Dosimetric characterization of the Exradin W1 plastic scintillator detector through comparison with an in-house developed scintillator system

New commercial dosimetry systems need careful characterization and can benefit from the comparison with similar, in-house developed solutions. A comparison between such two dosimetry systems, both based on fibre-coupled organic plastic scintillator detectors, is presented. One system is the Exradin W1, fully commercialized by Standard Imaging, while the other system is the non-commercial ME40 system, developed by DTU Nutech with the aim of fundamental dosimetric research. Both systems employ plastic scintillator detectors that can be considered similar in design, calibrated using the same method, but differing primarily in the signal detection hardware. The two systems were compared with respect to essential dosimetric properties, with the purpose of testing their performance under conditions less well discussed in the literature. A Farmer ionization chamber was used as the primary reference of the comparison. The study demonstrated that the Cerenkov light ratio calibration coefficient of both systems was not constant, but changed systematically with photon beam quality to a maximum difference of 1.1%. Calibration with respect to stem effect correction should therefore be performed for every investigated beam quality when using plastic scintillator detectors. Both systems were found to be dose rate independent, even for the highest instantaneous dose rate evaluated (1.5 mGy per pulse). Low-dose measurements revealed large uncertainties for both systems, although the ME40 system handled short beam deliveries under reference conditions with accuracy and precision within 0.4%. Changes in response due to field size dependence were investigated and found to be as large as 3.3% for the W1 and 5.4% for the ME40, biasing output factor measurements in large fields. Great caution is therefore advised if using either system for measurements in large fields or under circumstances where the fibre irradiation geometry is unfavourable. Measurements of reference dose to water yielded differences up to 1.5% when compared with the Farmer ionization chamber for all investigated beam qualities.     

Passive infrared detector used for detection of very slowly moving of crawling people

The paper presents construction and principle of operation of passive IR detectors (PIR detectors) of a large detection range. Important virtue of these detectors is highly efficient detection of slowly moving or crawling people. The described here PIR detector detects crawling people at the distance of 140 m. To ensure high probability of detection of slowly moving objects, new method of signals analysis was applied. On the basis of the carried out real-time measurements, both probability of detection and false alarms were determined.     

Employing a Cerenkov detector for the thickness measurement of X-rays in a scattering background

The variation in environmental scattering background is a major source of systematic errors in X- ray inspection and measurement systems. As the energy of these photons consisting of environmental scattering background is much lower generally, the Cerenkov detectors having the detection threshold are likely insensitive to them and able to exclude their influence. A thickness measurement experiment is designed to verify the idea by employing a Cerenkov detector and an ionizing chamber for comparison. Furthermore, it is also found that the application of the Cerenkov detectors is helpful to exclude another systematic error from the variation of low energy components in the spectrum incident on the detector volume.     

Development and application of chip calorimeter as an X-ray detector

Radiotherapy for cancer patients requires accurate measurement of the absorbed dose of radiation in a treatment planning step. Various types of radiation detectors are currently utilized for dose measurement. Among them, calorimeters are known to be the most precise detector for measuring absorbed dose, but their on-site application is limited by the large size of the equipment. We developed a miniaturized chip calorimeter for application as a radiation detector. The calorimetric radiation detector was built using micro/nano fabrication techniques, and consists of an SU-8 photoresist absorber and high-sensitivity vanadium oxide (VO_x) thermistors. The thermistors had a temperature resolution of 135 μK, and the calorimeter showed a thermal conductance of 11 μW/K. The detector was irradiated with various X-ray dose rates from a linear accelerator, and the absorbed dose to SU-8 was measured. The detector responses showed high linearity with dose rates, demonstrating the feasibility of the radiation detector for practical uses.     

一种近红外探测器的光谱响应率测量

对近红外辐射功率光谱绝对响应率的定标技术进行了研究。设计了一种制冷扩展波长型的InGaAs探测器，为了使其能够作为功率传递的标准探测器工作在（1.2～2.5）μm波长范围，对探测器的光谱响应率进行了测量。首先在1260nm波长下进行绝对功率传递的标定试验，然后用基于红外单色仪的光谱比较系统（SCF）测量了探测器的相对光谱响应率。结合2个步骤的数据，最终可以得到探测器的绝对光谱响应率。     

Time calibration for the end cap TOF system of BESⅢ

The time calibration for end cap TOF system of BESⅢ is studied in this paper.It has achieved about 110 ps time resolution for muons in dimu events.The pulse height correction using electronic scan curve and the predicted time calculated using Kalman filter method are introduced.This paper also describes the study of using electrons and muous as calibration samples.     

Digital pulse shape discrimination methods for n-γ separation in an EJ-301 liquid scintillation detector

A digital pulse shape discrimination system based on a programmable module NI-5772 has been established and tested with an EJ-301 liquid scintillation detector. The module was operated by running programs developed in Lab VIEW, with a sampling frequency up to 1.6 GS/s. Standard gamma sources22 Na,137Cs and60 Co were used to calibrate the EJ-301 liquid scintillation detector, and the gamma response function was obtained. Digital algorithms for the charge comparison method and zero-crossing method have been developed. The experimental results show that both digital signal processing(DSP) algorithms can discriminate neutrons from γ-rays. Moreover,the zero-crossing method shows better n-γ discrimination at 80 ke Vee and lower, whereas the charge comparison method gives better results at higher thresholds. In addition, the figure-of-merit(FOM) for detectors of two different dimensions were extracted at 9 energy thresholds, and it was found that the smaller detector presented better n-γseparation for fission neutrons.     

Photogalvanic effect in asymmetric quantum wells and superlattices

We have investigated the influence of the final states of bound-to-continuum transitions within the conduction band of asymmetric quantum well structures on the photocurrent. This influence manifests itself by an energy-dependent oscillation of the current direction. We observe pronounced oscillations at zero bias voltage in a double quantum well structure, induced by an asymmetric excitation into continuum states with positive and negative momentum, i.e. by a photogalvanic effect (PGE). If this effect is superimposed on an asymmetric backrelaxation, similar oscillations are observed in the spectrum when the latter asymmetry is compensated by an external electric field. Theoretically, we find a strong relation between the PGE and a quantum interference effect occurring in the continuum.     

塑料闪烁光纤阵列成像探测器在高能X射线辐照下的串扰分析

采用蒙特卡罗方法对闪烁光纤阵列探测器在高能X射线入射下的串扰进行了模拟研究,并且分析比较了加铅层对串扰的影响.研究中采用对表征成像系统空间分辨率参量——调制传递函数进行模拟分析和比较,得到在光纤阵列之间加入不同铅层厚度后对系统调制传递函数参量曲线的影响.研究结果表明:在高能射线下,采用闪烁光纤阵列作为成像探测器存在严重的次级粒子相互串扰的现象,而在阵列之间加入铅介质能够减少这种效应;但另一方面,若所加铅层太厚又会导致成像探测器像素过大而使得空间分辨率下降.通过模拟计算得出:只要在阵列之间加入适当厚度的铅介质,既可以有效抑止阵列之间次级粒子的串扰,同时又能提高闪烁光纤阵列探测器系统的空间分辨率.     

一种实用化实时测温系统工作波长优化设计的进一步分析

基于Kirchhoff定律,依照测温系统的各主要技术参数与各主要技术指标(温度分辨力、测温灵敏度、相对测温灵敏度及测温准确度)之间的关系,对利用激光并采用钽酸锂热释电探测器作光电转换器件的实用化实时测温系统的工作波长进行了进一步的优化设计.实验表明,在测温范围400~1200 ℃内,系统的测温误差符合设计要求.