X射线荧光光谱检测多层薄膜样品的增强效应研究

研究了X射线荧光光谱检测多层薄膜样品的增强效应。根据多层膜中的X荧光强度理论计算公式编写了计算机程序,并计算了Zn/Fe和Fe/Zn双层膜样品中不同薄膜厚度时Fe Kα的一次荧光强度、二次荧光强度、二次荧光与一次荧光强度比以及二次荧光在总荧光强度中比例。研究发现,在多层膜样品的X射线荧光分析中,激发条件不变的情况下,元素谱线的一次荧光相对强度、二次荧光相对强度和二次荧光在总荧光强度中所占比例都随薄膜厚度及位置的变化而变化。当Fe和Zn层厚度相同时,随厚度的变化,对于Fe/Zn样品,Fe Kα二次荧光强度占总荧光强度最高为9％,而对于Zn/Fe样品这一比例最高可达35％。     

荧光法研究对羧基苯偶氮基杯[8]芳烃与诺氟沙星的作用

合成了一种超分子探针对羧基苯偶氮基杯[8]芳烃(简称CPAC).利用荧光光谱法研究了溶液状态下该探针与诺氟沙星(简称NFLX)的相互作用.实验表明,两者之间存在较强烈的相互作用,CPAC与NFLX形成外式包结物,静态猝灭NFLX的荧光,CPAC的杯腔体与NFLX的喹啉环间的疏水作用是主要作用方式.测定了该反应的结合常数(K=6.38×105 L·mol-1)和结合比(n=1).实验发现,小牛胸腺DNA能夺取CPAC-NFLX体系中的CPAC,使NFLX游离,说明超分子化合物CPAC可用于诺氟沙星药物的储存和定点释控.     

8-羟基喹啉快速共沉淀分离富集原子吸收光谱法测定啤酒中的Cu和Pb

研究了用8-羟基喹啉-Mg(Ⅱ)共沉淀体系,以Mn(Ⅱ)为内标,快速共沉淀分离富集啤酒中的铜和铅,并用火焰原子吸收光谱(FAAS)测定的方法。共沉淀受pH值、载体镁和内标锰用量的影响。结果显示在pH为9的条件下,能够定量共沉淀试样中的铜和铅。当试液为100 mL时,方法的检出限分别为铜6.28×10-3 μg·mL-1,Pb 2.26×10-2 μg·mL-1回收率为97.6%～103.0%,基本消除了基体干扰,取得了较为满意的结果。该方法无需收集全部沉淀,与传统的共沉淀方法比较,克服了收集沉淀费时的缺点。方法快速、简便、重现性好。     

基于支持向量机测定水质中硝酸盐含量

针对水质中被测物硝酸盐与干扰物铁离子、铬离子紫外吸收谱线严重重叠的问题,将支持向量机应用于混合重叠光谱分析中,利用核函数将重叠的光谱数据进行高维空间变换后求得SVM回归模型,实现硝酸盐含量的光谱检测。实验结果表明:硝酸盐浓度在0.5—10mg/L范围内,所测得含量的最大相对误差为3.2%;平均回收率为100.9%,本法与传统的方法相比,要求条件较低,不需要物理或化学的分离,分析速度快,有望应用于在线监测污水中硝酸盐的含量。     

探测器横纹误差对大孔径静态干涉成像光谱仪影响的建模与修正

大孔径静态干涉成像光谱技术在航天遥感应用中,由于探测器横纹误差影响,使获得的干涉数据无法反演光谱数据,需要对横纹误差进行修正。通过对干涉成像机理的分析,给出探测器横纹误差影响下的干涉成像模型,提出横纹误差影响下干涉数据修正方法。最后利用仪器获取的数据,对提出的修正方法进行验证,由处理结果可以看出,本文所提的修正方法可以很好的修正横纹误差对光谱的影响,提高反演光谱的精度。     

基于双向偏振态激光诱导荧光方法的离子速度分布函数测量

为了评估利用发散磁场构型双电层效应的紧凑式螺旋波等离子体推力器的离子加速效果,探索了一种双向偏振态激光诱导荧光测量方法来对螺旋波等离子体源近出口端的离子速度分布函数进行测量。实验中采用Ar作为螺旋波等离子体源工质,中心波长为611.662 nm的激光以轴向方式注入等离子体,以激励一价Ar离子获得波长为461.086 nm的诱导荧光光谱。为了消除磁化等离子体中逆塞曼效应对激光诱导荧光光谱带来的分裂影响,通过四分之一波片将入射激光分别调制为左旋和右旋圆偏振态,并对其诱导光谱进行了分别测量,结果发现不同磁场强度下两次测量结果的偏移值与理论高度吻合,证明了双向偏振态激光诱导荧光测量方法的理论可行性。进一步,采用高斯型滤波器反卷积算法从测量光谱中去除自然展宽和能量饱和效应,再通过对两次相反偏振态测量结果进行平移处理消除逆塞曼效应,从而分离得到实际的多普勒效应。测量了射频能量600 W,不同轴向位置、磁场大小以及气体压力下的螺旋波Ar等离子体激光诱导荧光光谱,结果表明在该实验条件下离子并没有因双电层效应而达到期望值的加速效果,离子速度的形成可能只是一种磁约束作用下的双极电场所导致,并不能产生好的推力性能。     

Magnetoresistance studies of MeV ranged H and C ion irradiated HOPG flakes

2 MeV protons and 1 MeV carbon ions are bombarded on highly oriented pyrolytic graphite (HOPG) samples and their electronic transport measurements are carried out in the presence of magnetic field. The Magneto-Resistance (MR) measurements show measurable hysteresis in the resistance value after ion beam irradiation for the in-plane magnetic field direction as well as for the out-of-plane field direction. The MR depends on the thickness of the flake and the method of its separation from the bulk HOPG. The results substantiate that the ferromagnetic coupling between the magnetic moments at the vacancy defect sites in HOPG sensitively depends on the average defect separation. The average defect separation range of 1.7–0.5 nm allows only a part of the 40 μm thick proton beam irradiated sample to go for ferromagnetic ordering. Similar conclusions are drawn from carbon ion irradiated HOPG flake. The irradiation increases the resistance of the flake as well.     

Influence of aging time of the starting solution on the physical properties of fluorine doped zinc oxide films deposited by a simplified spray pyrolysis technique

Fluorine doped zinc oxide (FZO) films were fabricated from fresh and aged (4, 8, 12 and 16 days) starting solutions using a simplified and low cost spray pyrolysis technique. The X-ray diffraction study showed that the preferential orientation is along the (0 0 2) plane for all the films irrespective of the age of the solution. The crystallite size calculated using the Scherrer’s formula is comparatively smaller only for the film prepared from the starting solution having aging time 4 days which may be due to the efficient incorporation of fluorine atoms into the ZnO lattice. This phenomenon is confirmed by the minimum resistivity value (3.14 × 10⁻² Ω cm) obtained in this particular case. The visible transmittance and the optical band gap values are found to be in the range of 63–83% and 3.20–3.31 eV, respectively. The optical transmittance is found to decrease gradually as the aging time of the solution increases and the optical band gap is found to be slightly higher in the case of the film prepared from the fourth day solution. The scanning electron microscopy results depicted that the microstructure of ZnO:F films are largely influenced by the aging of the starting solution.     

The interfacial properties of MgCl2 films grown on a flat SiO2/Si substrate. An XPS and ISS study

The interaction between MgCl₂ and SiO₂ was investigated by X-ray photoelectron spectroscopy (XPS), ion scattering spectroscopy (ISS) and contact potential difference (CPD) measurements. A thin SiO₂ layer was grown for this purpose on a Si(1 0 0) wafer and MgCl₂ was applied on this support at room temperature by evaporation under UHV conditions. It was found that magnesium chloride is deposited molecularly on the SiO₂ substrate, growing in layers and covering uniformly the oxide surface. The interaction with the substrate is initially very weak and limited to the interfacial layer. Above 623 K, most of the molecular MgCl₂ is re-evaporated and the interfacial interaction becomes stronger, as Mg-Cl bonds in the remaining sub-monolayer chloride break and Cl atoms desorb. This leaves on the surface sub-stoichiometric MgCl_x, which interacts with oxygen atoms from the substrate to form a complex surface species. At 973 K all Cl atoms desorb and Mg remains on the surface in the form of an oxide.     

三维荧光光谱的特征区域选择方法

将数学中的二元凸函数判定和数据挖掘中的聚类分析方法结合,提出了针对三维荧光的光谱区域选择方法,并利用此种方法从光谱图中提取出含有丰富光谱信息的凸集区域。对水体中总有机碳的检测和白酒中黄曲霉素的检测进行了实验研究,实验结果表明,采用本文提出的三维荧光光谱区域选择方法提高了模型的精度,与利用全光谱所建立的回归模型相比,模型精度分别提高了6.17%和4.97%。