La传感器在测定铝液凝固过程中La活度研究

微量稀土加入铝或铝合金中，如果加入方法、数量、时间得当，可明显改善材料的多项性能．稀土对铝及铝合金的影响规律和作用机理，已取得了一些进展，但对稀土铝合金的热力学性质，尤其是溶解态稀土的研究少有报导［‘，2］．本工作采用L即．95C。。。。FZ。。多晶作为固体电解     

LaB6-ZrB2共晶复合材料的组织特征及控制

用电弧炉和电子束悬浮区熔炉法制备了ＬａＢ６ＺｒＢ２共晶复合材料，并用ＳＥＭ和ＴＥＭ方法对其显微组织进行了研究。结果表明，ＬａＢ６ＺｒＢ２形成纤维状共晶组织，控制凝固条件可得到定向排列的组织，ＬａＢ６基体上均匀分布着直径为０２～１２μｍ的ＺｒＢ２纤维，纤维长度可达１００μｍ以上。对于固液界面为平面生长的试样，其结晶学取向关系为［００１］ＬａＢ６∥［００１］ＺｒＢ２，（１１０）ＬａＢ６∥（０１０）ＺｒＢ２。     

Thermal analysis and thermal expansion studies on high density YBa2−xLaxCu3O7−δ, 0x0.2

The compositions in the YBa_2−xLa_xCu₃O_7−δ (0x0.2) system were prepared by the solid state reaction, employing a novel high-temperature oxygen sintering route. The modified sintering route yields dense slab like microstructures with large grains. The decomposition (incongruent melting) temperature of the YBa₂Cu₃O_7−δ (Y-123) phase was found to shift to higher temperatures with increasing oxygen partial pressure and lanthanum content. Structure remained orthorhombic up to x=0.2 with a decrease in the orthorhombic strain ((b−a)/b). Iodometric titration indicated a systematic increase in the oxygen content with increasing lanthanum content. Thermo-gravimetric studies in various oxygen partial pressures revealed that the oxygen diffusion in to the YBa₂Cu₃O_7−δ (δ>0.5) lattice is an exothermic event and takes place at temperatures not less than 573 K. High-temperature thermal-expansion measurements in air indicated that the nonlinearity in thermal expansion behaviour was reduced by the substitution of lanthanum.     

氯化铯和氯化镧溶剂体系及四类新化合物的合成

研究了四元体系ＣｓＣｌ－ＬａＣｌ３－ＨＣｌ－Ｈ２Ｏ（２５℃、「ＨＣｌ」＝１３％（ｗｔ），２３％（ｗｔ）和ＣｓＣｌ－ＬａＣｌ３－ＨＡｃ－Ｈ２Ｏ（３０℃，「ＨＡｃ」＝４２％（ｗｔ））的平衡态的溶度数据，并给出制了相应的溶度图，共得到了ＣｓＣｌ．ＬａＣｌ３．４Ｈ２Ｏ、２ＣｓＣｌ．ＬａＣｌ３．２Ｈ２Ｏ和３ＣｓＣｌ．ＬａＣｌ３．３Ｈ２Ｏ３种化合物。对得到的新相进行了热分析，Ｘ射线粉末衍射及偏光性质的测定，依     

Vapor pressure,speciation, and chemical activities in highly concentrated sodium borate solutions at 277 and 317°C

The system H₂O-B₂O₃-Na₂O has been studied experimentally at 277 and 317°C. The activities of water and boric acid have been determined at mole ratios Na/B from 0 to 1.5, and total dissolved solids 3 to 80 weight percent. The activity of boric acid has been fitted to within experimental error using a speciation model with eight complex species. This model is consistent with the model previously published by Mesmer et al. The electrolyte properties of the liquid are modeled using the Pitzer-Simonson model of very concentrated electrolyte solutions. The calculated values of water activity agree with experiment, and the activity of NaOH and pOH have also been calculated. The potassium borate system also was briefly studied at 317°C, and is adequately described by a model with five complex species. The potassium borate liquid is more alkaline at K/B= 1 than a sodium borate liquid at the same mole ratio, but pOH in the two systems is the same at lower mole ratios.     

Structure and electronic transport properties of the Misfit layer compound (LaSe)1.14(NbSe2)2, „LaNb2Se5”︁

The new misfit layer compound (LaSe)_1.14(NbSe₂)₂ has been synthesized from the elements at 1050- and its structure has been determined by a composite approach. The structure has an alternating stacking sequence of [LaSe] and two [NbSe₂] layers along the c direction. The misfit of the two different layers is occurring along the a direction: a₁(LaSe)=6.0191 Å and a₂(NbSe₂)=3.4372 Å therefore yielding a ratio of 1.751 which is very close to 7/4. An investigation of electrical resistivity was done. The crystal shows superconducting properties at 5.3 K.     

On the stereochemistry of the Horner—Emmons reaction between 3-functionally substituted 2-methyl-2-propenylphosphonates and aliphatic aldehydes

The reaction of diethyl 3-ethoxycarbonyl-2-methyl-2-propenylphosphonate (1a) with 3-methylbutanal (2) in heterogeneous MOH (solid)-benzene systems in the presence of 5–10 mol.% of benzyltriethylammonium chloride (BTEAC) gives the reaction product (3) with a higher, for M=K, or lower, for M=Li, ratio of 2E,4E and 2Z,4E-stereoisomers than that observed in the absence of BTEAC. Tetrabutylammonium bromide (TBAB) as a catalyst of the reaction1a + 2 3 in the system KOH (solid)-wet benzene leads to a higher [2E,4E-3][2Z,4E-3] ratio than BTEAC; this ratio grows from 4456 without TBAB to 8020 at 100 mol.% of TBAB. In the latter case the stereochemical outcome of the reaction is similar to that obtained when tetrabutylammonium hydroxide in dry benzene is used as the deprotonating agent. The corresponding diisopropyl phosphonate (1b) and 3,7-dimethyloctanal (4a) interact in the system KOH (solid)-wet benzene-TBAB to give hydroprene (5) containing 88 % of the 2E,4E-isomer (5a) while in the case of 1 equiv. of [(n-Bu₄)N]OH in dry benzene the content of5a is 92 %. Diisopropyl 3-isopropoxycarbonyl-2-methyl-2-propenylphosphonate (1c) and 7-methoxy-3,7-dimethyloctanal (4b) under either of these conditions afford methoprene (6) containing 93 % of the 2E,4E-isomer.Part 6, see ref. 1.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 6, pp. 1094–1098, June, 1993.     

Quantitative thermogravimetric analysis of binary mixtures

Thermogravimetric analysis is used to determine the amounts of Mg(OH)₂ and Mg(CH₃COO)₂in a mixture thereof. The application and suitability of different analysis methods are discussed. In the first method the mass losses in the temperature ranges as indicated by the decomposition of the pure compounds were used. Results obtained using these temperature ranges were unusable. The percentage mass losses due to the decomposition of Mg(OH)₂ and Mg(CH₃COO)₂ were then determined in a second method using the minimum in the derivative mass vs. temperature curves. The results obtained by this method compared well with the actual values for mixtures containing more than 15% magnesium acetate. The third method employed the total experimental mass loss of both decomposition reactions. The results obtained using this method compared well to the actual values, giving a R ² value of more than 0.99. This method of using the total mass losses can however only be used for binary mixtures that consist only of magnesium hydroxide and magnesium acetate. This revised version was published online in August 2006 with corrections to the Cover Date.