铜离子交换改性的沸石催化剂上甲烷的非氧芳构化

已有研究表明，ＭｏＯ３／ＨＺＳＭ５是甲烷非氧芳构化的优良催化剂，在９７３Ｋ下甲烷转化率达６％～８％，苯选择性高于８０％，这为非氧气氛下甲烷的芳构化反应展示了非常诱人的前景［１～１２］．但是，该催化剂的活性和稳定性尚有待进一步提高，目前已有使用Ｐｔ，...     

Vapor pressure,speciation, and chemical activities in highly concentrated sodium borate solutions at 277 and 317°C

The system H₂O-B₂O₃-Na₂O has been studied experimentally at 277 and 317°C. The activities of water and boric acid have been determined at mole ratios Na/B from 0 to 1.5, and total dissolved solids 3 to 80 weight percent. The activity of boric acid has been fitted to within experimental error using a speciation model with eight complex species. This model is consistent with the model previously published by Mesmer et al. The electrolyte properties of the liquid are modeled using the Pitzer-Simonson model of very concentrated electrolyte solutions. The calculated values of water activity agree with experiment, and the activity of NaOH and pOH have also been calculated. The potassium borate system also was briefly studied at 317°C, and is adequately described by a model with five complex species. The potassium borate liquid is more alkaline at K/B= 1 than a sodium borate liquid at the same mole ratio, but pOH in the two systems is the same at lower mole ratios.     

Preparation and catalytic performance of superfine Ni/BaTiO3 catalyst

Superfine Ni/BaTiO₃ catalysts were prepared by impregnation method and used successfully for CO₂ reforming CH₄ to syngas. The effects of preparation method and the temperatures of calcination, reduction and reaction on the catalytic activity of the Ni/BaTiO₃ system were investigated. This revised version was published online in June 2006 with corrections to the Cover Date.     

CuZnAl水滑石衍生催化剂上甲醇水蒸气重整制氢Ⅲ.合成水滑石用金属盐的影响

采用共沉淀法,用不同金属盐为Cu源和Zn源合成了一系列CuZnAl水滑石,以此为前体经600℃焙烧后制得相应催化剂.用硝酸盐和醋酸盐合成的水滑石结晶度高,其衍生催化剂比表面积大、Cu的分散性好且易于还原;而用硫酸盐和盐酸盐合成的水滑石结晶度差,其衍生催化剂比表面积小、Cu的分散性差且不易还原.反应评价结果显示,用硝酸盐和醋酸盐制得的催化剂活性高、反应稳定性好;而用硫酸盐和盐酸盐制得的催化剂由于低的Cu表面积以及S和Cl的毒化作用而几乎无催化活性.在醋酸盐制备的催化剂上,产物干气中CO的浓度明显较低,在250℃和WHSV=3.28 h-1的条件下约为0.03%~0.04%,仅为硝酸盐所制催化剂上CO浓度的1/5;在210℃和WHSV=0.5 h-1的条件下,该催化剂上甲醇几乎完全转化,同时CO浓度降至约0.005%.N2O滴定、CO2程序升温脱附和程序升温还原结果显示,用醋酸盐和硝酸盐制备的催化剂具有极相近的Cu表面积和表面碱性,但前者CuO的还原峰温较后者低近70℃,归因于ZnO与CuO间的强相互作用,这是催化剂具有良好选择性的可能原因.     

Effect of the composition of nickel-containing composites based on stabilised zirconia on catalytic activity in methane steam conversion

A study was carried out on the composition and nature of the stabilizing additive on the activity of nickel-containing composites based on zirconia in the methane steam conversion. The methane conversions were 91–99% on Ni/ZrO₂(Y, Sc, Ce) at 700–800 °C.     

Li—Ni—La—O系复合氧化物催化剂上甲烷氧化偶联的研究

考察了Ｌｉ－Ｎｉ－Ｌａ－Ｏ系催化剂的组成、结构及反应条件对甲烷氧化偶联反应活性的影响。在７８０℃、ＣＨ４：Ｏ２：Ｎ２＝２：１：７、空速１５０００ｈ＾－１时，Ｃ２烃收率可达２５．８％。ＸＲＤ、ＩＲ、ＸＰＳ及ＳＥＭ等的结构分析表明，在ＬｉＬａ１－ｘＮｉｘＯ２催化剂中，当０．１≤ｘ≤０．９时，该催化剂由ＬｉＮｉＯ２和Ｌａ２Ｎｉ１－ｙＬｉｙＯ４－λ两相组成，ｘ＜０．３时出现了ＬｉＬａＯ２相，Ｌａ２Ｎｉ１－     

Comparative study of catalytic activity of Pd loaded hydroxyapatite and fluoroapatite in butan-2-ol conversion and methane oxidation

Palladium loaded calcium-hydroxyapatite, Pd(z)/CaHAp, and calcium-fluoroapatite, Pd(z)/CaFAp, were synthesised and characterised by TEM, XRD, IR and UV–vis–NIR spectroscopies. Introduction of palladium does not change the structure of CaHAp and CaFAp. The average size of PdO particles was found to be around 4–5 nm on Pd(1)/CaHAp but larger (6–7 nm) on Pd(1)/CaFap. The acid–base properties of the supports and of the catalysts were studied using butan-2-ol conversion. On CaHAp and CaFAp, the butenes yield (dehydration reaction) is very low either in the absence or in the presence of oxygen. The methyl ethyl ketone yield (dehydrogenation reaction) is significant only in the presence of oxygen and higher over CaFAp. Conversely, the performances of Pd(z)/CaHAp are better than those of Pd(z)/CaFAp below 180 °C. Above 180 °C, buta-2-ol combustion is favoured on Pd/CaHAp but not on Pd/CaFAp.

In methane oxidation, Pd(z)/CaHAp showed also a much larger activity than Pd(z)/CaFAp. On 2 wt% Pd loaded CaHAp, the methane oxidation reaches a conversion of almost 100% at 350 °C, which is comparable with the performance of conventional Pd/Al₂O₃ catalysts. The reducibility of PdO under methane–oxygen mixtures is lower on Pd(z)/CaHAp. For both reactions, the lower activity of Pd(z)/CaFAp is related to its higher acidity, resulting from the substitution of OH⁻ by F⁻, and to the larger PdO particle size.     

Selective Oxidation of Methane to Methanol Using Molecular Oxygen on MoOx／（LaCoO3＋Co3O4） Catalysts

Comparatively high CH3OH selectivity (60.0%) and yield (6.7%) were obtained on MoOx/(LaCoO3 Co3O4) catalysts in selective oxidation of methane to methanol using molecular oxygen as oxidant. The interaction between MoOx and La-Co-oxide modified the molecular structure of molybdenum oxide and the ratio of O^-/O^2- on the catalyst surface, which controlled the catalytic performance of MoOx/(LaCoO3 Co3O4) catalysts.     

甲烷二氧化碳介质阻挡放电转化产物分布研究

针对介质阻挡放电甲烷二氧化碳转化实验,分析了反应的产物分布,探讨了进料组成和反应器结构对反应的影响.反应产物包括:高H2/CO摩尔比的合成气、气态烃、高辛烷值的汽油组分、醇和酸等含氧有机物.对所述电极结构,产物的选择性随碳数增加而降低;高的甲烷进料浓度有利于烃的生成,对醇和酸的最佳甲烷进料体积分数范围在67.4％～75.1％;放电间隙越小,原料转化率和烃、酸的选择性越大,大的放电间隙对醇的生成有利.