Analysis of electron energy distribution function in a magnetically filtered complex plasma

The electron energy distribution function (EEDF) for a magnetically filtered dusty plasma is studied in a dusty double plasma device where the electron energy can be varied from 0.15 eV to ～ 2.8 eV and plasma density from 10 6 cm-3 to 10 9cm-3 . The characteristics of EEDF for these ranges of plasma parameters are investigated in a pristine plasma as well as in a dusty plasma. The results show that in the presence of dust, there is a drastic modification in EEDF patterns in a plasma with higher electron temperature and density than those in a low temperature and low density plasma produced by the magnetic filter.     

电子束在等离子体微波器件中的脉动

 对填充等离子体漂移空间小脉动电子束进行了近似分析,对大脉动电子束进行了较精确的计算,结果表明虽然α区和β区束的脉动性能各不相同,但幅度和波长均受限于电子入射的初始条件和等离子体参数,当其它条件给定后存在一最佳等离子体填充密度。     

液体中激光等离子体冲击波波前传播特性研究及测试

将空气中球对称冲击波衰减波前传播公式推广到非完全中心对称情况，根据对光学阴影法对激光等离子体冲击波波前测试数据的计算分析，提出液体中点源激光等离子体冲击波旋转椭球面波前传播公式.并且用声学方法对水中和酒精中的激光等离子体冲击波波前进行实验测试，结果表明测试结果与计算公式相吻合. 关键词： 激光 等离子体冲击波 旋转椭球面     

厄尔尼诺和南方涛动海气耦合模型中参数估计的变分方法

提出一种基于变分原理估计厄尔尼诺和南方涛动海气耦合模型中未知参数的方法. 首先将所研究的非线性海气耦合动力方程引入到目标泛函中; 接着利用变分方法导出伴随方程和待辨识参数泛函梯度的公式; 然后设计了估计未知参数的算法.数值试验结果表明变分方法是一 种能有效估计海气耦合非线性系统未知参数的方法.     

Quantitative Determination of Silicon in Organosilicon Compounds Using Low-Temperature RF-Discharge Oxygen Plasma

Abstract

The paper describes a technique for quantitative determination of silicon in organic monomer and polymer materials based on low-temperature decomposition of samples in rf-discharge oxygen plasmas. The final step of analysis involves gravimetric determination of silicon in the form of silicon dioxide. The presence of fluorine (up to 50%) does not interfere with the determination of silicon.     

Determination of Iron in Calf Serum Using Bathophenanthroline and Thermal Lens Spectrometry

ABSTRACT

Thermal lens spectrometry has been used for the determination of iron in calf serum. The method is based on dissociation of Fe³⁺ from proteins, reduction of Fe³⁺ to Fe²⁺ and formation of a coloured complex between Fe²⁺ and bathophenanthroline. Contrary to the spectrophotometric method, it is shown that thermal lens spectrometry is less sensitive to scattering caused by the presence of small particles remaining in the test solution after the deproteinization step. The background signal is very small and the response is only slightly dependent on the amount of scattering particles. The method is reliable, sensitive and reproducible. The limit of detection for iron is 4 ppb and the relative standard deviation is around 2%. It is expected that the volume of serum sample necessary for an analysis can be reduced to less than 100 μl.     

Electron Capture Determination of Propoxyphene from Human Plasma

Abstract

A procedure for the determination of propoxyphene (α-d-dimethylamino-1, 2 -diphenyl-3 -methyl-2 -propionoxybutane) in plasma is reported. The method is based on the electron capture characteristics of propoxyphene. The plasma is rendered basic to generate the free amine and extracted with ether. The extract is analyzed by gas chromatography using a 4 foot OV-225 column. An internal standard of imipramine hydrochloride is used to quantitate the propoxyphene. This internal standard is carried through the entire procedure. The ratio of the peak heights of propoxyphene to imipramine is compared to ratios obtained from standards placed in plasma and treated in the same manner as the samples. Six subjects were given propoxyphene at different time intervals, and the data are presented concerning these subjects.     

Determination of Lead in Human Hair by High Resolution Continuum Source Graphite Furnace Atomic Absorption Spectrometry with Microwave Digestion and Solid Sampling

The content of lead in human hair was measured by high resolution continuum source graphite furnace atomic absorption spectrometry (HR-CS GFAAS) combined with microwave-assisted digestion (MAD) and direct solid sampling (DSS). Hair strands were washed, dried, and then cut into three parts (root, middle portion, and tip). For MAD-GFAAS assays, approximately 0.25 g of hair was completely digested using a mixture of concentrated nitric acid and hydrogen peroxide in a closed system. In the DSS-GFAAS assays, 0.1–0.2 mg of dried hair was directly introduced into a graphite furnace using a solid autosampler. The temperature programs were optimized and the effects of various added modifiers were compared. The results indicated that NH₄H₂PO₄ was the optimal modifier for analysis of Pb using GFAAS. Use of the optimal modifier and temperature program gave similar limits of detection for MAD-GFAAS and DSS-GFAAS of 1.16 ng/g and 0.82 ng/g, respectively. Both methods also produced satisfactory recoveries ranging from 98.69% to 103.14%. There was no significant difference observed between the Pb contents of hair strands determined by the MAD-GFAAS and DSS-GFAAS assays, which both indicated that the Pb levels increased along the hair strands. Comparison of the two methods revealed that DSS-GFAAS had several advantageous characteristics over MAD-GFAAS, including the need for much less sample material and having a less time-consuming procedure, lower sample blank absorbance, lower memory effect, and no risk of environmental pollution by digesting chemicals. The direct solid sampling technique can be employed as a good alternative to conventional wet digestion in AAS assays.     

Separation and Analysis of o.p'-DDD and its Lipophilic Metabolite,O.P'-DDE,in Tissue,Faeces and Plasma

Abstract

An analytical procedure based on electron capture gas chromatography for the determination of o,p′-DDD, a drug used for the treatment of Cushing′s syndrome, is presented. Detection of a metabolite, identified as o,p′-DDE, is also described.     

Transformation of macromonomers into ring‐opening polymerization macroinitiators: A detailed initiation efficiency study

In the present study, n‐butyl acrylate macromonomer (BAMM) (M_n = 1900 g mol^?1; PDI = 1.96) has been synthesized via a high‐temperature polymerization process. Subsequently, the olefinic termini of the BAMM have been transformed into a diol via a dihydroxylation process using KMnO₄ as an oxidizing agent. The OH‐terminated macroinitiator pBA(OH)₂ has subsequently been employed for the ring‐opening polymerization (ROP) of ε‐caprolactone via various catalytic systems, that is, organo‐(1,5,7‐triazabicyclo[4.4.0]dec‐5‐ene), metal (tin(II) 2‐ethylhexanoate), and enzymatic catalysis (Novozym® 435). The obtained pBA‐b‐pCL block copolymers and the initiation efficiency of the BAMM macroinitiator have been investigated via size exclusion chromatography (SEC), electrospray ionization–mass spectrometry (ESI‐MS) hyphenated with SEC and liquid chromatography at the critical conditions of both poly(ε‐caprolactone) (pCL) and pBA. The in vitro enzyme catalysis (eROP) approach proved to be the most efficient catalysis system due to minor transesterification side reactions during the polymerization process. However, side reactions such as transesterifications occur in each catalytic system and—while they cannot be suppressed—they can be minimized. The species generated during the eROP process include the desired block copolymer pBA‐b‐pCL as main species as well as pCL homopolymer and residual macroinitiator pBA(OH)₂. © 2012 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2012