磺化聚醚醚酮／二氧化硅／磷钨酸导电复合膜的制备

1引言 直接甲醇燃料电池（DMFC）被认为是最适合发展可移动电源的选择之一，目前困扰DMFC发展的主要问题之一是所使用的质子交换膜（主要是杜邦公司的Nation膜）的阻醇性能较低。磺化聚醚醚酮膜（SPEEK）特有的微观结构使其阻醇性能明显的优于Nation膜，而较低的质子传导率、较差的机械性能以及溶胀等缺点限制了它的应用；本文通过在其中加入二氧化硅（SiO2）和磷钨酸（PWA）制备磺化聚醚醚酮／二氧化硅／磷钨酸导电复合膜，并考察了二氧化硅及磷钨酸对复合膜溶胀性能、质子传导率及机械性能的影响。     

XPS研究电抛光铜表面粘液膜的组成

金属的电抛光应用越来越广泛.但电抛光机理至今仍不很清楚.我们曾用 XPS 和AES 研究了不同槽电压下电抛光铜表面的组成和物种,确认其表面均为纯铜,不存在含磷固体膜.本文用 XPS 研究电抛光液中1-羟基乙叉-1,1-膦酸(HEDP)浓度、抛光液的 pH 及其接受体(H_3PO_4,HEDP 和 HEDP H_3PO_4)变化时铜的表面组成,并进一步证明,电抛光时形成的粘液膜是水溶性膜,铜表面在不同抛光条件下并不形成难溶的含磷固体膜.通过电子能谱对固化后粘液膜组成和深度分布的研究确定,粘液膜可能是铜的多核聚合混合配体配合物,其组成可近似地表示为[Cu_4(PO_4)(HEDP)]_n.     

穿过液膜的自发电势振荡

An artificial membrane consisting of pricramic acid in nitrobenzene was used as an oil phase imposed between two aqueous phases. The right one contained trimethyl-slearylammonium chloride and aicohol; and the left contained sucrose solution (or H_2O). We found that this system exhibited rhythmic oscillation of electrical potential. The amplitude of the oscillations was between 20—150 mV. The oscillations were observed even when ethyl alcohol was absent in the aqueous of trimethylslearylammonium Chloride, and the increase in amplitude of oscillation with time was found to be less in the presence of sucrose. Some of the expremental results have been explained.     

2-巯基乙醇自组装膜电极对多巴胺电催化氧化及其分析应用

在裸金电极上制备了 2 巯基乙醇自组装膜电极 (ME AuSAMs) ,研究了多巴胺 (DA)在ME AuSAMs上的电化学行为 ,发现该膜电极对DA的氧化具有良好的电催化作用 ,氧化过电位降低了 3 94mV ,测得DA的扩散系数D为 9.1 4 5× 1 0 - 7cm2 s,初步探讨了电催化机理。采用水平衰减全反射 傅里叶变换红外光谱 (ATR FTIR)技术对ME AuSAMs进行了表征 ;方波伏安法 (squarewavevoltammetry ,SWV)测定DA ,其氧化峰电流与DA浓度在 2 .0 0× 1 0 - 6 ～ 1 .0 0× 1 0 - 4 mol L范围内呈线性关系 ;相关系数为 0 .9998,检出限为 4 .0 0× 1 0 - 7mol L。该电极用于DA药物针剂的测定 ,结果满意     

以Cyanex272为载体的乳状液膜迁移和分离铅的研究

用Ｃｙａｎｅｘ２７２－Ｓｐａｎ８０－甲苯乳状液膜体系研究了铅的迁移行为，确定了铅迁移的适宜条件。在此条件下，许多常见离子如Ｃｕ＾２＋、Ｃｏ＾２＋、Ｎｉ＾２＋、Ｃｄ＾２＋等均不迁移，Ｈｇ＾２＋迁移率很低。因此Ｐｂ＾２＋能与这些离子得到快速且完全的分离。这对分析测定及三废处理等工作具有实际意义。     

Deposition of Layer－by－layer Inorganic－organic Nano－hybrid Ultrathin Films onto SBA－15

Deposition of inorganic-organic nano-hybrid ultrathin films onto mesoporous silicate materials has been proven possible by using layer-by-layer assembly method. In combination with sol-gel method, titania, subsequently dye molecules (or polymer) were successfully fabricated onto the inner wall of SBA-15. Their structures were preliminarily characterized by FTIR and solid-state UV-Vis spectroscopy, thermal analysis, and BET surface area measurements,respectively.     

N-甲基丙烯酰-N′-甲基哌嗪在嵌段聚醚氨酯膜上的Co60-γ辐射接枝的研究

The graft copolymerization of N-methacryl-N'-methyl-opiperazine onto segmented polye-therurethane (SPEU) film by Go⁶⁰-r-preirradiation has been studied. It is found that the grafting time varies with structure of different chain extenders. The grafted substrated become opaque, the contact angle drops down and from SEM photographs with salient micrograph showing grafts of macrochain on the surface of SPEU film.     

Synthesis of polypiperazine-amide thin-film membrane on PPESK hollow fiber UF membrane

A new interfacial polymerization (IP) procedure is developed in order to synthesize polypiperazine-amide thin-film membrane on the inner surface of poly(phthalazinone ether sulfone ketone) (PPESK) hollow fiber ultrafiltration (UF) membrane.A hollow fiber composite membrane with good performance was prepared and studied by FT-IR and scanning electron microscopy.