Study on oxidation of polymers treated by high LET radiation

The oxidation of medical silicone rubber and segmented polyether urethane which were bombarded with 11.2 MeV Si⁺ or F⁺ at the dose of 5 × 10¹⁴ ions/cm² was studied. In XPS measurements, it was found that the oxygen concentration on the surface of the implanted polymeric membranes had been increasing in three months at least. ESR measurement showed that some free radicals existed in these membranes and their quantities decreased with time. Chemical analysis proved that peroxides were generated in the γ irradiated membranes. The reason for the increasing of oxygen concentration was that free radicals combined with oxygen in the air and produced peroxides on the membrane surface. Moreover, in order to demonstrate the radiation mechanism, low LET (γ rays) radiation of such polymeric membranes was carried out for comparison     

Fluorescence study of the solubilization of benzo[a]pyrene: application to its detection in coal washing waters

The solubilization of benzo[a]pyrene by organic solvents (dioxane, toluene and dichloromethane) and a surfactant (Triton X-100) was investigated. These media were successfully used for the determination of benzo[a]pyrene using fluorescence detection, with excellent limits of detection and large linear analytical ranges. Benzo[a]pyrene was detected in coal washing waters using liquid chromatography with fluorescence detection. The stability of this compound in dioxane was also examined.     

Synthesis of novel tri-podal mesogenic alkenes and side-chain polysiloxanes

Low molecular weight tri-podal biphenyl- and benzoate-type mesogens [C₆H₅C₆H₄O(CH₂)₅SiMe₂CH₂CH₂SiMe₂]₃CH (4), [C₁₁H₂₃O(C₆H₄)₂O(CH₂)₅SiMe₂]₃CH (5) and [MeOC₆H₄OC(O)C₆H₄O(CH₂)₅SiMe₂]₃CH (6) (C₆H₄ = 1,4-phenylene) were obtained, from branched silyl substituted methane precursors [CH₂CH(Me)₂Si]₃CH (1) and (HMe₂Si)₃CH (2). The biphenyl-containing ones (4) and (5) were converted into terminal alkenes, which were subsequently hydrosilylated with poly(methylsiloxanes). The polymer derived from (5) exhibited mesomorphic properties. Such systems have the potential to significantly increase the density of liquid crystal rod-like structures in side chains of linear polymers (or dendritic liquid crystal polymers).     

Dielectric studies under high pressure on strongly polar liquid crystals exhibiting monolayer smectic A phase

Dielectric studies have been performed at elevated pressures on two compounds of a homologous series possessing a strongly polar terminal group and three phenyl rings in their molecular structure. This is the first high pressure dielectric study on such systems that exhibit a monolayer smectic A phase. Also notable is the fact that these compounds show a dual frequency response, a promising feature for fast liquid crystal display devices. The low frequency relaxation recorded in the nematic and smectic A phases is attributed to the reorientation of the molecules about the short axis. The temperature and pressure dependence of the relaxation frequency of this mode as well as the involved activation parameters are discussed. At a given relative temperature the relaxation frequency decreases as the pressure is increased. However, the parameter that characterizes the temperature dependences of the relaxation frequency, viz., the activation enthalpy, has a very weak dependence on pressure. In contrast, the activation volume shows a linear decrease with temperature.     

PREPARATION AND CHARACTERIZATION OF SHISH-KEBAB TYPE LIQUID CRYSTALLINE POLY（p-PHENYLENEVINYLENE）

Novel shish-kebab type liquid crystalline poly（p-phenylenevinylene） derivatives were synthesized by Stille coupling reaction from 2,5-bis[（4-n-alkoxyl）benzoyloxy]1,4-dibromobenzene （monomer l） and 1,2-bis（tributylstannyl） ethylene （monomer 2）. The polymers with alkoxy groups are soluble in common organic solvents and exhibit blue fluorescence. Both the cast film and the annealed film have large red-shifts in fluorescence spectra and show yellow fluorescence. The polymers with CN and NO2 groups show poor solubility and green fluorescence. All the polymers possess liquid crystalline smectic phases. The melting point （Tm） of the polymers decreases when the length of the alkoxy tails of the mesogenic units increases. The polymers are easily aligned under a magnetic field of 10 Tesla. It is found that the conjugated backbone and LC side chain are aligned perpendicular and parallel to the magnetic field, respectively. The polymers show optical dichroism in fluorescence spectra, suggesting that they are available for advance materials with linear optical polarization.     

W／O／W乳液的渗透溶胀与夹带溶胀

研究了W/O/W乳液的溶胀,实验结果表明,渗透溶胀随内外相溶液间的渗透压差、表面活性剂及载体浓度的增大而增加,但随膜粘度的增加而降低,渗透压差较高时,水渗透的影响大于夹带的影响;膜相中含氧化合物对溶胀的影响大于含氮化合物,采用Span 80作乳化剂时,比采用E 644渗透溶胀约高6倍,夹带溶胀也较高;重复聚结再分散使夹带溶胀急剧增加,因而多级混合澄清槽对液膜操作似不适用。     

A comparison between the SBR vulcanizates reinforced by magnesium methacrylate added directly or prepared in situ

The styrene-butadiene rubber (SBR) cured by dicumyl peroxide was reinforced by magnesium methacrylate [Mg(MAA)₂], which was added into SBR directly or prepared in situ in SBR through the neutralization of magnesium oxide (MgO) and methacrylic acid (MAA). The experimental results show that the SBR vulcanizates reinforced by Mg(MAA)₂ prepared in situ have better mechanical properties than those reinforced by Mg(MAA)₂ added directly. The SBR vulcanizates with Mg(MAA)₂ prepared in situ are semi-transparent, but those with Mg(MAA)₂ added directly are opaque. The Fourier transform infrared analysis shows that the polymerization conversion of Mg(MAA)₂ in the SBR vulcanizates with Mg(MAA)₂ prepared in situ is much higher than that in the SBR vulcanizates with Mg(MAA)₂ added directly. The scan probe microscopy photographs show that the particles in the SBR vulcanizates with Mg(MAA)₂ prepared in situ are much finer and disperse more evenly than that in the SBR vulcanizates with Mg(MAA)₂ added directly.     

Liquid chromatography of benzene derivatives on a porous methacrylate copolymer containing epoxy groups

Summary The retention of benzene derivatives with nonpolar and polar substituents on a porous methacrylate copolymer containing epoxy groups using both nonpolar and polar eluents was investigated. When n-hexane is used as the eluent, the retention of n-alkylbenzenes and polymethylbenzenes is weaker than that of benzene. In the case of benzene derivatives containing polar functional groups their capacity ratios (k) on this porous polymer increases approximately linearly with the increase of the adsorbate molecules dipole moment. The retention characteristics of the methacrylate copolymer were compared with that of a styrene-divinylbenzene copolymer and silica gels with a hydroxylated surface and with a surface modified by chemically bonded alkylsilyl groups.     

Instantaneous strain recovery elasticity and endothermic heat change in nylon-6 monofilaments and silicone rubbers

The instantaneous elastic moduli for a nylon-6 monofilament were derived on strain recoveries right after creep, stress relaxation, and rapid elongation,E _c ,E _s andE _e , respectively. It was found that during strain recoveryE _s (>E _e ) andE _e increase monotonically with increasing load,m ₁, on the sample. The extrapolated value of E_s atm ₁=0 g is almost equal to Young's modulus, 4.06 GPa. The value ofE _c also increased with increasingm ₁, and atm ₁=600 g (1.93 t cm^–2) reached about 14 GPa. The endothermic heat change right after creep, stress relaxation or rapid elongation,Q, was negligibly small. For comparison,E _s ,E _c andQ were also investigated for silicone rubber. It was found thatE _s (53.8 M Pa at the draw ratioD=1.2) decreased abruptly atD=1.3. In the range ofD=1.4–1.9,E _s was only 22.6 MPa. In the case of stress relaxation,Q increased with increasingD from 4 J mol^–1 (atD=1.2) to 56 J mol^–1 (atD=1.9). FurthermoreE _c (5.58 MPa atm ₁=133.8 g (429.4 kg cm^–2)) increased gradually with increasing m₁ and attained 16.6 MPa atm ₁=548.4 g (1.76 t cm^–2). In the case of creep,Q was in the range of 0–11.5 J mol^–1 and larger when larger loads,m ₂ were removed during the later stages of creep.Dedicated to Professor Bernhard Wunderlich on the occasion of his 65th birthdayThe author wishes to thank Mr. Keizi Igarashi and Mr. Tetsuya Yasui for helping in the experiments.     

带甲基侧基的环氧树脂增容剂对炭黑在丁苯橡胶中分散度的影响

用自制的带甲基侧基的环氧树脂(TMBP)作为界面增容剂, 从拉伸性能、键合胶含量、动态性能、扫描电镜和流变性能等方面, 研究了TMBP对炭黑在丁苯橡胶中分散度的影响, 并与市售通用双酚A型环氧树脂(E-51)和橡胶工业常用软化剂邻苯二甲酸二辛酯(DOP)进行了比较. 结果表明, 带甲基侧基的环氧树脂TMBP在提高炭黑分散性方面的效果远比E-51好， 其作用模式具有典型的增容特性.