Ultrasound-assisted facile one-pot synthesis of ternary MWCNT/MnO2/rGO nanocomposite for high performance supercapacitors with commercial-level mass loadings

Commercial application of supercapacitors (SCs) requires high mass loading electrodes simultaneously with high energy density and long cycle life. Herein, we have reported a ternary multi-walled carbon nanotube (MWCNT)/MnO₂/reduced graphene oxide (rGO) nanocomposite for SCs with commercial-level mass loadings. The ternary nanocomposite was synthesized using a facile ultrasound-assisted one-pot method. The symmetric SC fabricated with ternary MWCNT/MnO₂/rGO nanocomposite demonstrated marked enhancement in capacitive performance as compared to those with binary nanocomposites (MnO₂/rGO and MnO₂/MWCNT). The synergistic effect from simultaneous growth of MnO₂ on the graphene and MWCNTs under ultrasonic irradiation resulted in the formation of a porous ternary structure with efficient ion diffusion channels and high electrochemically active surface area. The symmetric SC with commercial-level mass loading electrodes (∼12 mg cm⁻²) offered a high specific capacitance (314.6 F g⁻¹) and energy density (21.1 W h kg⁻¹ at 150 W kg⁻¹) at a wide operating voltage of 1.5 V. Moreover, the SC exhibits no loss of capacitance after 5000 charge−discharge cycles showcasing excellent cycle life.     

Normal Coordinate Analysis of Pyridine-N-Oxide

We have been interested for some time in the study of the hydrogen bonded complexes in the far-infrared region with special attention to the adducts between phenol and pyridine-N-oxides (1). In such systems the intermolecular mode vσ was identified and some intramolecular vibrations related to the N-O group were observed to be remarkably shifted consequent on hydrogen bonding. In this context we wished to obtain a force field for the complex which could fit the observational results. Unfortunately for one of the constituents i. e. pyridine-N-oxide a force field, suitable for our purposes, was not available and therefore preliminarily we determined it. We report here the results of such analysis.     

锰结核中硅,铝,铁,镁,磷,钾,锰,钛的XRFA

本文叙述了用XRF分析锰结核中Si、Al、Fe、Mg、P、K、Mn和Ti的方法。按照通常锰结核的主次成分制备6个人工合成标准,根据Sherman方程计算了已知成分(二元系统)的相对强度。用L-T方求得了互致元素校正的理论α系数(基本的、混合的、修正的),用DATAFLEX151B计算机以BASIC语言汇了“PRA,APU”计算机程序。然后进行非线性回归分析了锰结核样品得到了满意的结果。     

一维锰氧化物纳米棒在以O2为氧源的苯甲醇氧化反应中的催化性能

采用水热法合成MnOOH一维纳米线,通过MnOOH在不同气氛和温度中煅烧得到尺寸和形貌相似的不同锰氧化物,并用于以O₂为氧源的苯甲醇液相氧化反应. 结果表明,MnO₂对苯甲醇氧化反应具有较高的催化活性. 通过XPS、SEM、TEM和H₂-TPR等手段对催化剂的形貌和结构进行了表征,并讨论了可能影响反应活性的一些因素. MnO₂的良好催化性能可能与其晶格氧具有较高的迁移率以及氧化还原能力有关. 通过简单的焙烧处理,可以使MnO₂催化剂在苯甲醇氧化反应中具有良好的重复使用性.     

锰(Ⅱ)-高碘酸钾-灿烂绿体系测定水中痕量锰

在 HAc- Na Ac环境中 ,锰 ( )对于高碘酸钾氧化灿烂绿的反应具有很强的催化作用。据此 ,建立了催化动力学光度法测定痕量锰 ( )的新方法。该方法的检出限为 2 .2 2× 10 -11g/ m L ,测定线性范围为0 .1— 12 ng/ m L。直接用于环境水样中锰的测定 ,获得满意的结果     

ICP-AES测定饮用水源中的Cu、Mn、Pb、Cd、Zn

用ICP－AES法同时测定饮用水源中的Cu、Mn、Pb、Cd、Zn等重金属元素，具有基体效应小、测量范围宽等优点。检出限为0．2－4．0μg/L，回收率为91．5％－103．9％，相对标准偏差为0．29％－1．5％，测定密码样与实际样品，结果令人满意。     

非有机溶剂萃取催化光度法测定锰Mn(Ⅱ)-H2O2-EBT-PEG-2000体系

研究了碱性介质中,利用锰(Ⅱ)催化过氧化氢氧化铬黑T的指示反应。用聚乙二醇-2000非有机溶剂萃取平衡控制反应时间和指示反应进行的程度。通过测量酸性条件下539nm处聚乙二醇-2000相的吸光度,建立了非有机溶剂萃取催化光度法测定痕量锰(Ⅱ)的新方法。方法的线性范围为0.0080~0.55μg.mL-1,检测限为3.0×10-9g.L-1,可用于铝合金、茶叶样品中锰的测定。     

ICP－AES法同时测定电解金属锰中的硅、铁、硒和磷

本文研究了用ＩＣＰ－ＡＥＳ直接测定电解金属锰中的Ｓｅ、Ｐ、Ｓｉ、Ｆｅ等元素的方法，方法简便、快速，精密度和准确度均能满足对出口电解金属锰的检验要求。     

Influence of Fe-doping on the microstructure and electromagnetic performance of manganese oxides

A simple wet chemical method was used to synthesize Fe-doped MnO₂ composites with iron amount ranging from 0 to 90 M percent. X-ray diffraction, electron probe micro-analyzer, scanning electron microscopy and vector network analyzer were employed to investigate the effect of iron doping on the microstructure and electromagnetic performance of the as-synthesized samples. Results indicate that relative small content of Fe-doping cannot change the α-MnO₂ structure but can promote the formation of hollow-structural morphology. The as-obtained products are transformed into a novel compound (Fe_0.67Mn_0.33)OOH with the increase of Fe-doping to 30 mol%. The possible formation mechanism was proposed in detail. Compared with the pure MnO₂, the Fe-doped samples exhibit decreased dielectric loss but increased magnetic loss with increasing the iron content below 20 mol% while relatively poor electromagnetic properties with the iron content above 30 mol%.     

锰基钙钛矿多层膜中的层间相互作用

本文采用直流磁控溅射方法在(100)取向的LaAlO3基片上制备了系列多层膜: La0.67Ca0.33MnO3-δ/La0.67Sr0.33MnO3-δ/La0.67Ca0.33MnO3-δ (LC/LS/LC).并采用标准四探针方法对所制备样品的阻温关系进行了测量. 结果表明:在零场下,当上下两层厚度一定时,随着中间层(LS)厚度增加,多层膜的电阻率减小,金属-绝缘体转变温度(TM-I)向高温方向移动.在中间层(LS)厚度保持一定时,随着上下两层(LC)厚度增加,其电阻率和金属-绝缘体转变温度(TM-I)出现同样的变化规律.基于双交换理论,我们对以上结果给出了尝试性解释.