Computation of moisture and temperature profiles in soil—The coupled model

The coupled model has been developed in this study for moisture transport and beat exchange in soil. The model is driven by atmospheric conditions measured in a field. The concept that soil has a surface resistance to evaporation is introduced in order to relate the evaporation from surface with the vapour flux in air. With the use of this concept, the simulation results agree quite well with the measured data.     

Observation of inter-grain Josephson effects in Y-Ba-Cu-O samples

Josephson effects have been observed in bulk samples of Y-Ba-Cu-O. The magnitude of the zero-voltage current is found to change systematically with externally applied small magnetic fields of a few mG. It is also found to vary when samples are irradiated with microwaves. These observations suggest the presence of inter-grain Josephson junctions.     

Topological order in the phase diagram for high-temperature superconductors with point defects

Applying a Lindemann like criterion obtained previously by Kierfeld et al. [J. Kierfeld, T. Nattermann, T. Hwa, Phys. Rev. B 55 (1997) 626], we estimate the magnetic field and temperature for a high-T_c superconductor, at which a topologically ordered vortex glass phase becomes unstable with respect to a disorder-induced formation of dislocations. The employed criterion is shown to be equivalent to a conventional phenomenological Lindemann criterion including the values for the numerical factors, i.e., for the Lindemann number. The positional correlation length of the topologically ordered vortex glass is calculated.     

低密度聚乙烯光引发交联机理——Ⅱ.BNB自旋捕捉ESR研究

在光引发剂二苯甲酮(BP)存在下,紫外光辐照低密度聚乙烯(LDPE)所形成的自由基中间体已被自旋捕捉剂2,4,6-三特丁基亚硝基苯(BNB)所捕捉,其自旋加合物自由基已为电子自旋共振(ESR)所特征。现已检测和鉴定到二种自旋加合物:一种是叔碳自由基;另一种是仲碳自由基。它们分别是由BP的激发三重态从LDPE链的支化点和亚甲基团上夺氢所形成的自由基中间体同自旋捕捉剂BNB反应生成的。上述的证据表明:LDPE的光引发交联点主要发生在叔碳和仲碳原子上,且H-型交联点占主导地位。     

A fixed-point equation for the high-temperature phase of discrete lattice spin systems

A fixed-point equation on an infinite-dimensional space is proposed as an alternative to the usual definition of the infinite-volume limit in discrete lattice spin systems in the high-temperature phase. It is argued heuristically that the free energy and correlation functions one obtains by solving this equation agree with the usual definitions of these quantities. A theorem is then proved that says that if a certain finite-volume condition is satisfied, then this fixed-point equation has a solution and the resulting free energy is analytic in the parameters in the Hamiltonian. For particular values of the temperature this finite-volume condition may be checked with the help of a computer. The two-dimensional Ising model is considered as a test case, and it is shown that the finite-volume condition is satisfied for0.77 _critical.     

Pressure and temperature effects on the excess deuteron and proton conductance

The limiting molar conductances ° of deuterium chloride DCl in D₂O were determined as a function of pressure and temperature in order to examine the proton-jump mechanism in detail. The excess deuteron conductances °_E(D ⁺), as estimated by the equation [°_E(D ⁺) = °(DCl/D ₂ O) – °(KCl/D ₂ O)], increases with an increase in the pressure and temperature as well as the excess proton conductance [°_E(H ⁺) = °(HCl/H ₂ O) – °(KCl/H ₂ O)]. The isotope effect on the excess conductances, however, depends on the pressure and temperature contrary to the model proposed by Conway et al.: °_E(H ⁺)/°_E(D ⁺) decreases with increasing pressure and temperature. The magnitude of the decrease with pressure becomes more prominent at lower temperature. These results are discussed in terms of the pre-rotation of adjacent water molecules, the bending of hydrogen bonds with pressure, and the difference in strength of hydrogen bonds between D₂O and H₂O.     

MgO•3B2O3-18%MgSO4-H2O过饱和溶液析出固相组成和机理研究

针对青藏高原盐湖卤水析盐过程的特点, 模拟合成MgO•3B₂O_3-18%MgSO_4-H₂O过饱和溶液, 在150 ℃水热条件下对析出固相进行研究. 用化学分析方法、X射线衍射、红外光谱进行物相鉴定. 提出了可能的结晶反应机理, 分析了水热温度对析出物相的影响及MgSO₄对硼酸镁盐的盐溶效应随水热温度的变化.     

Partial molal heat capacities of aqueous tetraalkylammonium bromides as functions of temperature

Enthalpies of solution have been measured from 5 to 85°C for aqueous tetraethyl- and tetrapropylammonium bromides, and the integral heat method is employed to evaluate for these electrolytes over a wide temperature range. Data taken from the literature have been used to evaluate for aqueous Bu₄NBr over a similar temperature range. These data, along with similar data for Me₄NBr, previously reported, have been used to evaluate absolute ionic heat capacities. While the absolute values agree only qualitatively with two other methods of division, the temperature dependences of the three methods essentially agree up to 65°C. Heat capacities due to structural effects on the solvent, obtained by subtracting the inherent heat capacities of the ions, are extraordinarily positive for all four tetraalkylammonium ions and have negative temperature coefficients, indicating that all four ions, including the tetramethylammonium ion, are structure-making ions.     

Thermal coefficient of linear expansion of non-crystalline chalcogenides in the As-S-Se-Te-I system

The object of the paper is an investigation of the glasses of the (As₂S₃)_x(AsSe_0.5Te_0.5I)_100-x. type for 65≤;x≤;95, using methods of thermomechanical analysis. Values of the thermal coefficients of linear expansion in solid and visco-plastic phase were determined. it was shown that introducing arsenic-sulfide in glass-matrix AsChI, i.e. (AsSe_0.5Te_0.5I), leads to an increasing stability of these glasses. The characteristic temperatures of softening Tg and the temperature of the beginning of deformation t_w increase by increasing content of As₂S₃. The analytical forms of dependence of four significant physical values α_g, α_l, Tg, Tw, as a function of As₂S₃ content in the structure of glasses were fitted. This revised version was published online in July 2006 with corrections to the Cover Date.     

Sub-zero temperature behavior of water in non-ionic microemulsions

Sub-zero temperature DSC measurements were conducted to evaluate the behavior of water in non-ionic microemulsions. Two surfactant systems were studied. The first, based on ethoxylated fatty alcohol, octaethylene glycol monon-dodecylether [hereafter referred to as C₁₂(EO)₈] and also containing water, pentanol and dodecane at a fixed weight ratio of 1:1. The second system, based on oligomeric ethoxylated siloxanes, water and dodecanol as oil phase. In both systems it was found that in up to 30 wt.% of the total water content, all water molecules solubilize in the amphiphilic phase and are bound to the ethylene oxide (hereafter referred to as EO) head-groups. No free water exists in the surfactant aggregates’ core. Up to three molecules of water are bound to each EO group. In the first system, the behavior changes significantly upon adding more water. The added pentanol allows further swelling and the water penetrates into the amphiphile structures and forms a reservoir of free water. Structures are deformed and grow from elongated channels (up to 15–20 wt.% water), via illdefined (one-dimensional growth) local lamellar structures (up to ca. 60 wt.% water) to spherical normal, O/W micelles (at ≥85 wt.% water). In contrast, the oligomeric systems, due to geometrical restrictions of the amphiphiles and the nature of their curvature that prevents inversion, cannot further solubilize water in the surfactant aggregates’ core, causing phase separation to occur. Part of the results presented in this paper were included in S. E.’s doctoral thesis in Applied Chemistry at The Hebrew University of Jerusalem, Israel.