微色谱柱分离/ICP-AES测定环境样品中的痕量硼

本文采用色谱系统对水样品（温泉水、卤水）中的硼进行分离富集，探讨了影响其分离富集的条件。实验表明，在pH＝8条件下，硼可被树脂完全吸附，用3mL 1mol/L硫酸可以从吸附术上完全解吸硼，浓缩物用ICP－AES进行测定，所建立的方法简便、准确，适合于含盐量高及其它水样品中微量硼的测定。     

有机溶剂对镧和钇ICP光谱信号的增敏机理研究

本文考察了有机溶剂（乙酸丁酯）及有机试剂（PMBP）引入ICP－AES对稀土元素镧和钇光谱信号的影响。实验结果表明，有机溶剂的引入明显增大了待测物的传质效率，从而导致分析灵敏度的改善。与水相相比，有机相的引入对ICP激发温度未产生明显影响，但使线对强度比（LogI^ /I)增强，有利于待测物的电离。     

Simultaneous determination of hydride (Se) and non-hydride-forming (Ca,Mg, K,P, S and Zn) elements in various beverages (beer,coffee, and milk), with minimum sample preparation,by ICP–AES and use of a dual-mode sample-introduction system

A method has been developed enabling direct analysis (i.e. after dilution only) of beer, instant coffee, milk, and milk powder by ICP–AES. Analysis of the beverages after dilution with a low concentration of HNO₃ was used for accurate determination of essential minor and trace elements (Ca, Mg, K, P, S, and Zn). Selenium, introduced as the hydride, was determined simultaneously with the other non-hydride-forming elements using the commercial multi-mode sample-introduction system (MSIS). To obtain accurate results, however, some simple pre-treatment was needed. Analysis was also performed after microwave-assisted decomposition of the samples. Three different modes of sample-preparation, i.e. dilution only, partial decomposition (aqua regia treatment), and complete decomposition were compared. The results obtained by use of the three different sample-preparation methods were in very good agreement. Results from analysis of certified reference material (SRM 1459 non-fat milk powder) also verified the accuracy of the methods. The limit of detection obtained for Se using dual-mode sample introduction was 0.5 ng mL^–1, which corresponds to approximately 2 ng g^–1 in beer and approximately 4 ng g^–1 in coffee and milk when using the recommended procedure.     

Grain boundary diffusion coefficients in gold–nickel thin films

Polycrystalline gold–nickel thin films are deposited on silicon (111) wafers by evaporation in a vacuum of 2 × 10^?6 mbar. Concentration profiles of heat‐treated specimens are obtained by Auger electron depth profiling. The heat treatments are carried out in a vacuum furnace of 4 × 10^?6 mbar in the temperature interval 473–773 K. The grain boundary diffusion coefficient is determined, using a modified Wipple model, to be (3 × 10^?4 cm² s^?1) exp (?0.94 eV kT^?1). It is concluded that interdiffusion in the investigated system is characterized by type B kinetics, and that grain boundary diffusion plays a dominant role in the mass transport process of such films. Copyright © 2003 John Wiley & Sons, Ltd.     

SO4●－自由基氧化酪氨酸反应中的溶剂效应

研究了水-乙腈混合溶液中SO4●－自由基氧化酪氨酸的反应.实验结果表明，SO4●－自由基氧化酪氨酸的反应机制不因乙腈的加入而改变，但所产生的瞬态粒子的动力学行为受到较大影响.随介质中乙腈体积分数的增加，SO4●－的衰变速率减慢而酪氨酸中性自由基（TyrO●）的衰变速率加快.我们认为这两种自由基所呈现出来的相反的溶剂效应是由于其所带电荷的不同.随介质中乙腈体积分数的增加，SO4●－氧化酪氨酸的反应速率减慢.这一实验结果意味着，在有机溶剂存在的情况下TyrO●/ TyrOH的氧化还原电势可能发生了变化，从而旁证了关于TyrO●/ TyrOH的氧化还原电势因酪氨酸从游离状态变到肽或蛋白质中而发生变化的推测.     

Co—Mo／MgO—Al2O3水煤气耐硫变换催化剂失活的研究

利用Ｘ－射线衍射，扫描电镜，拉曼光谱，等离子发射光谱和比表面测定等方法研究了不同状态下失活及新鲜催化剂的结构，杂种类及含量。结果表明，超温使催化剂晶化明显，制备方法对催化剂结构有直接影响，再生使其强度降低，条形催化剂比较容易粉化，无机杂质是次要的失活原因。     

Topical Problems in Elemental Analysis of Advanced Ceramic Materials

Selected prominent problems in the analysis of advanced ceramic materials are surveyed. The importance of reliability of results is discussed in the field of elemental trace- and microanalysis in view of its interaction with economy, power of detection, local resolution and speciation selectivity. Particular problems in the analysis of major constituents, trace components and microlocal distributions are based on the striking propertics of ceramics; they are exemplified. Analytical assistance must start from the beginning of the production processing, in the preparation of the powdered base materials. Determination of the stoichiometry requires high accuracy and differentiation of chemical species in bulk and surface analysis of ceramic base powders. Element trace determination by direct instrumental methods requires standard reference materials for calibration; these are currently inavailable in a sufficient variety. For optimum reliability and power of detection, element traces must be prepared in isolated form in a small excitation volume for analysis. A review on the state-of-the-art of wet-chemical combined procedures is presented. Decomposition position procedures are emphasized, due to their risk of contributing severe systematic error. Combustion in elementary fluorine is presented for decomposition of refractory materials. The performance of some direct procedures is discussed. Very efficient methods are available for element trace determinations in ceramic materials, offering high detection power. Several approaches for high-resolution local microanalysis in non-conductive ceramic materials are identified as the most promising development in the analysis of sintered compact ceramic products and devices.     

Photochemical aging of in situ polymerized blends of polystyrene and poly[acrylonitrile-g-(ethylene-co-propylene-co-diene)-g-styrene] (AES)

The influence of photochemical aging of in situ polymerized PS/AES blends on their mechanical properties has been studied. The PS/AES blends were subjected to photochemical aging for 168 h and 720 h. Tensile properties and Izod impact resistance of aged and non-aged samples were evaluated. The mechanical properties of the PS/AES blends are influenced by the polymerization temperature and blend composition and represent a balance between the toughness of EPDM and the stiffness of SAN in the PS matrix. Even though the impact resistance and strain at break of HIPS are higher than those of the PS/AES blends, after the aging period all PS/AES blends showed higher strain at break than HIPS. PS/AES blends present higher photochemical stability than HIPS.     

Rheological Properties of Anionic Surfactant Solutions in the Presence of Al3+ Counterion

Aqueous solutions of ionic surfactants with strongly binding counterions exhibit wormlike or network properties. The properties of anionic micelles of sodium dodecyltrioxyethylene sulfate (AES) in the presence of multivalent counterion Al³⁺ were investigated by dynamic rheological methods. The steady-shear viscosity and stress, the zero-shear viscosity, the complex viscosity, and the dynamic shear modulus have been determined as a function of the surfactant and salt concentrations. Some interesting and noticeable results have been obtained, which can express the micellar growth and structure. The formation of wormlike micelles or network structure in surfactant solutions becomes much easier with increasing surfactant and salt concentrations. The Cox-Merz rule and the Cole-Cole plot are not applicable perfectly to the systems studied. The nonlinear viscoelasticity and non-Newtonian behavior can be found in all solutions according to the comparison with the simple Maxwell model. The technique of freeze-fracture transmission electron microscopy (FF-TEM) was also applied to confirm the formation of these interesting structures.