Comparing Efficiency of Lysis Buffer Solutions and Sample Preparation Methods for Liquid Chromatography–Mass Spectrometry Analysis of Human Cells and Plasma

The use of a proper sample processing methodology for maximum proteome coverage and high-quality quantitative data is an important choice to make before initiating a liquid chromatography–mass spectrometry (LC–MS)-based proteomics study. Popular sample processing workflows for proteomics involve in-solution proteome digestion and single-pot, solid-phase-enhanced sample preparation (SP3). We tested them on both HeLa cells and human plasma samples, using lysis buffers containing SDS, or guanidinium hydrochloride. We also studied the effect of using commercially available depletion mini spin columns before SP3, to increase proteome coverage in human plasma samples. Our results show that the SP3 protocol, using either buffer, achieves the highest number of quantified proteins in both the HeLa cells and plasma samples. Moreover, the use of depletion mini spin columns before SP3 results in a two-fold increase of quantified plasma proteins. With additional fractionation, we quantified nearly 1400 proteins, and examined lower-abundance proteins involved in neurodegenerative pathways and mitochondrial metabolism. Therefore, we recommend the use of the SP3 methodology for biological sample processing, including those after depletion of high-abundance plasma proteins.     

呋喃唑酮在凡纳滨对虾组织中代谢动力学研究

运用液相色谱-串联质谱法研究了呋喃唑酮药饵多次给药后在凡纳滨对虾体内的药物代谢动力学.研究结果表明：呋喃唑酮代谢物在血淋巴、肝胰脏、肌肉组织中的代谢过程均符合二室模型,其动力学方程分别为C血液=414.107×e^-0.092t＋124.451×e^-0.005t,C肝胰腺=1625.563×e^-0.019t＋125.700,C肌肉=120.434×e^-0.019t＋71.579×e^-0.001t.凡纳滨对虾血淋巴和肝胰腺中呋喃唑酮代谢物浓度在4h达到高峰,肌肉中药物浓度在2h达到最大值;最高峰时血淋巴、肝胰腺和肌肉中药物浓度平均为570.6μg·L^-1、1948.6μg·kg-1和210.0μg·kg-1.在血淋巴、肝胰腺和肌肉组织中呋喃唑酮代谢物浓度的吸收半衰期（t1/2α）分别为7.497h、36.206h和36.484h,消除半衰期（t1/2β）分别为132.525 h、1 000 479.217 h和505.637 h,总表观分布容积（V1/F）分别为55.775 L·kg^-1、17.16 L·kg^-1和161.574L·kg^-1.说明给药后呋喃唑酮代谢物在凡纳滨对虾体内消除缓慢,残留严重,尤其以肝胰脏残留最为明显.     

Non-Invasive Detection of Anti-Inflammatory Bioactivity and Key Chemical Indicators of the Commercial Lanqin Oral Solution by Near Infrared Spectroscopy

Quality control methods of current traditional Chinese medicine (TCM) preparation is time-consuming and difficult to assess in terms of overall efficiency of the drug. A non-destructive rapid near-infrared spectroscopy detection system for key chemical components and biological activity of Lanqin oral solution (LOS), one of the best-selling TCM formulations, was established for comprehensive quality evaluation. Near infrared spectral scanning was carried out on 101 batches of commercial LOS under the penetrated vial state and traditional state. RAW 264.7 cells were cultured to detect the anti-inflammatory ability of LOS, and the reference concentrations of epigoitrin, geniposide, and baicalin were obtained by HPLC. The quantitative models were optimized by three kinds of variable selection methods. The correlation coefficients of prediction value of the models were greater than 0.94. The system also passed the external validation. The performance of the non-invasive models was similar to the traditional models. The established non-destructive system can be applied to the rapid quality inspection of LOS to avoid unqualified drugs from entering the market and ensure drug effectiveness. The biological activity index of LOS was introduced and predicted by NIRs for the first time, which provides a new idea about the quality control of TCM formulations.     

Zur Anreicherung der stabilen Isotope des Schwefels durch Fest-Flüissig-Austausch unter Verwendung von Ionenaustauschern

An verschiedenen Systemen chemischer Verbindungen wurden Versuche zur Anreicherung des stabilen Isotopes ³⁴S unter Verwendung der Ionenaustauscher Wofatit L 150, SBW und SBK nach den Methoden der Frontalchromatographie und der Bandenverdrāngungschromatographie ausgeführt. Beim Isotopenaustauschsystem Hydrogensulfit (am Ionenaustauscher)/Schwefeldioxid (in wäβriger Lösung) wurden Verfahrensweise und Betriebsparameter hinsichtlich des Anreicherungsgrades optimiert. Mit Hilfe einer einfachen Methode gelang es, aus den Versuchsergebnissen Werle für den elementaren Trennfaktor und die Trennstufenhöhe zu berechnen.     

A new method for the determination of the 34S/32S ratio of water-soluble sulphur in soil

A new method for the determination of the ³⁴S/³²S ratio of water-extractable sulphate in soil is described. Soils are extracted directly with deionized water, which is evaporated down. The remaining residue is then rehydrated and transferred to tin cups containing an adsorbent and mixed with an oxygen donor (V₂O₅). Samples are then analysed using a continuous flow isotope ratio mass spectrometer. The new method requires around 10?g soil per determination, compared to much larger amounts (up to kilograms) of soil required for the previous methods. Sample preparation and subsequent analysis is quick and efficient. The method is demonstrated using a number of soils collected from around the world to provide a range of determined δ³⁴S values. The δ³⁴S values of water-extractable sulphur were broadly similar to those of the soil total sulphur.     

Determination of Iron in Calf Serum Using Bathophenanthroline and Thermal Lens Spectrometry

ABSTRACT

Thermal lens spectrometry has been used for the determination of iron in calf serum. The method is based on dissociation of Fe³⁺ from proteins, reduction of Fe³⁺ to Fe²⁺ and formation of a coloured complex between Fe²⁺ and bathophenanthroline. Contrary to the spectrophotometric method, it is shown that thermal lens spectrometry is less sensitive to scattering caused by the presence of small particles remaining in the test solution after the deproteinization step. The background signal is very small and the response is only slightly dependent on the amount of scattering particles. The method is reliable, sensitive and reproducible. The limit of detection for iron is 4 ppb and the relative standard deviation is around 2%. It is expected that the volume of serum sample necessary for an analysis can be reduced to less than 100 μl.     

Determination of Lead in Human Hair by High Resolution Continuum Source Graphite Furnace Atomic Absorption Spectrometry with Microwave Digestion and Solid Sampling

The content of lead in human hair was measured by high resolution continuum source graphite furnace atomic absorption spectrometry (HR-CS GFAAS) combined with microwave-assisted digestion (MAD) and direct solid sampling (DSS). Hair strands were washed, dried, and then cut into three parts (root, middle portion, and tip). For MAD-GFAAS assays, approximately 0.25 g of hair was completely digested using a mixture of concentrated nitric acid and hydrogen peroxide in a closed system. In the DSS-GFAAS assays, 0.1–0.2 mg of dried hair was directly introduced into a graphite furnace using a solid autosampler. The temperature programs were optimized and the effects of various added modifiers were compared. The results indicated that NH₄H₂PO₄ was the optimal modifier for analysis of Pb using GFAAS. Use of the optimal modifier and temperature program gave similar limits of detection for MAD-GFAAS and DSS-GFAAS of 1.16 ng/g and 0.82 ng/g, respectively. Both methods also produced satisfactory recoveries ranging from 98.69% to 103.14%. There was no significant difference observed between the Pb contents of hair strands determined by the MAD-GFAAS and DSS-GFAAS assays, which both indicated that the Pb levels increased along the hair strands. Comparison of the two methods revealed that DSS-GFAAS had several advantageous characteristics over MAD-GFAAS, including the need for much less sample material and having a less time-consuming procedure, lower sample blank absorbance, lower memory effect, and no risk of environmental pollution by digesting chemicals. The direct solid sampling technique can be employed as a good alternative to conventional wet digestion in AAS assays.     

Separation and Analysis of o.p'-DDD and its Lipophilic Metabolite,O.P'-DDE,in Tissue,Faeces and Plasma

Abstract

An analytical procedure based on electron capture gas chromatography for the determination of o,p′-DDD, a drug used for the treatment of Cushing′s syndrome, is presented. Detection of a metabolite, identified as o,p′-DDE, is also described.     

Transformation of macromonomers into ring‐opening polymerization macroinitiators: A detailed initiation efficiency study

In the present study, n‐butyl acrylate macromonomer (BAMM) (M_n = 1900 g mol^?1; PDI = 1.96) has been synthesized via a high‐temperature polymerization process. Subsequently, the olefinic termini of the BAMM have been transformed into a diol via a dihydroxylation process using KMnO₄ as an oxidizing agent. The OH‐terminated macroinitiator pBA(OH)₂ has subsequently been employed for the ring‐opening polymerization (ROP) of ε‐caprolactone via various catalytic systems, that is, organo‐(1,5,7‐triazabicyclo[4.4.0]dec‐5‐ene), metal (tin(II) 2‐ethylhexanoate), and enzymatic catalysis (Novozym® 435). The obtained pBA‐b‐pCL block copolymers and the initiation efficiency of the BAMM macroinitiator have been investigated via size exclusion chromatography (SEC), electrospray ionization–mass spectrometry (ESI‐MS) hyphenated with SEC and liquid chromatography at the critical conditions of both poly(ε‐caprolactone) (pCL) and pBA. The in vitro enzyme catalysis (eROP) approach proved to be the most efficient catalysis system due to minor transesterification side reactions during the polymerization process. However, side reactions such as transesterifications occur in each catalytic system and—while they cannot be suppressed—they can be minimized. The species generated during the eROP process include the desired block copolymer pBA‐b‐pCL as main species as well as pCL homopolymer and residual macroinitiator pBA(OH)₂. © 2012 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2012     

Single‐pulse pulsed laser polymerization–electron paramagnetic resonance investigations into the termination kinetics of n‐butyl acrylate macromonomers

The termination of model mid‐chain radicals (MCRs), which mimic radicals that occur in acrylate polymerization over a broad range of reaction conditions, has been studied by single‐pulse pulsed laser polymerization (SP‐PLP) in conjunction with electron paramagnetic resonance spectroscopy. The model radicals were generated by initiator‐fragment addition to acrylic macromonomers that were preformed prior to the kinetic experiments, thus enabling separation of termination from the propagation reaction, for these model radicals propagate sparingly, if at all, on the timescale of SP‐PLP experiments. Termination rate coefficients of the MCRs were determined in the temperature range of 0–60°C in acetonitrile and butyl propionate solution as well as in bulk macromonomer over the range of 0–100 °C. Termination rate coefficients slightly below those of the corresponding secondary radicals were deduced, demonstrating the relatively high termination activity of this species, even when undergoing MCR–MCR termination. For chain length of 10, a reduction by a factor of 6 is observed. Unusually high activation energies were found for the termination rate coefficient in these systems, with 35 kJ mol^?1 being determined for bulk macromonomer. © 2012 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2012