Dislocation driven chromium precipitation in Fe-9Cr binary alloy: a positron lifetime study

The influence of initial heat treatment on anomalous Cr precipitation within high temperature solubility region of the Fe–9Cr alloy has been investigated using positron lifetime studies. Air-quenched samples with pre-existing dislocations exhibited a distinct annealing stage in positron lifetime between 800 and 1100?K corresponding to Cr-precipitation. During this stage, Transmission Electron Microscopy showed fine precipitates of average size 4 nm, dispersed throughout the sample and from Energy-dispersive X-ray spectroscopy (EDS) analysis they are found to be Cr-enriched. The presence of dislocations is found to be responsible for Cr precipitation.     

高掺镁LiNbO3晶体折射率温度系数的表示式

推导了掺５ｍｏｌ％ＭｇＯ的ＬｉＮｂＯ３晶体折射率温度系数的表示式。利用这些表示式可以计算２９３～４２８Ｋ温度和０．５３９８μｍ～１．３４１４μｍ波长范围内的折射率温度系度，结果表明：计算值和实验值的最大相对偏差是１２％，用具有最大相对偏差的折射率温度系数的计算值，计算１．０７９５μｍ波长的非临界相位匹配温度，其值为３８２．４Ｋ，它与实验值仅差６Ｋ。因此，本文得到的表示式，对于采用这种晶体，设计在上     

Cr、Mn、Co、Ni掺杂对Al13Fe4相稳定性和力学性能影响的第一性原理研

采用基于密度泛函理论的第一性原理计算方法,系统地研究了不同掺杂浓度下过渡族元素Cr、Mn、Co、Ni在Al13Fe4相中的占位情况、结构稳定性和机械性能. 计算得到所有的Al13(Fe24-xMx) (M=Cr、Mn、Co、Ni;X=1,2,4)相都具有良好的热力学稳定性和机械稳定性. 相同掺杂浓度化合物的形成焓按如下顺序减小：Al78(Fe24-xCrx) > Al78(Fe24-xMnx) > Al13Fe4 > Al78(Fe24-xNix) > Al78(Fe24-xCox).形成焓的降低增加了Al13Fe4相成核驱动力,Co和Ni有利于促进Al-Fe合金中Al13Fe4相形核,细化Al13Fe4相. 过渡族元素可以改善金属间化合物的脆性,增强塑性变形能力. 并且随着掺杂浓度的增加,过渡族元素的加入对脆性的改善呈先增大后减小的趋势.     

孤子掺杂光纤放大的半径典模型与分析

建立了孤子掺杂光纤放大的半经典模型，给出了分布放大透明传输的泵浦条件，详细讨论了激发态吸收的影响．文中结果为Ｅｒ￣３＋掺杂光纤孤子放大器的设计提供了重要理论依据．     

Numerical Simulation of the Elastic Shrinkage Induced by Portevin-Le Chatelier Effect

A new one-dimensional phenomenological model based on the dynamic strain aging mechanism is developed. In order to account for the elastic shrinkage induced by the Portevin-Le Chatelier effect, elastic deformation is considered under the boundary conditions of the present model. The simulated results are found to be in good agreement with the experimental observations.     

H2S在Fe(100)面吸附的第一性原理研究

基于密度泛函理论第一性原理, 在广义梯度近似下, 研究了表面覆盖度为0.25 ML (monolayer)时硫化氢分子在Fe(100)面吸附的结构和电子性质, 并与单个硫原子吸附结果进行了对比. 结果表明: 硫化氢分子吸附在B2位吸附能最小为-1.23 eV, 最稳定, B1位吸附能最大为-0.01 eV, 最不稳定; 并对硫化氢分子在B1位和B2位吸附后的电子态密度进行了分析, 也表明了吸附在B2位稳定, 且吸附在B2位后硫化氢分子几何结构变化不大; 将硫化氢中硫原子吸附与单个硫原子吸附的电子性质进行了比较, 发现前者吸附作用非常微弱; 同时对吸附后的Fe(100)面进行了对比, 单个硫原子吸附的Fe(100)面电子态密度出现了一系列峰值且离散分布, 生成了硫化亚铁, 表明在硫化氢环境下, 主要是硫化氢析出的硫原子发生了吸附. 关键词： 第一性原理 Fe(100)表面 吸附能 硫化氢     

甲基紫掺杂聚乙烯醇薄膜材料红光多重全息存储

甲基紫掺杂聚乙烯醇薄膜材料在两束相干光照射下生成相位光栅.当改变一束相干光光程,通过监测相位光栅的一级衍射信号强度的变化,可以检测相位光栅的生长和擦除过程.在此实验基础上,讨论了甲基紫掺杂聚乙烯醇薄膜材料多重全息存储的原理与结果.     

Degradation of the Giant Magnetoresistance in Fe/Cr Multilayers Due to Ar-Ion Beam Mixing

The influence of 200 keV Ar-ion irradiation on the interlayer coupling in the Fe/Cr multilayer system exhibiting the giant magnetoresistance effect (GMR) is studied by conversion electron Mössbauer spectroscopy (CEMS), VSM hysteresis loops, magnetoresistivity and electric resistivity measurements and supplemented by the small-angle X-ray diffraction (SAXRD). The increase of Ar ion dose causes an increase of interface roughness, as evidenced by the increase of the Fe step-sites detected by CEMS as a result of which the GMR gradually decreases and vanishes at doses exceeding 1×10¹⁴ Ar/cm². A degradation of GMR with increasing Ar-ion dose is related to the formation of pinholes between Fe layers and the decrease of the antiferromagnetically coupled fraction.

     

Atomic Vibrational Dynamics of Thin Films Studied by Nuclear Resonant Inelastic X-Ray Scattering: Amorphous Tb1−x Fe x Alloys

Hyperfine Interactions - Nuclear resonant inelastic X-ray scattering (NRIXS) of 14.4125 keV synchrotron radiation was used to measure directly the partial vibrational density of states (VDOS),...