Optimization of tetramethoxysilane-derived sol gel entrapment protocol stabilizes highly active chlorophyllase

Entrapment of membrane proteins is a challenging task compared to that involving soluble proteins. Chlorophyllase, a membrane protein, was successfully entrapped in tetramethoxysilane-derived sol-gel. Pre-gel sol typically consists of an aqueous suspension of chlorophyllase, precursors including tetramethoxysilane and/or methytrimethoxysilane, and sodium fluoride as catalyst. To obtain a highly active entrapped enzyme preparation, the effects of various immobilization parameters, including the chemical compositions of pre-gel sol (water/silane ratio, precursor type and proportions, enzyme loading, sodium fluoride concentration), and sol-gel process parameters (aging and drying time and approach) have been investigated. Chlorophyllase demonstrated the highest activity in gel derived from a pre-gel sol with water/silane ratio of 30 and enzyme loading of 0.257 mg_protein/g_gel, and showed moderately lower activity in organically modified sol-gel than that in hydrophilic sol-gel. The effects of water/silane ratio and precursor combinations on the activity of entrapped chlorophyllase were also studied by examining the pore morphology of gel via nitrogen adsorption-desorption. Longer aging time leads to an entrapped chlorophyllase preparation with higher activity. Chlorophyllase preparation demonstrated negligible activity after air-drying for 12 h while lyophilized chlorophyllase preparation demonstrated 8, 4 and 4 times higher activity than air-dried, vacuum-dried and solvent-dried preparations. Chlorophyllase demonstrated 30% higher activity in the improved sol-gel protocol than that from a non-optimized sol-gel protocol developed in a previous study.     

The relaxation field for the general case of electrolyte mixtures

The relaxation field for solutions of mixed electrolytes of any type is calculated. the calculation is based on the well-known treatment due to Fuoss-Onsager with the same distance parameter for all the ions in solution. A general conductance-continuity equation has been established and an improved iterative method of calculation, using Laplace transforms, is proposed. The relaxation-field results are derived to the second iteration in the perturbation method of integration.     

Interactions of dicarboxylic porphyrins with membranes in relation to their ionization state

The interactions of dicarboxylic porphyrins with membrane systems are discussed with particular emphasis on the effect of the charge of the porphyrin and the nature of the side-chains. The incorporation of hematoporphyrin or related dicarboxylic porphyrins within small unilamellar vesicles as membrane models is favored by a decrease of the pH in the range of physiological pH values. This effect might play an important role in the retention of porphyrins by tumors, which are more acidic than normal tissues. Kinetics studies also show that the partition of the porphyrin between the lipidic bilayer and the aqueous phase is governed by its release rate rather than by its incorporation rate.     

Conductance of tetraalkylammonium salts in 2-butanone from −45 to 25°C

Interactions of three types of tetraalkylammonium cations (tetrapropyltetrabutyl-and tri-isoamylbutyl- ammonium) with perchlorate and tetraphenylborate anions were studied by the conductivity method in 2-butanone from –45°C to 25°C. Conductance data obtained for diluted solutions (5×10^–5 – 2×10^–3 mol-dm^–3) were used to calculate the limiting molar conductivities and associationconstants. The conductance equation of Fuoss-Hsia including the Chen term and the chemical model assumption were applied. Limiting ion conductivities were calculated assuming equal limiting conductivities of the i-Am₃BuN⁺ and BPh ₄ ^– ions at all temperatures. Gibbs energies and entropies of ion pair formation, calculated from the dependence of association constants on temperature, are presented including the contributions due to short-range forces.     

Ionization of five aqueous fluorobenzoic acids: Conductance and thermodynamics

The three monofluorobenzoic acids together with 2,4-difluoro and 2,6-difluorobenzoic acids in aqueous solution are the subject of precision conductance measurements. The experimental data are analyzed to give ionization constants and limiting conductances at temperatures from 0 to 100°C. Walden products for the acid anions are derived from the limiting conductances while the ionization consatants are fitted by statistical methods to the function pK _a (m)=A+B/T+ C logT+DT. Only the 2,6- acid requires the fourth term of the function to fit the data to a precision of better than 0.03%. Mathematical analysis of the pK function gives the standard changes in enthalpy, entropy, and heat capacity. All the acids studied are more acidic than the parent, benzoic acid, as well as more acidic than the isoelectronic methylbenzoic acids. In general the increased acidity is tied to decreases in enthalpy while entropy changes on ionization differn little from those found for the parent acid.     

Synthesis and characterisation of poly[2,2-(m-phenylene)-5,5-bibenzimidazole] as polymer electrolyte membrane for high temperature PEMFCs

Intermediate-high molecular weight poly[2,2-(m-phenylene)-5,5-bibenzimidazole] has been produced by mixing 3,3′,4,4′-tetraminobiphenyl and isophthalic acid in polyphosphoric acid as polycondensing agent and triphenyl phosphite as catalyst. Polymers with intrinsic viscosities close to 1 were measured in 97% sulphuric acid. Membranes were prepared by solution casting and subsequently immersed in phosphoric acid in order to gain ionic conductivity. These membranes were characterised by Fourier transform infrared spectroscopy, X-ray diffraction, thermogravimetric analyses, methanol permeation and conductivity measurements. Levels of acid and water absorbed by the membranes were measured and the kinetic of this process was studied. Finally, doped membranes were tested in an actual fuel cell setup, obtaining also information about gases crossover from the open circuit potential. Acceptably reproducible molecular weights between 115,000 and 190,000 were obtained allowing the casting of mechanically stable membranes, which showed a great affinity towards phosphoric acid, high thermal stability, and a conductivity of 0.039 S/cm at 190 °C with the membrane equilibrated in saturated air at 60 °C. Open circuit potential of a PBI membrane was 0.99 V, close to those of commercial perfluorinated membranes. A H₂/O₂ fuel cell with dry gases was able to produce a maximum power output of 0.22 W/cm² at 175 °C.     

Dehydration of tetrafluoropropanol (TFP) by pervaporation via novel PBI/BTDA-TDI/MDI co-polyimide (P84) dual-layer hollow fiber membranes

A novel PBI/P84 co-polyimide dual-layer hollow fiber membrane has been specifically fabricated through the dry-jet wet phase inversion process, for the first time, for the dehydration pervaporation of tetrafluoropropanol (TFP). Polybenzimidazole (PBI) was chosen as the outer selective layer because of its superior hydrophilic nature and excellent solvent-resistance together with robust thermal stability, while P84 co-polyimide was employed as the inner supporting layer because of its good solvent-resistance and thermal stability. The PBI/P84 membrane exhibits superior water selectivity and relatively high permeation flux. At 60 °C, the PBI/P84 dual-layer hollow fiber membrane shows a permeation flux of 332 g/(m² h) and a separation factor of 1990 for a feed solution containing of 85 wt% TFP. The preferential water sorption and the significant diffusivity difference between TFP and water are the main causes of high separation factor. However, an increase in feed temperature will greatly increase the permeation flux but seriously decrease the water selectivity. The activation energy data verify that water can preferentially permeate the PBI membrane due to the strong water affinity of PBI and a much smaller molecular size of water.     

Statistics of transfer matrices for disordered quantum thin metallic slabs

In the quantum transport problem of a tight-binding Anderson model, the statistics of eigenvalues for the transfer matrices of thin disordered slabs is studied. Numerical simulations indicate that the probability distribution of nearest neighbor eigenvalue spacing and the ₃ statistics have already become close to that of the Gaussian orthogonal ensemble for sample lengths of the order of the mean free path, provided that transverse localization effects are not important. An intuitive argument is given why this should occur independently of the size of the matrix. Therefore, good mixing of the channels is not essential for obtaining Gaussian orthogonal ensemble type statistics and universal conductance fluctuations.     

A novel composite chitosan membrane for the separation of alcohol-water mixtures

A novel alcohol dehydration membrane with a three layer structure has been prepared. The top layer is a thin dense film of chitosan (CS), and the support layer is made of microporous polyacrylonitrile (PAN). Between the dense and microporous layer, there is an intermolecular cross-linking layer. This novel composite membrane has a high separation factor of more than 8000 and a good permeation rate of 0.26 kg/m² h for the pervaporation of 90 wt% ethanol aqueous solution at 60°C, 0.8 kg/m² h flux for a n-PrOH/water system and around 1 kg/m² h flux for an i-PrOH/water system using 80 wt% alcohol concentration at 60°C. The separation factor for both cases is more than 10⁵. The separation performance varies with feed composition, operating temperature and conditions of membrane preparation. The results show that the separation factor and flux of this membrane increase with raising the operating temperature. At the same time, the crosslinking layer improves durability of the composite membrane, and the pervaporation performance can be adjusted by changing the structure of the cross-linking layer. The cross section of the composite membrane has been examined by SEM.     

Conductance Study of Binding of Some Rb+ and Cs+ Ions by Macrocyclic Polyethers in Acetonitrile Solution

A conductance study of the interaction between Rb+ and Cs+ ions and18-crown-6 (18C6), dicyclohexyl-18-crown-6 (DC18C6), dibenzo-18-crown-6 (DB18C6),dibenzo-24-crown-8 (DB24C8), and dibenzo-30-crown-10 (DB30C10) inacetonitrile solution has been carried out at various temperatures. The formationconstants of the resulting 1:1 complexes were determined from the molarconductance-mole ratio data and found to vary in the orderDC18C6 > 18C6 > DB30C10 > DB18C6 DB24C8for Rb+ ion andDC18C6 > 18C6 > DB30C10 DB24C8 > DB18C6for Cs+ ion. The enthalpy and entropy of complexation were determined fromthe temperature dependence of the formation constants. The complexes with the18-crowns are both enthalpy and entropy stabilized while, in the case of largecrown ethers, the corresponding complexes are enthalpy stabilized but entropydestabilized.