类钙钛矿化合物Ca(Mn2 Cu1)Mn4 O12的磁性与磁电阻效应

利用固相反应法制备了名义成分为Ca(Mn2 Cu1 )Mn4 O1 2 的类钙钛矿锰氧化物 .x射线衍射表明 ,为了获得较为致密的样品和减小杂相含量 ,可以采用高温烧结再在 10 73K长时间空气中退火的制备方法 .样品在低温下同时存在铁磁相和反铁磁相 ,由于反铁磁相的存在导致样品在 4 5K时的磁化强度显著降低 ,并在 8T的高磁场下仍未达到饱和 .样品呈半导体导电性质 ,在 85K和 6T磁场下磁电阻比的最大值可达 - 4 6 % .     

水合甘氨酸体系水桥式质子迁移的理论研究

水分子与甘氨酸作用会导致甘氨酸羧基上的质子迁移到氨基上,质子可以通过水分子链进行迁移。采用密度泛函理论的B3LYP/6-31++g**方法研究了水分子链的逐渐增长（1~5个水分子）对质子迁移的影响,发现水分子数少于5时,质子迁移一步完成;水分子数为5时,质子迁移经由一个中间体,需两步完成;水分子链的增长使质子迁移反应的自由能越来越低,但是反应的活化能越来越高,即在热力学上有利于质子迁移反应,在动力学上不利于质子迁移反应。     

Chemical analysis of Gothic mortar from a bridge pier in Roudnice nad Labem (Czech Republic)

In this paper, a Gothic mortar originating from the remains of a bridge pier in Roudnice nad Labem (Czech Republic) was analyzed. The inorganic composition of the mortar showing special mechanical properties was studied using polarizing light microscopy, scanning electron microscopy coupled with energy dispersive X-ray spectrometry, and X-ray diffraction, while the protein content was analyzed by peptide mass mapping using matrix-assisted laser desorption/ionization—time of flight mass spectrometry and nanoliquid chromatography coupled to tandem mass spectrometry. Two types of inorganic binders having a composition similar to mineral wollastonite and hydraulic lime and milk protein additive were detected. We believe that organic and inorganic binders added together to the mortar increase its hardness and firmness in the aquatic environment.     

Promotion effect of adsorbed water/OH on the catalytic performance of Ag/activated carbon catalysts for CO preferential oxidation in excess H2

Activated carbon (AC) supported silver catalysts were prepared by incipient wetness impregnation method and their catalytic performance for CO preferential oxidation (PROX) in excess H₂ was evaluated. Ag/AC catalysts, after reduction in H₂ at low temperatures (≤200 °C) following heat treatment in He at 200 °C (He200H200), exhibited the best catalytic properties. Temperature-programmed desorption (TPD), X-ray diffraction (XRD) and temperature-programmed reduction (TPR) results indicated that silver oxides were produced during heat treatment in He at 200 °C which were reduced to metal silver nanoparticles in H₂ at low temperatures (≤200 °C), simultaneously generating the adsorbed water/OH. CO conversion was enhanced 40% after water treatment following heat treatment in He at 600 °C. These results imply that the metal silver nanoparticles are the active species and the adsorbed water/OH has noticeable promotion effects on CO oxidation. However, the promotion effect is still limited compared to gold catalysts under the similar conditions, which may be the reason of low selectivity to CO oxidation in PROX over silver catalysts. The reported Ag/AC-S-He catalyst after He200H₂00 treatment displayed similar PROX of CO reaction properties to Ag/SiO₂. This means that Ag/AC catalyst is also an efficient low-temperature CO oxidation catalyst.     

Synthesis and characterization of bimetallic ruthenium complexes connected through linear (CH)14 chain

Treatment of RuHCl(CO)(PPh₃)₃ with (3E,5E,7E,9E,11E)-HCC-(CHCH)₅- CCH produces [RuCl(CO)(PPh₃)₂]₂[μ-(CHCH)₇]. The later complex reacts with PMe₃ to give [RuCl(CO)(PMe₃)₃]₂[μ-(CHCH)₇], the structure of which has been confirmed by X-ray diffraction. The through-space distance from one Ru to the other is 19.88 Å.     

A DFT study of DMC formation on Rh‐doped Cu/AC surfaces

The activity and selectivity of heterogeneous catalysts can be significantly improved by dispersion of another active component in the metal substrate. The impact of Rh promoter on the formation of dimethyl carbonate (DMC) via oxidative carbonylation of methanol on Cu–Rh/AC (activated carbon) catalyst was investigated by density functional theory calculations. The most stable configurations of reacting species (CO, OH, CH₃O, monomethyl carbonate, and DMC) adsorbed on the Cu⁰(zero‐valent copper)/AC and Cu–Rh/AC surfaces were determined on the basis of the calculated results. The reaction energy and activation energy of the rate‐limiting steps on the Cu–Rh/AC and Cu⁰/AC surfaces were compared. The activation energies of the rate‐limiting step of CO insertion into dimethoxide are 206.3 and 304.8 kJ mol^?1 on the Cu–Rh/AC and Cu⁰/AC surfaces, respectively. The activation energies of the rate‐limiting step of CO insertion into methoxide are 78.5 and 92.7 kJ/mol on the Cu–Rh/AC and Cu⁰/AC surfaces, respectively. The calculated results indicate that the addition of Rh atom has a significant effect on decreasing the active energy the main pathway for DMC formation. © 2015 Wiley Periodicals, Inc.     

Synthesis and Magnetic Studies of Copper (II)‐Manganese (II) Heterobinuclear Complexes with an Oxamido Bridge

Four new copper (II)‐manganese (II) heterobinuclear complexes bridged byN, N'‐bis[2‐(dimethylamino)ethyl)]oxamido dianion (dmoxæ) and end‐capped with 1, 10‐phenanthroline (phen), 5‐methyl‐1, 10‐phenanthroline (Mephen), diaminoethane (en) or 1,3‐di‐aminopropane (pn). respectively, namely, [Cu(dmoxae)MnL₂] (CIO₄)₂ (L=phen, Mephen, en, pn), have been synthesized and characterized by elemental analyses, IR, electronic spectral studies, and molar conductivity measurements. The electronic reflectance spectrum indicates the presence of spin exchange‐coupling interaction between bridged copper(II) and manganese (II) ions. The cryomagnetic measurements (4.2‐300 K) of [Cu(dmoxae)Mn(phen)₂](CIO₄)₂ (1) and [Cu(dmoxae)Mn(Mephen)₂](CIO₄)₂(2) complexes demonstrated an antiferromagnetic interaction between the adjacent manganese(II) and copper (II) ions through the oxamido‐bridge within each molecule. On the basis of spin Hamiltonian, H= ‐ 2JS₁. S₂. the magnetic analysis was carried out for the two complexes and the spin‐coupling constant (J) was evaluated as ?35.9 cm^?1 for 1 and ‐ 32.6 cm^?1 for 2. The influence of methyl substitutions in the amine groups of the bridging ligand on magnetic interactions between the metal ions of this kind of complexes is also discussed.     

Assessment of corrosion resistance of surface-coated galvanized steel by analysis of the AC impedance spectra measured on the salt-spray-tested specimen

In the present work, corrosion resistance of surface-coated galvanized steel was quantitatively determined by an analysis of the alternating current (AC) impedance spectra measured on the salt-spray-tested specimen. To evaluate the corrosion resistance of the surface-coated galvanized steel, AC impedance spectroscopy was performed on the salt-spray-tested specimen previously exposed to salt-sprayed corrosive environment. From the analysis of the impedance spectra, the area fraction transient of white rust θ ₂(t) was theoretically derived from the equivalent circuit equation by using two fitting parameters. The values of the two fitting parameters were determined by fitting the empirical transient equations to the area fraction of the resin coating layer and to the total resistance obtained from the impedance spectra measured, respectively. From the analyses of θ ₂(t) for four kinds of surface-coated galvanized steels with various resin coating layers, it is indicated that as the values of the two fitting parameters decrease in the order of CP, GI, OD and OM (commercial trade names) specimens, the corrosion resistance increases in that order as well. Furthermore, from the quantitative comparison of the two fitting parameters with the polarization resistance of the upper resin coating layer R _p determined from the potentiodynamic polarization curve, it is suggested that the two fitting parameters decrease in value as well with increasing R _p.     

醋酸铜热解制备无氯Cu2O/AC催化剂及其催化氧化羰基化

以醋酸铜为前驱物, 采用浸渍法负载后进行热处理使醋酸铜热解, 获得了负载型无氯Cu2O/AC(活性炭)催化剂, 并通过催化甲醇直接气相氧化羰基化合成碳酸二甲酯(DMC). 在氮气和惰性气体气氛下, 一水合醋酸铜Cu(CH3COO)2·H2O在30~450 ℃范围内产生3个失重过程, 其中在150~300 ℃范围内Cu(CH3·COO)2热解生成Cu2O; 而在300~450 ℃范围内生成单质Cu. 在200~350 ℃范围内, 将Cu(CH3COO)2·H2O/AC加热处理4 h后, 催化剂上逐步形成了Cu2O, 到350 ℃时, 水合醋酸铜几乎全部转化为Cu2O, 并有极少量单质Cu形成. 在300~350 ℃热处理4 h后, 催化剂中铜主要以Cu2O形式存在, 并表现出良好的氧化羰基化催化活性. 在n(CO)∶n(MeOH)∶n(O2)=4∶10∶1及SV=5600 h-1条件下, 于300 ℃热处理4 h所制备的催化剂的甲醇转化率达到6.21%, DMC的时空收率为128.16 mg·g-1·h-1, 选择性为64.26%.     

Comparative studies on the adsorption and association of 3-methylxanthine and 7-methylxanthine at a charged interface

Summary A systematic comparative study of the adsorption and association of 3-methylxanthine (3MXan) and 7-methylxanthine (7MXan) at mercury-solution interfaces in acidic, neutral, and alkaline buffer solutions was undertaken by ac voltammetry. At bulk concentrations of3MXan above a threshold value, the stacking interactions between vertically oriented molecules lead to a slow reorientation aroundE _ecm, and the molecules adopt a perpendicular orientation. The association of the adsorbed molecules of7MXan is hindered and is not effective in promoting base-base stacking interactions. The enhanced surface activity of3MXan compared to7MXan results from the different position of the methyl group in the purine moiety. The effect of some divalent metal ions on adsorption stages and association of the investigated compounds has been studied. The results indicate that the complexation of methylated xanthine enhances the stacking interactions and hence would be expected to facilitate the formation of perpendicularly stacked layers ofM(II)-MXan complexes on the electrode surface. The adsorption parameters of the investigated compounds have been computed in absence and presence of Cu(II) at differentpH values. The results are compared with the behaviour of xanthine.

---

Vergleichende Untersuchungen zur Adsorption und Assoziation von 3-Methylxanthin und 7-Methylxanthin an einer geladenen Grenzfläche

Zusammenfassung Eine systematische vergleichende Untersuchung zur Adsorption und Assoziation von 3-Methylxanthin (3MXan) und 7-Methylxanthin (7MXan) an Quecksilber-Lösungs-Grenzflächen wurde mittels AC-Voltammetrie in sauren, neutralen und basischen Pufferlösungen durchgeführt. Oberhalb einer bestimmten Grenzkonzentration kommt es durch Wechselwirkungen zwischen vertikal angeordneten3MXan-Molekülen zu einer langsamen Reorientierung umE _ecm, was zu einer senkrechten Anordnung führt. Die Assoziation von7MXan ist gehindert und erlaubt daher keine ausgeprägten Basen-Basen-Wechselwirkungen. Die erhöhte Oberflächenaktivität von3MXan gegenüber7MXan resultiert aus der unterschiedlichen Stellung der Methylgruppe am Purinrest. Der Effekt einiger zweiwertiger Metallionen auf die Adsorption und Assoziation von3MXan und7MXan wurde untersucht. Die Ergebnisse weisen auf eine Begünstigung der Wechselwirkungen hin; die Bildung von vertikal angeordneten Grenzschichten an der Elektrodenoberfläche sollte daher im Fall vonM(II)-Mxan-Komplexen erleichtert sein. Die Adsorptionsparameter der untersuchten Verbindungen wurden in Abwesenheit und in Gegenwart von Cu(II) bei verschiedenenpH-Werten berechnet. Die Ergebnisse werden mit dem Verhalten von Xanthin verglichen.