, 0.2) perovskites used in methane combustion

A study on the synthesis of La_1−xAg_xMnO_3+δ (x = 0, 0.2) using a microwave process (MWhyd) has been carried out by comparing the heating time and reaction temperature with the same factor under conventional thermal process (CHhyd). Experiments have been conducted using the hydrothermal method at medium pressure (T = 200 °C, P = 20 atm) followed by a thermal treatment of the precursor at 700 °C (10 h).Structural and physico-chemical properties of the catalysts were investigated using X-ray diffraction (XRD), BET sorption, temperature-programmed reduction or desorption, mass spectrometry (TPR-MS and TPD-MS), and X-ray photoelectron spectroscopy (XPS). While CHhyd and MWhyd powder catalysts exhibited the same XRD patterns indexed as pure perovskite structure, their surface physico-chemical properties were found to be strongly influenced by the preparation method. The effect of the nature of oxygen species, their amount and mobility, evidenced by temperature programmed experiments, on the catalytic properties in methane combustion in the presence and in the absence of hydrogen sulphide has been studied. MWhyd-La_0.8Ag_0.2MnO_3+δ catalysts were found to exhibit a much better performance in methane combustion together with higher resistance to sulphur poisoning than CHhyd catalysts.     

Solubilization of methane,ethane, propane andn-butane in aqueous solutions of sodium dodecylsulfate

The solubilities of methane, ethane, propane, and n-butane were measured in aqueous solutions of sodium dodecylsulfate (NaDS) (0–0.1M) from 15 to 27°C. From these measurements the standard Gibbs energies, entropies, and enthalpies for the process of transferring the solute molecules from the gaseous phase into the solutions were calculated. An approximate relationship was found relating the volume fraction of the micelles to NaDS concentration.     

Studies on the Performance and Structure of Supported Catalysts for the Partial Oxidation of Methane to Syngas

The catalytic properties of several supported metal catalysts on different carriers were studied in the partial oxidation of methane (POM) to syngas. In our experiment, supported noble metal catalysts exhibited better performance than the other supported transition metal catalysts. The catalyst performances were significantly influenced by the d-electron configuration of the active metal components and the dispersion of active metal components on the support. A catalyst with a moderate number of unpaired electrons in the d-orbital of the active metal support without obvious acidity or redox activity (e.g. MgO) was suitable for POM performance. The Rh/SiO2 catalyst was the best in the POM reaction, among those investigated. Reaction conditions apparently also affected the POM performance of the catalyst. The conversion of methane and the selectivity for CO increased with the reaction temperature, and a high CH4/O2 ratio was not beneficial for POM performance.