Scattering and Transmission by a Monolayer of Spheres: A Study on the Monolayer Structure

The angular distribution of scattered light and the transmission of radiation through a monolayer of monodisperse spherical particles at variable particle concentration are studied. The scattering of light by a single particle is calculated with the classical Lorentz‐Mie theory. For a monolayer of mono‐dispersed spherical particles, if the monolayer density is less than 0.5 and the particle size parameter is larger than 5, effects from multiple scattering and dependent scattering can be excluded so that only steric interactions are considered. It is found that the scattering pattern, especially in the forward and backward directions, and the transmission are strongly dependent on the monolayer density.     

两亲性卟啉的合成及其L—B膜

早期L-B膜的研制主要着眼于长碳链脂肪酸及其衍生物。近来,由于对膜性能的特殊要求,人们把注意力转向丁二炔、酞菁和卟啉衍生物。本文用四一(N,N-二甲基氨基苯基)卟啉(TDMAPP)与溴代十六烷反应得到两亲性的含有4个长碳链的澳化四-(4-     

Electrochemical Characterization of In Situ Functionalized Gold Cysteamine Self‐Assembled Monolayer with 4‐Formylphenylboronic Acid for Detection of Dopamine

Functionalization of gold cysteamine (Au? CA) self‐assembled monolayer with 4‐formylphenylboronic acid (BA) via Schiff's base formation, through in situ method to fabricate Au‐CA‐BA electrode is presented and described. The fabricated electrode was used as a novel sensor for accumulation and determination of dopamine (DA). The accumulation of DA as a diol on the topside of Au‐CA‐BA as a Lewis acid, was performed via esterification (Au? CA? BA? DA), and followed for determination of DA. Functionalization, characterization, and determination steps were probed by electrochemical methods like cyclic voltammetry and electrochemical impedance spectroscopy. The data will be presented and discussed from which a new sensor for DA is introduced.     

Electrochemically driven organic monolayer formation on silicon surfaces using alkylammonium and alkylphosphonium reagents

The functionalization of silicon surfaces with organic monolayers, bound through Si–C bonds, is an area of wide interest due to the technological promise of organosilicon hybrid devices, but also to investigate fundamental surface reactivity. In this paper, the use of alkylammonium and alkylphosphonium cations as sources of organic moieties to bind to hydrogen-terminated flat and porous silicon is demonstrated. Tetraalkylammonium, tetraalkyl/arylphosphonium reagents, and alkyl pyridinium salts can be utilized, but trialkylammonium salts cannot as they yield substantial surface oxidation. Under electrochemical conditions, either potentiostatic or galvanostatic modes, alkyl groups derived from the ammonium or phosphonium salts are grafted to the silicon surface and are bound through Si–C bonds. Covalent attachment of the organic monolayers to the surface was demonstrated by XPS, AFM scribing, and FTIR. The mechanism may proceed via reduction of the ammonium salt yielding alkyl radicals, R, which may be reduced to R⁻ and attack surface Si–Si bonds, leading to Si–C bonds, or the formation of silyl anions (≡Si⁻) under the cathodic conditions followed by nucleophilic attack on the trialkylammonium cation.     

Premicellar and micelle formation behavior of aqueous anionic surfactants in the presence of triphenylmethane dyes: protonation of dye in ion pair micelles

The premicellar and micelle formation behaviors of four cationic triphenylmethane dyes, viz, Pararosaniline (RN), Crystal violet (CV), Ethyl violet (EV), and Malachite green (MG), in aqueous anionic surfactant solutions of sodium dodecyl sulfate (SDS), sodium dodecyl benzene sulfonate (SDBS), and sodium dodecyl sulfonate (SDSN) have been studied by spectral and surface tension measurements. The study was carried out within a pH range where the dyes are stable in their quinoid forms. The dyes have been found to form dye–surfactant ion pairs (DSIPs) with the surfactants, at the surfactant concentrations well below their critical micelle concentration, CMC*. The DSIPs behave like nonionic surfactants and form an air–water interfacial monolayer. The DSIPs have a lower critical micelle concentration (CMC_IP), greater efficiency, and lower effectiveness than the corresponding pure surfactants. As the surfactant concentration is increased below the CMC*, the DSIPs start forming micelles of their own where the dye gets protonated and exists as a protonated dye–surfactant ion pair (PDSIP) in the ion pair micelles. As the concentration of the surfactant exceeds the CMC* of the pure surfactant, the protonation reverses gradually with the dye remaining in the micelles in solubilized form and the DSIPs in the air–water interfacial monolayer are replaced by pure surfactants. The distorted helical isomeric form (isomer B) of the dyes is favored in the PDSIPs. Copyright © 2009 John Wiley & Sons, Ltd.     

A novel method for elimination of the gold-islands formed in the self-assembled monolayers of benzeneselenol on Au(1 1 1) surface

Molecular ordering of benzeneselenol (BSe) self-assembled monolayers (SAMs) on Au(1 1 1) substrates have been investigated by scanning tunnelling microscopy (STM) [1]. After short immersion time (10 min), elevated islands with height of 2.4 Å were found to cover the entire gold surface. On and among the islands, the STM results exhibited the formation of a highly ordered phase (α-phase) by BSe species. In the present study, a novel method is presented to completely eradicate the elevated gold-islands. The method depends on a repetitive STM scanning over the same part of the SAM at restricted tunnelling conditions. After almost 6 h of successive scanning, the surface becomes clean and free of the elevated islands. Moreover, this method was found to induce phase transformation into β-phase. The size of the ordered domains of the β-phase was found to exceed five times that of α-phase. Such a long-range ordering of the β-phase at room temperature has not been previously observed for any system on Au(1 1 1). After detailed analyses, the β-phase was found to have a 33.5% of lower packing density than that of α-phase.     

Passivation of aluminum with alkyl phosphonic acids for biochip applications

Self-assembly of decylphosphonic acid (DPA) and octadecylphosphonic acid (ODPA) was studied on aluminum films using XPS, ToF-SIMS and surface wettability. Modified aluminum films were tested for passivation against silanization and subsequent oligonucleotide attachment. Passivation ratios of at least 450:1 compared to unprotected aluminum were obtained, as quantified by attachment of radio-labeled oligos.     

Thermal Effect on Positive Patterned Self-Assembled Monolayer Grown from a Droplet of Alkanethiol

Atomic force microscope technique is widely used for the spatial narrow deposition of molecules inside the bare space of preexisting self-assembled monolayer (SAM) matrix. Using molecular dynamics simulation, we studied the formation of positively patterned SAM from a globule of 1-octadecanethiol (ODT) on predesigned SAM matrix of 1-dodecanethiol (DDT) and effect of temperature on it. The alkyl chains of ODT SAM were densely packed and ordered by means of chemisorption through sulfur atoms. The circular SAM of ODT contained defects due to the molecules those were standing upside down or trapped inside ODT SAM. We found that with the increase of temperature, these defects moved out by flipping of inverted ODT molecules or building spaces to be adsorbed on Au surface. The ODT molecules on the top of the pile of stable circular SAM or those are upside down and trapped disperse in a unique fashion namely serial pushing through which molecules firstly make a free space to enter inside the adsorbed thiol molecules and then push neighboring molecules to get enough space to be adsorbed on the gold surface. The stability of ODT SAM was confirmed by analyzing different structural properties such as tilt angle, tilt orientation. and backbone orientation. We also calculated the diffusion coefficient of the ODT molecules which were on the top of SAM island. © 2019 Wiley Periodicals, Inc.     

Ultimate Charge Extraction of Monolayer PbS Quantum Dot for Observation of Multiple Exciton Generation

Multiple exciton generation (MEG) has great potential to improve the Shockley-Queisser (S-Q) efficiency limitation for colloidal quantum dot (CQD) solar cells. However, MEG has rarely been observed in CQD solar cells because of the loss of carriers through the transport mechanism between adjacent QDs. Herein, we demonstrate that excess charge carriers produced via MEG can be efficiently extracted using monolayer PbS QDs. The monolayer PbS QDs solar cells exhibit α=1 in the light intensity dependence of the short-circuit current density J_sc (J_sc∝I^α) and an internal quantum efficiency (IQE) value of 100 % at 2.95 eV because of their very short charge extraction path. In addition, the measured MEG threshold is 2.23 times the bandgap energy (E_g), which is the lowest value in PbS QD solar cells. We believe that this approach can provide a simple method to find suitable CQD materials and design interface engineering for MEG.