酚醛树脂中亚甲基对热降解的影响

将固化后的酚醛树脂在不同温度下进行热处理,对固化后的样品进行热重分析,对热处理后的试样进行傅立叶红外光谱分析.实验结果表明,酚醛树脂的热降解与亚甲基的取代位有关.酚醛树脂中的亚甲基分两个阶段进行热解降,350~450℃的温度区间主要是部分邻-邻(o-o′)位亚甲基和邻-对(o-p)位亚甲基的分解,400~620℃温度区间为对-对(p-p′)位亚甲基的分解,p-p′位亚甲基比o-o′位亚甲基的起始热分解温度高50℃左右.     

Correlation between Irradiation Treatment and Metabolite Changes in Bactrocera dorsalis (Diptera: Tephritidae) Larvae Using Solid-Phase Microextraction (SPME) Coupled with Gas Chromatography-Mass Spectrometry (GC-MS)

The metabolites produced by the larvae of Bactrocera dorsalis (Diptera: Tephritidae) exposed to different doses of irradiation were analyzed using solid phase microextraction (SPME) and gas chromatography-mass spectrometry (GC-MS), and a metabonomic analysis method of irradiated insects based on GC-MS was established. The analysis revealed 67 peaks, of which 23 peaks were identified. The metabolites produced by larvae treated with different irradiation doses were compared by multivariate statistical analysis, and eight differential metabolites were selected. Irradiation seriously influenced the fatty acid metabolic pathway in larvae. Using the R platform combined with the method of multivariate statistical analysis, changes to metabolite production under four irradiation doses given to B. dorsalis larvae were described. Differential metabolites of B. dorsalis larvae carried chemical signatures that indicated irradiation dose, and this method is expected to provide a reference for the detection of irradiated insects.     

Preparation of CdO nanoparticles by mechanochemical reaction

CdO nanoparticles of 43 nm in crystal size were successfully synthesized by the mechanochemical reaction (CdCl₂ + Na₂CO₃) with NaCl as a diluent and subsequent thermal treatment at 700°C for 2 h. The samples were characterized by differential thermal analysis (DTA), thermogravimetric analysis (TGA), X-ray diffraction (XRD) and transmission electron microscopy (TEM). Effect of calcination temperature on the crystal size of CdO nanoparticles was primarily investigated. The apparent activation energy of CdO nanoparticle formation during thermal treatment was calculated to be 12.2 kJ/mol.     

退火与极化温度对尼龙11薄膜驻极体内陷阱能级分布的影响

用热释电技术研究了尼龙11薄膜驻极体制备过程中热处理与极化温度对驻极体陷阱能级分布的影响.结果显示，淬火驻极体的热释电流谱上存在四个空间电荷退陷阱电流峰，而在退火处理后则显示两个退陷阱电流峰.采用多点法对热释电流谱进行理论拟合可以将各个退陷阱电流峰分离并得到它们的陷阱深度参数.这些参数进一步表明，淬火尼龙11薄膜驻极体内存在四个空间电荷的陷阱能级，极化温度升高对它们的分布情况影响不大；退火处理后，陷阱能级减少为两个，且随着极化温度的升高，较浅的陷阱能级有明显向较深陷阱能级接近的趋势. 关键词： 尼龙11 薄膜驻极体 热释电 热处理     

超声在废水处理中的应用

超声波处理废水是一项新兴的废水处理技术,具有操作简单方便、降解速度快等优点,在处理毒性高、难降解的有机废水应用表现出广阔的前景。     

Improvement of Biological Effects of Root-Filling Materials for Primary Teeth by Incorporating Sodium Iodide

Therapeutic iodoform (CHI₃) is commonly used as a root-filling material for primary teeth; however, the side effects of iodoform-containing materials, including early root resorption, have been reported. To overcome this problem, a water-soluble iodide (NaI)-incorporated root-filling material was developed. Calcium hydroxide, silicone oil, and NaI were incorporated in different weight proportions (30:30:X), and the resulting material was denoted DX (D5~D30), indicating the NaI content. As a control, iodoform instead of NaI was incorporated at a ratio of 30:30:30, and the material was denoted I30. The physicochemical (flow, film thickness, radiopacity, viscosity, water absorption, solubility, and ion releases) and biological (cytotoxicity, TRAP, ARS, and analysis of osteoclastic markers) properties were determined. The amount of iodine, sodium, and calcium ion releases and the pH were higher in D30 than I30, and the highest level of unknown extracted molecules was detected in I30. In the cell viability test, all groups except 100% D30 showed no cytotoxicity. In the 50% nontoxic extract, D30 showed decreased osteoclast formation compared with I30. In summary, NaI-incorporated materials showed adequate physicochemical properties and low osteoclast formation compared to their iodoform-counterpart. Thus, NaI-incorporated materials may be used as a substitute for iodoform-counterparts in root-filling materials after further (pre)clinical investigation.     

扫描环形光斑激光束优化研究

激光束的形状和能量分布限定了激光的应用范围,为满足不同的激光加工需要,必须对激光束进行变换。针对实验室用CO2激光器在热处理方面的应用,提出了激光扫描环形光斑光束优化法。基于温度场叠加原理建立了扫描环形光斑温度场的数学模型,模拟其温度场,可得到其温度分布特性;通过实验研究,分析了聚焦光斑与扫描环形光斑在激光淬火中对材料的热作用效果。结果表明,扫描环形光斑能改善激光热处理硬化层分布。理论和实验研究表明,激光扫描环形光斑技术可以实现激光热处理光束的优化,有一定的应用前景。     

Fouling Mitigation in a Heat Exchanger: High Cycles of Concentration for a Cooling-Tower Application

The purpose of the present study is to investigate the effect of a physical water treatment (PWT) technology on fouling mitigation in a simulated cooling tower operating at high cycles of concentration. Hard water was produced by evaporating pure water in a circulating open cooling tower, where dissolved calcium carbonate ions became concentrated with time. Heat transfer tests were conducted in a rectangular channel by varying the cycle of concentration (COC) from 5 to 10, and fouling resistances were measured over 270 hrs for each case with and without the PWT treatment. Another test was conducted with no blowdown case with and without the PWT treatment. The fouling resistance at 5 cycles with the PWT treatment was about 70% less than that in the case without the PWT treatment at the end of 270-hr tests. Even at 10 cycles, the PWT treatment reduced the fouling resistance by 60% from the value for the no treatment case. Thus, one can conclude that the PWT technology can help circulating cooling-tower water at relatively high COC for significant freshwater conservation, while keeping fouling resistances below industry standards.     

Cooling Characteristics During Bath Quenching of Test Probe Using Inverse Heat Transfer

It is of engineering importance to accurately predict the surface cooling characteristics in bath quenching of metals and alloys. In this investigation, the surface cooling characteristics in quenching of Wolfson probe are estimated with reasonable accuracy by solving an inverse heat conduction problem. Regularization method is used for smoothening the input temperature measurements at probe center, for superior inversion estimates. The reverse pool-boiling curve is captured on bath quenching characteristic, plotted as cooling velocity versus surface temperature. The prime advantage is the bypassing of convection coefficients, which are uncertain in pool boiling.     

Prediction of intracellular storage polymers using quantitative image analysis in enhanced biological phosphorus removal systems

The present study focuses on predicting the concentration of intracellular storage polymers in enhanced biological phosphorus removal (EBPR) systems. For that purpose, quantitative image analysis techniques were developed for determining the intracellular concentrations of PHA (PHB and PHV) with Nile blue and glycogen with aniline blue staining. Partial least squares (PLS) were used to predict the standard analytical values of these polymers by the proposed methodology. Identification of the aerobic and anaerobic stages proved to be crucial for improving the assessment of PHA, PHB and PHV intracellular concentrations. Current Nile blue based methodology can be seen as a feasible starting point for further enhancement. Glycogen detection based on the developed aniline blue staining methodology combined with the image analysis data proved to be a promising technique, toward the elimination of the need for analytical off-line measurements.