一种微穿孔板消声器

本文根据马大猷教授提出的“微穿孔板吸声体精确理论”，在对微穿孔板消声器结构参数与吸声特性之间的相互影响进行了分析的基础上，设计了微穿孔板消声器并将其应用在新舟60飞机APU(辅助动力装置)降噪的实际工程中，并通过编写的噪音数据采集分析程序，对降噪效果进行了测试和分析，验证出微穿孔板消声器对消除飞机的APU的排气噪声具有良好的消声效果，平均降噪7．16dB。     

全内反射荧光显微术应用于单分子荧光的纵向成像

利用这种显微术中激发场的纵向强度呈指数衰减的分布特性，测得的荧光强 度将强烈依赖渗透深度（强度衰减到1/e时的距离），从而快速直接的确定单分子荧光 团间的纵向间隔、每个荧光团的纵向绝对位置和荧光团的半径大小，即实现荧光分子三维分 布的重构.在整个重构的过程中，只需要改变一次入射角的大小，即只需探测两幅荧光分子 的全内反射成像. 关键词： 全内反射荧光显微术 纵向重构     

What Oxidation State of Iron Determines the Amethyst Colour?

A colourless quartz crystal doped with ⁵⁷Fe³⁺ was obtained by hydrothermal synthesis in an NH₄F solution. The crystal was transformed into violet amethyst by gamma-irradiation. The change in colour was accompanied by changes in the Mössbauer spectrum that can be interpreted as the conversion of trivalent iron into the tetravalent state: Fe³⁺→Fe⁴⁺.

     

富勒烯(C_(60)/C_(70))与N,N,N′,N′-四-(对甲苯基)-4,4′-二胺1,1′-二苯硒醚(TPDASe)间光诱导电子转移过程的激光光解研究

富勒烯 (C60 /C70 )与N ,N ,N′ ,N′ 四 (对甲苯基 ) 4,4′ 二胺 1,1′ 二苯硒醚 (TPDASe)间在激光光诱导条件下 ,发生了分子间的电子转移过程 .在可见 -近红外区 ( 60 0～ 12 0 0nm) ,观测到了TPDASe阳离子自由基、富勒烯 (C60 /C70 )激发三线态和阴离子自由基 ,在苯腈溶液中 ,观测瞬态谱测定了电子从TPDASe转移到富勒烯 (C60 /C70 )激发三线态的量子转化产率(ΦTet)和电子转移常数 (Ket) .     

碱蓝6B共振光散射法检测DNA

研究了碱蓝 6B与脱氧核糖核酸在酸性条件下共振光散射特征 ,考察了影响因素和最佳反应条件 ,建立了一种测定纳克级DNA的方法。在四硼酸钠 盐酸 (pH =2 90 )缓冲溶液中 ,线性范围为 10～ 10 0 4 μg·L- 1 ,相关系数为 0 9913,检出限为 4 2 μg·L- 1 ,用于合成样品的测定结果令人满意。     

Volumetric and infrared measurements on amorphous ice structure

We have simultaneously used adsorption isotherm volumetry and Fourier transform infrared spectroscopy in order to take the investigations on amorphous ice structure a step further, especially concerning porosity and annealing-induced modifications. We have studied surface reorganization during annealing and found that the number of surface sites decreases before crystallization, their relative ratios being different for amorphous and crystalline ice. We also present results confirming that ice can have a large specific surface area and nevertheless be non-microporous.     

Ultrasonic spectroscopic evaluation of the ring‐opening metathesis polymerization of dicyclopentadiene

An in situ ultrasonic spectroscopy technique was used to study the ring‐opening metathesis polymerization of dicyclopentadiene catalyzed by bis(tricyclohexylphosphine)benzylidene ruthenium dichloride. A reaction cell employing a flexible poly(ethylene terephthalate) window for pulse echo ultrasonic spectroscopy was used to monitor the polymerization. The changes in the density, wave speed, acoustic modulus, and attenuation were all simultaneously monitored. In comparison with Fourier transform infrared (FTIR) spectroscopy data, the changes in the density, velocity, and modulus only accurately measured the rate constant for the metathesis of the cyclopentyl unsaturation. The ultrasonic values were within 6% of the values determined by FTIR. The activation energy for metathesis of the cyclopentyl unsaturation was 84 kJ mol^?1, following first‐order kinetics. Rate constants for the polymerization of the norbornyl unsaturation could not be determined by ultrasound. The gel point, vitrification, and qualitative information about the reaction rate could be determined from the change in the attenuation. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1323–1333, 2003     

Atomic distributions in acetylene-air flame using hydraulic high-pressure nebulization with direct (100%) introduction of solutions Applications to speciation analysis

One of the fundamental factors of the performance of atomic spectrometric methods is the efficiency of sample introduction into flame or plasma. By utilization of the formerly developed hydraulic high-pressure nebulizer, a nebulizer/burner system with solution uptake efficiency of 100% have been worked out. Optimizing operation parameters of nebulizer/burner system, an improvement of 2-12 times was achieved for the signal-to-noise ratio in the flame emission and flame atomic absorption spectrometry, depending on sample flow rate. This nebulizer is especially suitable for development of liquid chromatography-AAS/FES coupled technique for speciation analytical tasks.     

Preparation and properties of the biodegradable graded blend of poly(L‐lactic acid) and poly(ethylene oxide)

We prepared biodegradable poly(ethylene oxide) (PEO)/poly(L ‐lactic acid) (PLLA) graded blends by the dissolution–diffusion process, and discussed the biodegradability and tensile strength of the graded blends by comparing isotropic blend and PLLA only. All the graded blends were degraded more largely than the PLLA only and isotropic blend (PEO: 37.5 wt %), which had the same content as the total content of those graded blends. The graded blend having most excellent wide compositional gradient was degraded most largely with the enzyme. Thus, graded structure of the blends promoted their biodegradabilities large. It was considered that the dissolution of PEO with water increased the surface area attacked by the enzyme, while PEO caught PLLA oligomers to promote the biodegradation of PLLA. Then, the biodegradabilities of the graded blends were suppressed by the increasing crystallinity of PLLA. Furthermore, the strengths of all the graded blends were larger than those of the isotropic blend. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2972–2981, 2007     

Chlorination of aromatic substrates catalyzed by the phthalocyanine complexes

The chlorination of benzene, toluene, and o-xylene with molecular chlorine in the presence of the phthalocyanine complexes of different structures was studied. The transformations of the catalysts during the reaction were investigated. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1644–1647, August, 2008.