Trapping Copper Phthalocyanine in a Silica Sono-Xerogel

A copper phthalocyanine (CuPc) has been encapsulated in silica. The trapping effects were studied comparing the UV-Vis absorption spectra of some CuPc solutions and composites prepared under different conditions. The trapped organic molecules’ stability was monitored during the gelation and drying processes. Leachability test have been carried out with the aim of checking the trapping efficiency. Hydrolysis water of pH=2 and a molar ratioR _w =6 mol acid H₂O/mol TMOS leads to a higher CuPc stacking angle homogeneity. The increase of Pc induces a narrower mesopore distribution and helps the stabilization of the composite.     

蒙脱石-石墨-聚氯乙烯复合电极测定制药废水中苯酚

报道了当制药废水PH8．0时，用蒙脱石－石墨－聚氯乙烯复合电极可以直接测定苯酚的含量而不受水杨酸存在的干扰，苯酚浓度在1．0μg/mL-25.0μg/mL范围内峰电流与浓度有良好的线性关系，I＝1．262c-0.046，相关系数r=0.998，检出限为0．1μg/mL，用该方法测定模拟制药废水中苯酚，其平均回收率为101．7％。     

Pervaporation separation of alkane/thiophene mixtures with PDMS membrane

Worldwide concerns over environment have stimulated increasing interest both in academic and industry for deep desulfurization of gasoline. Polydimethylsiloxane (PDMS) composite membrane was used to separate the binary and multicomponent alkane/thiophene mixtures by pervaporation. Effect of carbon number and concentration of alkane, and of feed temperature, on the separation efficiency of alkane/thiophene mixtures was investigated experimentally. Experimental results of binary mixtures indicated that the total fluxes for different alkane/thiophene mixtures decrease with increase of carbon number in the alkanes. Corresponding activation energies of permeation for alkanes in PDMS membrane increase with increase of carbon number in the alkanes. Differences of molecular size and structure of the alkanes lead to various selectivities thereof within PDMS membrane. In addition, the permeability and activation energy of thiophene in various systems differ from each other due to coupling effect which should be taken into consideration when dealing with multicomponent systems. Pervaporation results of ternary systems indicated that, the increase of content of lighter alkane in feed would result in a larger total flux, but a smaller selectivity to thiophene simultaneously. A quaternary system, the mixture of n-heptane, n-octane, n-nonane and thiophene, was employed to simulate the desulfurization process of gasoline. With the membrane having a PDMS layer of 11 μm, the total flux was measured to be about 1.65 kg/m² h, with the corresponding enrichment factor of thiophene 3.9 at 30 °C.     

Mesoporous amorphous MnO<Subscript>2</Subscript> as electrode material for supercapacitor

A kind of novel mesoporous, electrochemical active material, amorphous MnO₂ has been synthesized by an improved reduction reaction and using supramolecular as template. The synthesized sample was characterized physically by thermogravimetric analysis, X-ray diffraction, transmission electron microscope (TEM), and Brunauer–Emmett–Teller (BET) surface area measurement, respectively. Electrochemical characterization was performed using cyclic voltammetry and chronopotentiometry in 2 mol/l KOH aqueous solution electrolyte. The results of BET and TEM analysis indicated that supramolecular template plays an important role in the process of big specific surface area mesoporous material forming. After sintering at 200 °C, the sample still remained an amorphous structure, and its specific capacitance reached 298.7 F/g and presented a very stable capacitance after 500 cycles. In addition, the electrochemical process, such as ion transfer and electrical condition, was also investigated with electrochemical impedance spectroscopy.     

Preparation, phase transformation and photocatalytic activities of cerium-doped mesoporous titania nanoparticles

Cerium-doped mesoporous TiO₂ nanoparticles with high surface area and thermal stable anatase wall were synthesized via hydrothermal process in a cetyltrimethylammonium bromide (CTAB)/Ti(SO₄)₂/Ce(NO₃)₄/H₂O system. The obtained materials were characterized by XRD, FESEM, HRTEM, FTIR spectroscopy, nitrogen adsorption and DRS spectra. Experimental results indicated that the doping of cerium not only increased the surface area of mesoporous TiO₂ nanoparticles, but also inhibited the mesopores collapse and the anatase-to-rutile phase transformation. Moreover, the undoped, doped anatase mesoporous nanoparticles exhibit higher photocatalytic activity than commercial photocatalyst (Degussa, P25), but the maximum photodegradation rate corresponds to the undoped mesoporous TiO₂ nanoparticles. The lower photocatalytic activities of cerium-doped samples compared with undoped one may be ascribed to that the doped cerium partially blocks titania's surface sites available for the photodegradation and absorption of Rhodamine B (RB).     

Mass transfer determining parameter in facilitated transport through di-(2-ethylhexyl) dithiophosphoric acid activated composite membranes

Activated composite membranes (ACMs) containing di-(2-ethylhexyl) dithiophosphoric acid (D2EHDTPA) as a carrier have been found to facilitate the transport and separation of several cations. This paper describes an approach to the chemical characterisation of the transport phenomena of Zn²⁺, Cd²⁺, Cu²⁺, Ni²⁺, Sn²⁺ and In³⁺ by an ACM. The selectivity of D2EHDTPA based ACM towards different metal ions is presented and discussed focusing in Zn²⁺ and Cd²⁺ transport and recovery. Selectivity demonstrates that zinc ions are removable from mixtures due to the different extraction strength of D2EHDTPA. Such selectivity is based on the differences of the dynamic behaviour of the metal ions transport. In addition, a correlation of the chemical behaviour of those ACM systems with the corresponding solvent extraction systems has been found.     

Polyamide thin film composite membrane prepared from m-phenylenediamine and m-phenylenediamine-5-sulfonic acid

Thin film composite (TFC) membranes based polyamide were prepared with m-phenylenediamine (MPD), m-phenylenediamine-5-sulfonic acid (SMPD) and trimesoyl chloride (TMC) through interfacial polymerization technique on the polysulphone supporting film. The membranes were characterized using permeation experiments with salt water, attenuated total reflectance infrared (ATR-IR) and X-ray photoelectronic spectroscopy (XPS) as well as scanning electronic microscopy (SEM). This study has shown that the active layer of TFC membrane is aromatic polyamide, including sulfuric acid function group (-SO₃H) according to the result of ATR-IR and XPS. The NaCl rejection of RO membranes decreased and the flux increased when W_SMPD/W_MPD increased from 0 to 1, and the linear part with pendant -COOH in membrane barrier layer increased with the increase of SMPD content, but the surface of membrane becoming smoother and smoother with the increase of SMPD content. So the membranes performance mainly was determined by chemical structure in their barrier layer.     

AES investigations on starting powders for high performance ceramics

AES depth profiles on ceramic powders (untreated/hydrolyzed/oxidized/ (Al, Y)₂O₃ coated Si₃N₄, [BaO, SiO₂] coated Al₂O₃) are feasible on thin, homogeneous layers or m sized agglomerations prepared on an Au foil. By means of the depth profiles one can qualitatively characterize the coating around the particles. Factor analysis of the depth profiles on the differently treated Si₃N₄ powders suggests the existence of an Si₂N₂O phase on the oxidized sample.Dedicated to Professor Günther Tölg on the occasion of his 60th birthday     

Preparation and application of Ce-doped mesoporous TiO2oxide

Summary Mesoporous TiO₂-CeO₂mixed oxides (m-TiO₂-CeO₂) were synthesized under easy-operating neutral conditions. The structure was characterized by means of FT-IR, XRD, and N₂adsorption methods. For methanol decomposition to CO and H₂, the catalytic activity of the Ru/ m-TiO₂-CeO₂ catalyst was higher than that of the Ru/ m-TiO₂.</o:p>     

用双表面活性剂为共模板合成中孔分子筛MCM-48

利用水热法以非离子表面活性剂聚乙二醇辛基苯基醚和阳离子表面活性剂十六烷基三甲基溴化铵为共模板合成了中孔分子筛MCM-48.实验中发现利用较强的范德华力和氢键,聚乙二醇辛基苯基醚可在很大程度上降低合成MCM-48所需阳离子表面活性剂的用量,且利于制备有序性好、骨架聚合度高、稳定性好的MCM-48.通过调节聚乙二醇辛基苯基醚与十六烷基三甲基溴化铵的比例,可得到不同物相结构的分子筛.