Estimation of parameters characterizing the adsorption of sodium,potassium, and rubidium cryptates at the mercury electrode/solution interface

The adsorption of complexes formed by sodium, potassium, and rubidium cations with macrobicyclic ligand (kryptofix 222 with C₁₈H₃₆N₂O₆ composition) is studied as a function of the ligand concentration on a stationary mercury drop in 0.1 M solutions of corresponding sulfates and chlorides by using the differential capacitance technique. Based on the model of two parallel capacitors supplemented by the Frumkin isotherm, the adsorption parameters of studied cryptates are estimated by using the regression analysis technique. Differential capacitance curves calculated with the parameters found are compared with experimental data. The comparison of the found adsorption parameters makes it possible to reveal the effects of the nature of included cations and specifically adsorbed supporting-electrolyte anions on the adsorption behavior of cryptates under study.__________Translated from Elektrokhimiya, Vol. 41, No. 4, 2005, pp. 475–481.Original Russian Text Copyright © 2005 by Stenina, Sviridova.     

氢化物发生石墨炉原子吸收光谱法直接测定高温镍基合金中的硒

在６ｍｏｌ／Ｌ盐酸介质和０．１％ＫＢＨ４条件下，不但能有效地发生硒的氢化物，而且５ｍｇ／ｍｌＮｉ和３ｍｇ／ｍｌＦｅ都不干扰硒的测定。利用涂钯石墨；管作为氢化物的原子化器，直接测定了高温镍基合金中的硒，特征质量为４０ｐｇ，相对标准偏差在６．１％以内，回收率在９７％－１１０％之间。     

Separation and sensitive determination of arsenic species (As/As) using the yeast-immobilized column and hydride generation in ICP–AES

Inorganic arsenic was separated using the yeast-immobilized column. Saccharomyces cerevisiae was covalently bonded unto the controlled pore glass, which showed selective preconcentration of As⁵⁺ over As³⁺. The effluent was directly connected to hydride generation (HG) to increase sensitivity. The optimum pH condition for the retainment of arsenic at the column was 7. As⁵⁺ and As³⁺ were completely separated in a few minutes with the flow rate of 1.5 ml min⁻¹. Three molars of nitric acid was adequate both for the elution of As⁵⁺ and hydride generation. The accuracy of the technique was tested with NIST SRMs. Quantitative analysis of arsenic species for herbicide, pesticide, and cigarette were performed, and the results showed good agreements with the suggested values. Yeast-immobilized column-HG-ICP showed a promising future for the arsenic speciation study.     

Synthesis and Structure of the New Ammonium Indium Phosphate (NH4)In(OH)PO4

A new ammonium indium phosphate (NH₄)In(OH)PO₄ was prepared by hydrothermal reaction in the In₂O₃-NH₄H₂PO₄-NH₃/OH system (T=200°C, autogenous pressure, 7 days). The formula (NH₄)In(OH)PO₄ was determined on the basis of chemical and thermal analysis (TG/DSC), X-ray powder diffraction and IR-spectroscopy. (NH₄)In(OH)PO₄ crystallizes in the tetragonal system with space group P4₃2₁2 (No. 96); a=9.4232(1) Å, c=11.1766(1) Å, V=992.45(2) ų; Z=8. The crystal structure was refined by the Rietveld method (R_w=6.35%, R_p=5.10%). The second-harmonic generation study confirmed that structure of (NH₄)In(OH)PO₄ does not have a center of symmetry. The cis-InO₄(OH)₂ octahedra form helical chains, parallel to the c-axis. The In-O-In bonds are nearly equidistant. The chains are interconnected by phosphate tetrahedra and create tunnels containing the NH₄⁺ ions along the c-axis. (NH₄)In(OH)PO₄ is isostructural with RbIn(OH)PO₄.     

Advances in two-dimensional GC with glass capillary columns

A versatile two-dimensional gas chromatograph is described, consisting of 2 separate ovens, one intermediate trap, an auxiliary inlet, and the necessary hardware to effect off-line switching according to the principle of Deans. The unit has been designed for use with high resolution glass capillary columns. The performance of individual instrumental components was critically evaluated. Results showed that low dead volume glass to metal connections were required in the manifold and detector lines to minimize extra-column effects. The mass of the intermediate trap must be low to allow rapid heating. Operational parameters are discussed and examples of some applications are shown.     

Multicommutation as an environmentally friendly analytical tool in the hydride generation atomic fluorescence determination of tellurium in milk

The aim of this study is to show the advantages of the emerging multicommutation methodology based on the use of solenoid valves for Te determination in milk by hydride generation atomic fluorescence spectrometry (HG-AFS). The delivery of a series of alternating sequential insertions of small volumes of samples and reagents gives rise to new hydrodynamic processes and exciting analytical potentials by controlling the time of flow through the on/off-switched solenoid valves. This drastically reduces the reagent consumption by a factor of 4 and the generation of effluents (590 mL h^–1 instead of 750 mL h^–1 generated by the continuous-mode measurement) and also provides an improvement in the laboratory productivity by an increase of the sample throughput (85 h^–1 compared to 20 h^–1 found in the continuous mode). So, multicommutation is an environmentally and economically sustainable alternative to the methodology based on continuous measurements. The multicommutation-based method developed was applied to tellurium determination in commercially available milk samples; a calibration range of 0.0–0.5 ng mL^–1 and a detection limit of 0.20 ng L^–1 with average relative standard deviation of 2.1% were found. Comparable results were obtained for a series of samples using both continuous and multicommutation HG-AFS modes.     

Application of heat conduction calorimetry to high explosives

This paper describes some thermal analysis experiments conducted on high explosive samples. These employ differential scanning calorimetry to monitor thermal effects at elevated temperatures (around 200 °C) and heat conduction calorimetry to record thermal effects at much lower temperatures (below 100 °C).The work shows that, due to the generally high thermal stability of many high explosive compositions, heat generation rates are very low, if detectable at all, at normal storage temperatures, even when using a very sensitive instrument. The sensitivity and reproducibility of this technique has been investigated in detail by Wilker et al. [S. Wilker, U. Ticmanis, G. Pantel, Detailed investigation of sensitivity and reproducibility of heat flow calorimetry, in: Proceedings of the 11th Symposium on Chemical Problems Connected with the Stability of Explosives, Sweden, 1998] and shown to be capable of recording heat generation rates of less than a microwatt. This allows continuous measurement of decomposition processes in nitrate ester based propellants at temperatures as low as 40 °C. However, the measurement of very low levels of heat generation is difficult, time consuming and therefore expensive. If the assumption is made that the life limiting process is invariably the slow decomposition of the energetic component, this will frequently lead to very long service lifetime predictions.A number of possible complications are identified. Firstly, due to its low detection threshold, a heat conduction calorimeter may detect other reactions which will not lead to failure, but which may still dominate the heat flow signal. Secondly, the true failure process may generate little energy and be overlooked. In view of these considerations, at present it seems unwise to rely on heat conduction microcalorimetry as the only tool for the assessment of the life of high explosive energetic systems.Based on examples of life terminating processes in high explosives during storage and use, it is clear that decomposition of the energetic material is not invariably the cause of system failure. It is also by no means the only reaction that may take place in, and be observed by, a heat conduction calorimeter.     

Second-order nonlinear optical properties of side-chain liquid crystalline polymers studied by second harmonic generation from thin films

The two independent elements of the second-order nonlinear optical susceptibility tensor of a range of contact poled, donor–acceptor substitued side-chain polymers are reported. The susceptibilities were measured by second harmonic generation from thin films, typically less than 0.5 μm thick, at a fundamental wavelength of 1064 nm. The largest value was χ = 2.64 pm/V which is three times greater than the χ value of KDP and was measured in a nitrobenzylidene side chain, polyhydroxystyrene polymer with an eleven unit alkyl chain spacer attaching the side group to the backbone. Typical susceptibility values obtained were χ～0.3 pm/V and X⁽²⁾₃₃～1 pm/V. The coherence lengths of the materials, which lay in the range 4–12 μm, were measured at 1064 nm by the maker fringe technique using thick, wedge-shaped samples.     

氢化物发生-荧光光度法测定微量硒

本文提出了一个氢化物发生-荧光光度法测定微量硒的新方法。用硼氢化钾溶液将硒(Ⅵ)还原成H_2Se挥发出来,用8-羟基喹啉-5-磺酸钯溶液吸收,生成难溶的PdSe,释放出的8-羟基喳啉-5-磺酸与Al~(3+)生成发荧光的络合物,其荧光强度与硒(Ⅳ)量成正比。方法的检出限为0.26ng/ml。     

溴碘化银薄片乳剂颗粒中碘离子分布对潜影分散的影响

碘溴化银乳剂薄片颗粒的潜影分散与碘离子在颗粒中的分布有关。本文用交叉光楔曝光技术测定了由次潜影造成的潜影分散,并根据所测出的潜影分散度和乳剂的表面感光度,对内、表敏的分布作了分析。结果表明,碘离子分布在颗粒边缘的乳剂,其表面潜影分散度要比碘离子均匀分布的颗粒更甚,后者且表现出内、表敏度竞争的现象。