中性载体阳离子电极膜电化学的计算机数字模拟

对中性载体阳离子电极膜3种可能的传输模式进行了数字模拟,研究了淌度、浓度、配合物稳定常数以及阴离子亲脂性对电极电位响应的影响。模拟结果对于廓清这类电极响应机理,解释有关实验现象及指导新电极设计提供了有用的信息。     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

Early-stage flocculation kinetics of polystyrene latex particles with polyelectrolytes studied in the standardized mixing: Contrast of excess and moderate polyelectrolyte dosage

Standardized mixing procedure was applied to the analysis of flocculation of polystyrene latex (PSL) particles with polyelectrolytes. After confirming the initial enhancement of flocculation rate in the very beginning followed by abrupt stop with excess dosage, attention was shifted to the system of moderate dosage. In the former, effects of ionic strength were further analyzed to find the consistency with adsorption isotherm. In the latter, flocculation started slowly in the beginning, sometime slower than salt-induced rapid coagulation, however, the rate gradually increases in the middle stage. Often, the increased rate exceeds that of salt-induced rapid coagulation. This behavior emerged more clearly in the case of lower ionic strength. This is the indication that the rate of relaxation of polymer on the colloidal surface is a function of surface coverage and ionic strength. The ultimate degree of flocculation is usually higher than that observed for excess dosage. The size distribution of flocs was also examined, however, no clear difference between different experimental conditions was confirmed for the same degree of flocculation.     

光度检测离子色谱法测定大豆中的植酸

本文介绍了用光度检测离子色谱法分离分析植酸的适宜条件。以NaNO_3和HNO_3为淋洗液,用磺基水杨酸和三氯化铁为柱后衍生试剂,使用国产YSA型阴离子分离柱分离和测定了大豆中的植酸,得到满意的结果。     

磷钼酸铵-孔雀绿-PVA分光光度法测定钽粉中磷

提出了以磷钼酸铵-孔雀绿-PVA三元络合物体系测定金属钽粉中磷的方法,该体系表观摩尔吸光系数ε=8.19×104L.mol-1.cm-1,加标回收率为:99.3%~105%,方法的RSD为:5.9%。有效地解决了目前高纯钽粉中磷的分析难题,方法已应用于实际产品的分析中。     

Electrostatics of phosphatidic acid monolayers: Insights from computer simulations

In this paper, we argue that many of the fascinating electrostatic effects that take place in amphiphilic systems are strongly related to the particular organization of the oxygen atoms within each individual molecule. In particular, we focus on two effects: charge inversion and dielectric overscreening. For that purpose, we present molecular dynamics simulations of phosphatidic acid (DMPA²⁻) in the presence of divalent counterions. Our results show that the many oxygens present in DMPA²⁻ cooperatively create strong binding sites for counterions, which in some cases lead to charge inversion. We also present an analysis of the role of interfacial water and relate our analysis to the phenomenon of dielectric overscreening. Several experimental implications are discussed in the conclusions.     

电沉积羟基磷灰石/TiO2复合涂层

结合强度;电沉积羟基磷灰石/TiO2复合涂层     

利用天然斜发沸石从高离子强度的强碱性溶液中吸附和洗脱K+和Rb+的研究

在80℃下，用间歇法研究了NH4^ 型天然斜发沸石对某厂高离子 强碱性循环液中的K^ 和Rb^ 的吸附，得到不同粒度天然斜发沸石对K^ 和Rb^ 的交换吸附量，用不同浓度的NH4HCO3溶液对沸石进行洗脱再生，是到洗脱速率随着洗脱液浓度增大而增大。本文对沸石与钾含量很高的高离子强度强碱性溶液中碱金属的交换吸附和洗脱过程进行了初步探讨。     

三磷酸胞苷在Duolite A-30树脂上的交换过程研究

根据CTP在离子交换树脂上的吸附容量和分离因数的大小,确定Duolite A-30树脂适合CTP与CDP,CMP之间的分离.对CTP在Duolite A-30树脂上的吸附动力学和热力学研究表明,在283.15K~303.15K之间,CTP的质量浓度在7.5g/L以上时,Duolite A-30树脂对CTP的吸附主要受颗粒扩散的控制,其有效扩散系数为D=3.47×10-7cm2/s,溶液的质量浓度≤1.0g/L时,CTP与Duolite A-30树脂之间的交换速率主要受液膜控制,其液膜扩散系数为Kf =4.112×10-4/s.同时测定了不同条件下三磷酸胞苷溶液在Duolite A-30树脂固定床离子交换柱中的穿透曲线,研究了进口浓度、进口流速、原料液温度、原料液的pH值及柱高对穿透曲线的影响.用二阶动力学推动力模型描述固定床动态过程,考察了轴向返混对穿透曲线的影响,并从穿透曲线回归得到总传质系数,模型计算值与实验数据符合良好.     

Second Dissociation Constants of 4-[N-morpholino]butanesulfonic Acid and N-[2-hydroxyethyl]piperazine-N′-4-butanesulfonic Acid from 5 to 55°C

The values of the second dissociation constant, pK ₂, for the dissociation of the NH⁺ charge center of the zwitterionic buffer compounds 4-(N-morpholino)butanesulfonic acid (MOBS), and N-(2-hydroxyethyl)piperazine-N-4-butanesulfonic acid (HEPBS) have been determined from 5 to 55°C, including, 37°C at intervals of 5°C. The electromotive-force (emf) measurements have been made utilizing hydrogen electrodes and silver–silver chloride electrodes. The value of pK ₂ for MOBS was found to be 7.702 ± 0.0005, and 8.284 ± 0.0004 for HEPBS, at 25°C, respectively. The related thermodynamic quantities, G ^o, H ^o, S ^o, and C _p ^o for the dissociation processes of MOBS and HEPBS have been derived from the temperature coefficients of pK ₂. Both the MOBS and HEPBS buffer materials are useful as primary pH standards for the control of pH 7.3 to 8.6 in the region close to that of physiological fluids.