Use of a peroxidase reactor in flow injection analysis for the determination of chloramine and the inhibition kinetics

A method for the determination of chloramine using a flow injection peroxidase reactor based on the inhibition reaction of the enzyme is developed. The immobilisation of the horseradish peroxidase is performed on the commercial polymer carrier VA Epoxy Biosynth. The peroxidase activity is detected photometrically based on the dehydration of the dye 2,2′-azino-di-[3-ethylenebenzthiazoline-6-sulphonate] (ABTS). The calibration of the method gives a linear concentration range from 0.026 to 1.04 mmol l⁻¹ (SD_n=3=below 5%). The detection limit was calculated to 26 μmol l⁻¹. A mixture out of competitive and non-competitive inhibition was analysed based on the Lineweaver–Burk plots.     

Cu-Sn-P镀层的组成及耐腐蚀性能研究

运用AES和XPS分析了Cu-Sn-P镀层的组成,研究显示Cu-Sn-P合金镀层的原子百分数为：Cu 87.42%, Sn 4.92%, P 2.85%, Fe 2.23%和O 2.52%。提出了采用1-苯基-5-巯基四氮唑(PMTA)对Cu-Sn-P镀层表面进行再处理后在镀层表面形成了薄而致密的配合物保护膜,它既增强了镀层耐10%NaCl溶液和1%H_{2S气体的腐蚀能力,又不影响镀层表面的金色外观,其防变色效果优于苯并三氮唑(BTA)、2-巯基苯并噻唑(MBT)和2-氨基嘧啶(2-AP)。}     

Morphology and mechanical properties of extruded ribbons of LDPE/PA6 blends compatibilized with an ethylene-acrylic acid copolymer

Two grades of low density polyethylene (LDPE) were blended with polyamide-6 (PA) in the 75/25 and 25/75 wt/wt ratios and shaped into ribbons with a Brabender single screw extruder. An ethylene-acrylic acid copolymer (EAA) was used in the 2 phr concentration as a compatibilizer precursor (CP). The morphology of the ribbons and its evolution during high temperature annealing were investigated by scanning electron microscopy (SEM). The results confirmed that EAA does actually behave as a reactive compatibilizer for the LDPE/PA blends. In fact, in the presence of EAA, the interfacial adhesion is improved, the dispersion of the minor phase particles is enhanced and their tendency toward fibrillation is increased, especially for the blends with the higher molar mass LDPE grade. The mechanical properties of the latter blends were found to be considerably enhanced by the addition of EAA, whereas the improvement was relatively modest for the blends with the lower molar mass LDPE. The fracture properties of double end notched samples of the ribbons prepared with the blends containing the lower molar mass LDPE grade were also studied. It was shown that, despite of the increased interfacial adhesion caused by the presence of EAA, the latter plays a measurable positive effect on the fracture properties only for the blends with LDPE as the matrix.     

Structure and Photo‐Damage Resistance of Li‐Rich LiNbO3 Crystals Co‐Doped with Zn2+/Er3+

The pure congruent LiNbO₃, Er:LiNbO₃ and Zn,Er co‐doped Li‐rich LiNbO₃ crystals were grown by Czochralski method. The X‐ray diffraction method and ultraviolet‐visible absorption spectra of the crystals were used to analyze the structure of the crystals. The photo‐damage ability resistance of the crystals was measured. The Zn,Er co‐doped Li‐rich LiNbO₃ crystals show a decrease in lattice constant values, a shift in absorption edge of ultraviolet‐visible absorption spectra towards shorter wavelength, and three orders of magnitude increase in photo‐damage resistance compared to congruent LiNbO₃ crystal. The intrinsic and extrinsic defects are discussed to explain the enhance of the photo‐damage ability resistance     

新型PTC热敏电阻的特性测量及其应用

简述了新型有机材料ＰＴＣ热敏电阻的特性、测量方法、实验结果及应用前景并与陶瓷ＰＴＣ热敏电阻进行了比较。     

Fe/Al2O3/Fe隧道结特性分析

用离子束溅射方法制备磁性隧道结(MTJ). 研究MTJ样品的隧道结磁电阻(TMR)效应.用X射线 光电子能谱分析了MTJ的软、硬磁层和非磁层及其界面的化学组成与微结构.研究了MTJ的微 结构对氧化铝势垒高度与有效宽度和TMR效应的影响. 关键词： 磁性隧道结 X射线光电子能谱 隧道结磁电阻     

接触电阻的测量

本文介绍了如何测量接触电阻     

Collapse of quantized Hall resistance and breakdown of dissipationless state in the integer quantum Hall effect: filling factor dependence

Magnetic field dependence of critical current for collapse of quantized Hall resistance I_cr(collapse) and critical current for breakdown of dissipationless state I_cr(breakdown) have been measured near the filling factor ν=4 of Landau levels in a GaAs/AlGaAs heterostructure Hall bar. The difference I_cr(breakdown)−I_cr(collapse) decreases against the increase and the decrease in ν from 4 and the critical behavior disappears outside of the region 3.85<ν<4.15.     

基坑支护设计的弹性抗力法

本文对基坑支护设计中常用的设计方法作了评述 ,阐述了弹性抗力法的基本原理 ,对计算时土压力分布模式的选择问题和多支撑板桩墙计算模型位移协调问题给出了明确答案 ,最后通过实例分析阐明了采用弹性抗力法进行基坑支护设计的思路和步骤。     

非晶态分子合金低温制备纳米复合氧化物La~1~-~xCa~xMnO~3

钙钛矿型稀土锰氧化物La~1~-~xCa~xMnO~3(RE=La,Pr,Nd,Gd;T=Ca,Sr,Ba,Pb等)因其特殊的巨磁电阻效应,引起人们广泛的关注。用非晶态的分子合金为前驱体,制备了一系列具有纳米尺寸的La-Ca-Mn-O复合氧化物颗粒。研究表明,前驱体的晶化温度对纳米颗粒的形貌和大小均有影响。当晶化温度为450℃-600℃时,从透射电子显微镜观察到的颗粒大小约为25nm-100nm。该纳米材料的磁及磁电阻行为不同于其体相体系,其交流磁化率表现出较较强的尺寸依赖性,而磁电阻具有本征型和自旋隧穿型的巨磁电阻行为。