两亲性丙烯酸酯共聚物的聚合研究

利用过氧化苯甲酰为引发剂探讨了甲基丙烯酸β－羟乙酯和丙烯酸长链烷基酯的自由基共聚合。重点讨论了合成条件如溶剂、沉淀剂、引发剂用量、单体配比、反应时间等对共聚反应的影响以及各种聚合条件对该共聚物的组成、结构和性能的影响。并用ＩＲ，ＧＰＣ，＾１３ＣＮＭＲ等手段对共聚物进行了表征。     

Aminoalkylation with Aldehydes Mediated by Solid Lithium Perchlorate

Summary. The solid LiClO₄-mediated one-pot reaction of aldehydes with secondary amines and C nucleophiles afforded the corresponding aminoalkylation products in high yields. Unlike the previous reported procedure, the aminoalkylation of aldehyde was achieved in the presence of only 0.5 equivalents of solid lithium perchlorate in dichloromethane as the solvent with good to high yields at room temperature.     

低共熔混合锂盐相图的绘制及应用

采用热分析法对不同组成的混合锂盐二元体系进行研究, 绘制了混合锂盐体系的步冷曲线和T-x相图, 结果表明体系均为具有最低共熔点的二元体系. LiOH-LiNO3、LiOH-LiCl、LiOH-Li2CO3及LiNO3-LiCl体系的最低共熔点分别为175.7、294.5、418.2及221.6 ℃. 利用低共熔混合物LiNO3-LiOH为锂盐与不同前驱体反应, 制备出了层状结构良好的锂离子电池正极材料LiNiO2、LiNi0.8Co0.2O2及LiNi1/3Co1/3Mn1/3O2. X射线衍射分析表明, 合成的材料具有规整的层状NaFeO2结构, 且XRD衍射峰强度之比I(003)/I(104)>2.0, 电性能测试表明, 在2.7-4.3 V(vs Li/Li+)的电压范围内进行0.1C倍率充放电, LiNiO2、LiNi0.8Co0.2O2、LiNi1/3Co1/3Mn1/3O2首次充电比容量分别达168.0、225.4、194.0 mAh·g-1, 放电比容量分别为138.4、165.8、157.7 mAh·g-1.     

Effect of dimethylaminoethyl methacrylate on the graft copolymerization of ethyl acrylate onto hydroxypropyl methylcellulose in aqueous medium

Graft copolymerization of an ethyl acrylate (EA) and dimethylaminoethyl methacrylate (DMAEMA) monomer mixture onto water-soluble hydroxypropyl methylcellulose was investigated with potassium persulfate (KPS) as the initiator in an aqueous medium. The effects of introducing DMAEMA onto the graft copolymerization and the properties of the resulting latex that was produced were studied systematically. The optimum conditions for the graft copolymerization in terms of percentage of grafting and grafting efficiency were determined. The graft copolymer was characterized by Fourier transform infrared spectra, elemental analyses, nuclear magnetic resonance, transmission electron microscopy, and dynamic light scattering methods. The results suggest that the introduction of the DMAEMA monomer clearly accelerates the initial rate of the graft copolymerization, whereas the grafting parameters decrease significantly with increasing amounts of DMAEMA. These results can be attributed to the relatively large size of the DMAEMA molecule, its redox reaction with KPS, its hydrophilicity in water, and its chain transfer effect. The equilibrium humidity adsorption behavior and acid solubility of graft the copolymer films were also studied.     

A new strategy for the synthesis of α,β-diaroylpropionates promoted by samarium metal in DMF

When promoted by samarium in DMF, aroyl chlorides react readily with acrylates to afford α,β-diaroylpropionates in good to excellent yields without pretreating or activating the metallic samarium.     

Use of a Carbon Paste Electrode Modified with Spinel‐Type Manganese Oxide as a Potentiometric Sensor for Lithium Ions in Flow Injection Analysis

A potentiometric sensor constructed from a mixture of 25% (m/m) spinel‐type manganese oxide (lambda‐MnO₂), 50% (m/m) graphite powder and 25% (m/m) mineral oil is used for the determination of lithium ions in a flow injection analysis system. Experimental parameters, such as pH of the carrier solution, flow rate, injection sample volume, and selectivity for Li⁺ against other alkali and alkaline‐earth ions and the response time of this sensor were investigated. The sensor response to lithium ions was linear in the concentration range 8.6×10^?5–1.0×10^?2 mol L^?1 with a slope 78.9±0.3 mV dec^?1 over a wide pH range 7–10 (Tris buffer), without interference of other alkali and alkaline‐earth metals. For a flow rate of 5.0 mL min^?1 and a injection sample volume of 408.6 μL, the relative standard deviation for repeated injections of a 5.0×10^?4 mol L^?1 lithium ions was 0.3%.     

聚合物驱蚊剂的慢释放研究

本文研究了丙烯酸酯共聚物载体对驱蚊剂N,N-二乙基间甲苯酰胺(DETA)慢释放行为的控制,探讨了单体配比、共聚物分子量以及DETA含量对释放速率的影响。结果表明。增加亲水性单体丙烯酸(AA),可提高DETA的释放速率;降低共聚物数均分子量,会减少DETA的释放量;剂型中DETA含量与释放量存在线性正比关系,但DETA的含量增加并不导致释放有效时间的线性增加。本文还就共聚物膜的透湿性和碱溶性作了研究,亲水性单体AA的增加同样导致透湿性和碱溶性的增加。制备的聚合物驱蚊剂经现场应用试验,表明具有良好的长效驱蚊特性。     

Structure and Reactivity of Lithium Enolates. From Pinacolone to Selective C-Alkylations of Peptides. Difficulties and Opportunities Afforded by Complex Structures

The chemistry of lithium enolates is used to demonstrate that complex structures held together by noncovalent bonds (“supramolecules”) may dramatically influence the result of seemingly simple standard reactions of organic synthesis. Detailed structural data have been obtained by crystallographic investigations of numerous Li enolates and analogous derivatives. The most remarkable features of these structures are aggregation to give dimers, tetramers, and higher oligomers, complexation of the metal centers by solvent molecules and chelating ligands, and hydrogen-bond formation of weak acids such as secondary amines with the anionoid part of the enolates. The presence in nonpolar solvents of the same supramolecules has been established by NMR-spectroscopic, by osmometric, and by calorimetric measurements. The structures and the order of magnitude of the interactions have also been reproduced by ab-initio calculations. Most importantly, supramolecules may be product-forming species in synthetic reactions of Li enolates. A knowledge of the complex structures of Li enolates also improves our understanding of their reactivity. Thus, simple procedures have been developed to avoid complications caused by secondary amines, formed concomitantly with Li enolates by the common methods. Mixtures of achiral Li enolates and chiral Li amides can give rise to enantioselective reactions. Solubilization by LiX is observed, especially of multiply lithiated compounds. This effect is exploited for alkylations of N-methylglycine (sarcosine) CH₂ groups in open-chain oligopeptides. Thus, the cyclic undecapeptide cyclosporine, a potent immunosuppressant, is converted into a THF-soluble hexalithio derivative (without epimerization of stereogenic centers) and alkylated by a variety of electrophiles in the presence of either excess lithiumdiisopropyl amide or of up to 30 equivalents of lithium chloride. Depending on the nature of the LiX additive, a new stereogenic center of (R) or (S) configuration is created in the peptide chain by this process. A structure-activity correlation in the series of cyclosporine derivatives thus available is discussed.     

环氧丙烯酸酯的紫外光固化

制备了适于配制紫外光固化涂料的环氧丙烯酸酯，研究了反应温度、阻聚剂、催化剂等因素对环氧树脂与丙烯酸反应的影响；讨论了反应机理和动力学；并利用红外光谱观察了产物的紫外光固化行为。季铵盐能有效地催化环氧树脂和丙烯酸的反应，当其用量为０．６％～１．２％时，在９０～１１０℃反应４．５～８小时后，环氧基转化率大于９７％。由此配制的光固化涂料经紫外光辐照能快速固化。     

淀粉接枝丙烯酸乙酯及其增容性

研究了在挤出机中采用高温和剪切力的作用直接引发淀粉与丙烯酸乙酯的接枝共聚合反应．讨论了反应条件对接枝反应的影响，研究了接枝物在淀粉与聚乙烯共混物中的增容作用．实验结果表明，高温和剪切力可以引发淀粉与丙烯酸乙酯的接枝共聚合反应．接枝物作为增容剂，可以明显地改善淀粉与聚乙烯共混物的力学性能和流变性能．