Selective Oxidation of Methane to Methanol Using Molecular Oxygen on MoOx／（LaCoO3＋Co3O4） Catalysts

Comparatively high CH3OH selectivity (60.0%) and yield (6.7%) were obtained on MoOx/(LaCoO3 Co3O4) catalysts in selective oxidation of methane to methanol using molecular oxygen as oxidant. The interaction between MoOx and La-Co-oxide modified the molecular structure of molybdenum oxide and the ratio of O^-/O^2- on the catalyst surface, which controlled the catalytic performance of MoOx/(LaCoO3 Co3O4) catalysts.     

甲烷二氧化碳介质阻挡放电转化产物分布研究

针对介质阻挡放电甲烷二氧化碳转化实验,分析了反应的产物分布,探讨了进料组成和反应器结构对反应的影响.反应产物包括:高H2/CO摩尔比的合成气、气态烃、高辛烷值的汽油组分、醇和酸等含氧有机物.对所述电极结构,产物的选择性随碳数增加而降低;高的甲烷进料浓度有利于烃的生成,对醇和酸的最佳甲烷进料体积分数范围在67.4％～75.1％;放电间隙越小,原料转化率和烃、酸的选择性越大,大的放电间隙对醇的生成有利.     

Oxidation kinetics of timahdit and tarfaya moroccan oil shales

Organic matter evolution and kinetics of combustion of Tarfaya and Timahdit oil shales have been examined by thermogravimetry (TG) and by differential thermal analysis (DTA). An agreement is observed between both techniques where it was found that combustion of organic matter occurs in two steps. Kissinger's method applied on experimental results gives an activation energy of the same magnitude for the first step of both oil shales (103 kJ mol^–1) whereas the second is 148 kJ mol^–1 for Timahdit and 118 kJ mol^–1 for Tarfaya.The changes in specific surface area during thermal combustion of Timahdit and Tarfaya oil shales have been studied by thermogravimetric gas sorption balance and correlated with experimental results obtained on TG/DTA in air. For Timahdit oil shale oxidation products, specific surface areas calculated from nitrogen adsorption data shows a slight increase during the temperature domain of 280 to 430°C and after this temperature, they increase sharply. However, data obtained with Tarfaya oil shales shows a significant increase at the temperature of maximum oxidation of the first stage of combustion of organic matter.This revised version was published online in November 2005 with corrections to the Cover Date.     

Physico-Chemistry of the Limestone Sulphation Process

Aspects of the mechanism of the overall reaction between CaCO₃/CaO and SO₂/SO₃ under oxidizing conditions are discussed. The limestone and lime sulphation processes were carried out in a thermobalance under conditions relevant to atmospheric fluidized bed combustion. Sulphated samples, prepared in the form of cross-section particles, were examined in a scanning electron microscope by energy-dispersive X-ray and back-scattered electron imaging. Photomicrographs are presented. The reaction proceeded from the outer surface of the particles and along the pores. Surface textural changes during the reaction were considered. The layer of products was identified as controlling both the rate and extent of limestone/lime sulphation. In the products, two sulphur-bearing solids (CaSO₄ and CaS) were identified. The presence of CaS, which may cause difficulties in practice, is attributed to CaSO₃ disproportionation. This revised version was published online in August 2006 with corrections to the Cover Date.     

Mg改性对Co/γ-Al2O3-TiO2催化燃烧丙烷性能影响

采用分步浸渍法制备了系列Mg改性的Co/γ-Al_2O_3-TiO_2催化剂,通过X射线衍射(XRD)、紫外可见漫反射光谱(DR-UV-vis)、N_2吸附-脱附(BET)、X射线光电子能谱(XPS)和H_2程序升温还原(H_2-TPR)等技术对催化剂进行表征,并考察了其对丙烷燃烧的催化性能。结果表明,Co在原始γ-Al_2O_3-TiO_2载体和Mg改性MgO/γ-Al_2O_3-TiO_2载体上均以Co_3O_4的形式存在;Mg掺入后与Al_2O_3作用形成MgAl_2O_4尖晶石,改善了载体的织构性质,提升了Co_3O_4在催化剂载体表面的暴露数量和分散程度。此外,MgAl_2O_4与Co_3O_4相互作用提升了Co_3O_4颗粒表面Co~(3+)/Co~(2+)和O_(ads)/O_(latt)的比例,并削弱了Co-O键键能,从而提升了其对丙烷的催化燃烧活性。当Mg负载量为15%(质量分数)时,在Co/MgO(15%)/γ-Al_2O_3-TiO_2催化剂上进行丙烷燃烧,丙烷90%转化率的温度比无Mg掺杂的Co/γ-Al_2O_3-TiO_2催化剂的降低了45℃,并且连续反应40 h其活性保持稳定。     

甲烷在Mo/HZSM-5催化剂上的脱氢聚合反应

对不同Mo含量的Mo／HZSM－5催化剂的结构进行了表征，并对这些催化剂的甲烷非氧气氛下的转化反应进行了考察．催化剂的BET比表面积及酸性随Mo含量的增加而降低，当Mo含量大于5％时，Mo对ZSM－5分子筛的晶型有影响，并出现MoO3物相．甲烷在700℃时可高选择性地生成苯和乙烯，最佳Mo含量大约为2％．纯的MoO3或HZSM－5上该反应几乎不进行，因此，可能是分散的钼氧离子和分子筛的酸中心是甲烷转化的活性中心，只有二者的协同作用才能促进甲烷的转化．反应后催化剂中的钼物种被还原了．催化剂上的积炭可能是催化剂失活的主要原因之一，烧炭后催化剂活性基本恢复．     

Effect of water in the precursor solution on the catalytic property of LaMnAl11O19 high temperature combustion catalyst

Manganese-substituted lanthanum hexaaluminates were prepared by the sol-gel method. The effect of water content on the catalyst preparation was examined. Large water content caused a rapid decrease in the surface area. When the R (R is the mole ratio of H₂O/ Al(OC₃H₇)₃) is equal to 1.5, the catalyst retains a specific surface area of 13.5 m² g⁻¹ and shows higher activity in CH₄ combustion.     

甲烷氧化细菌催化二氧化碳生物合成甲醇的研究

甲烷氧化细菌中包含的甲烷单加氧酶(MMO)、甲醇脱氢酶(ADH)、甲醛脱氢酶(FaldDH)、甲酸脱氢酶(FateDH)经过一系列反应能够把甲烷深度氧化生成二氧化碳，并生成一定的能量物质．把二氧化碳还原为甲醇是一个需要能量的过程，目前还没有已知的有机体在温和条件下完成这一反应．研究发现，甲基弯菌Methylosi-nus trichosporium IMV 3011可以催化二氧化碳生物转化生成甲醇．在休眠的悬浮细胞中充人二氧化碳后，反应一段时间在反应液中检测到了甲醇．二氧化碳转化成甲醇是一个需要能量推动的反应，为了补充反应所消耗的能量．反应一段时间后需要用甲烷进行再生，以恢复细胞中的还原当量NADH．我们进行了反应再生的交替连续批式反应，甲醇积累量能够维持在一个比较稳定的水平．理论上，反应不会增加温室效应，这是一个有效的、环境友好的、可恢复的反应过程．     

沥青热解残炭的燃烧特性

与轻质油品(汽油、柴油等)燃烧特性不同,重质燃料油在燃烧时,首先发生燃料的热分解,分解的产物扩散到气相空间发生着火、燃烧,最后剩下固体残炭,然后残炭再着火、燃烧,由于残炭的燃烧属于异相反应,比燃料气与空气的同相反应慢,导致其燃尽时间明显变长,文献[1]给出了沥青和十二烷单滴的燃烧过程温度变化曲线,从曲线可以看出,残炭的燃烧阶段明显比气体的燃尽时间长,而残炭的质量只为沥青质量的10%～20%[2,3]。虽然残炭含量低,但它在整个燃烧过程中占有十分重要的地位;文献[4]利用热重系统研究了渣油热加工的副产物石油焦的燃烧特性,主要从…